Electrochemical detection of ornidazole in commercial milk and water samples using an electrode based on green synthesis of silver nanoparticles using cellulose separated from Phoenix dactylifera seed.

The widespread use of antibiotics has contributed to the control of disease and the nutritional well-being of livestock. Antibiotics reach the environment via excretions (urine and feces) from human and domestic animals, through non proper disposal or handling of unused drugs. The present study describes a green method for the synthesis of silver nanoparticle (AgNPs) using cellulose extracted from Phoenix dactylifera seed powder via mechanical stirrer method for the electroanalytical determination of ornidazole (ODZ) in milk and water samples. The cellulose extract is used as the reducing and stabilizer agent for the synthesis of AgNPs. The obtained AgNPs were characterized by UV-Vis, SEM and EDX, presenting a spherical shape and an average size of 48.6 nm. The electrochemical sensor (AgNPs/CPE) was fabricated by dipping a carbon paste electrode (CPE) in the AgNPs colloidal solution. The sensor shows acceptable linearity with ODZ concentration in the linear range from 1.0 × 10-5 to 1.0 × 10-3 M with a limit of detection (LOD =3S/P) and quantification (LOQ =10S/P) of 7.58 × 10-7 M and 2.08 × 10-6 M respectively.

Phytotoxic effect of the insecticide imidacloprid in Phaseolus vulgaris L. plant and evaluation of its bioaccumulation and translocation by electrochemical methods.

The objective of this work is to study the toxicological effect of the imidacloprid (IMD) on common bean plants (Phaseolus vulgaris L) when used at high doses and its quantification by electrochemical method. Common bean plants were exposed to increasing concentrations of IMD and the different plant tissues were subjected to various analyses. The IMD detection in different tissues of the bean plant was performed after extraction on the metallic silver electrode using square wave voltammetry. The analytical and calibration parameters (Slope, correlation coefficient, linear range, detection limit and relative standard deviation) were calculated for the different plant tissues. The effect of different doses (5.0 × 10-3 to 5.0 × 10-2 mol L-1) of IMD was evaluated on germination, seedling (vigour, growth) and photosynthetic pigments in the bean plant. The results indicate that germination rate and seed vigour index reduced significantly (p ≤ 0.05) only in the applied concentrations above the recommended dose. A similar effect of IMD was observed on seedling development in term of roots length, plant length, number of leaves and number of nods. Concerning pigments content, chlorophyll a, b and total chlorophyll maximally decreased by 95.26%, 80.44% and 82.15% respectively at high applied dose. The bioaccumulation and translocation behaviour of IMD in bean plant was investigated, revealing that the IMD can be bioaccumulated in roots and can easily be translocated into stems and leaves.

Extraction and determination of flubendiamide insecticide in food samples: A review.

Flubendiamide (FBD) is the first commercially available phthalic acid diamide that targets ryanodine receptors (RyRs) in insects, which play a major role in lepidoptera control. However, excessive use of FBD can influence the quality of treated products leading to toxic effects on human health. The availability of rapid and convenient methods for evaluating FBD amount in the environment is necessary. Therefore, analytical methods were developed for the determination of residues of FBD and its metabolite desiodo in different food matrices like tomato, cabbage, pigeon pea, apple, chilli and rice. The current review carries forward methods for FBD residues analysis in foods by using several chromatographic techniques including sample preparation steps. The comparison between the different methods employed for quantitative and qualitative analysis of food quality and safety is also discussed. Liquid chromatography (LC) is the predominant analytical method for assessing the quality of foods treated with FBD. Studies related to LC coupled multichannel detector (Ultraviolet (UV), Mass spectrometry (MS)) are also applied to detect pesticide residues. Extraction and clean up steps are essential to obtain reliable results. Moreover, this review reports the allowed limits of residues for the safety of consuming products treated with FBD.

Recent progress in controlling the synthesis and assembly of nanostructures: Application for electrochemical determination of p-nitroaniline in water.

The development of nanoparticle research has grown considerably in recent years. One of the reasons for the considerable current interest in nanoparticles is because such materials frequently display unusual physical (structural, electronic, magnetic, and optical) and chemical (catalytic) properties. The development of nanomaterials is of interest to the scientific community and industrial companies. Different methods (physical, chemical, and biological) allow their manufacture. In particular, a major effort has been devoted to the development and improvement of synthesis methods in order to obtain nano-objects of controlled size and shape, a necessary pre-requisite to their organization, and to the study of their intrinsic and collective properties. Reviews play an important role in keeping interested parties up to date on the current state of the research in any academic field. This review aims to focus on the development of nanoparticles and stabilization with adsorbed/covalently attached ligands in solution phase since these factors are deeply related to the origins of the particles' stability, the media to which they are exposed, and the involved applications. This study also examines the factors that influence the synthesis of nanoparticles. It aims to provide an overview of existing electrochemical sensors, particularly those that operate with nanomaterial-based electrode modifications for p-nitroaniline (PNA) determination and to propose guidelines for related research and development activities. Emphasis was placed on the procedure for the analysis of PNA in water samples using nanosilver-based electrodes.