RESUMEN
Cathodic electrochemical intercalation/exfoliation of transition metal dichalcogenides (TMDs) with bulky tetraalkylammonium-based cations is gaining popularity as it avoids the semiconducting (2H) to metallic (1T) phase transformation in TMDs like molybdenum disulfide (MoS2) and, generally, produces sheets with a larger aspect ratio - important for achieving conformal sheet-to-sheet contact in optoelectronic devices. Large single crystals are typically used as the precursor, but these are expensive, often inaccessible, and result in limited quantities of material. In this paper, a 3D-printable electrochemical cell capable of intercalating gram-scale quantities of commercially available TMD powders is presented. By incorporating a reference electrode in the cell and physically restraining the powder with a spring-loaded mechanism, the system can probe the intercalation electrochemistry, for example, determining the onset of intercalation to be near -2.5 V versus the ferrocene redox couple. While the extent of intercalation depends on precursor quantity and reaction time, a high yield of exfoliated product can be obtained exhibiting average aspect ratios as high as 49 ± 44 similar to values obtained by crystal intercalation. The intercalation and exfoliation of a wide variety of pelletized commercial powders including molybdenum diselenide (MoSe2), tungsten diselenide (WSe2), tungsten disulfide (WS2), and graphitic carbon nitride (gCN) are also demonstrated.
RESUMEN
In this work, native GaOx is positioned between bulk gallium and degenerately doped p-type silicon (p+-Si) to form Ga/GaOx/SiOx/p+-Si junctions. These junctions show memristive behavior, exhibiting large current-voltage hysteresis. When cycled between -2.5 and 2.5 V, an abrupt insulator-metal transition is observed that is reversible when the polarity is reversed. The ON/OFF ratio between the high and low resistive states in these junctions can reach values on the order of 108 and retain the ON and OFF resistive states for up to 105 s with an endurance exceeding 100 cycles. The presence of a nanoscale layer of gallium oxide is critical to achieving reversible resistive switching by formation and dissolution of the gallium filament across the switching layer.
RESUMEN
All-polymer, write-once-read-many times resistive memory devices have been fabricated on flexible substrates using a single polymer, poly(3,4-ethylenedioxythiophene):polystyrene sulfonate (PEDOT:PSS). Spin-cast or inkjet-printed films of solvent-modified PEDOT:PSS are used as electrodes, while the unmodified or as-is PEDOT:PSS is used as the semiconducting active layer. The all-polymer devices exhibit an irreversible but stable transition from a low resistance state (ON) to a high resistance state (OFF) at low voltages caused by an electric-field-induced morphological rearrangement of PEDOT and PSS at the electrode interface. However, in the metal-PEDOT:PSS-metal devices, we have shown a metal filament formation switching the device from an initial high resistance state (OFF) to the low resistance state (ON). The all-PEDOT:PSS memory device has low write voltages (<3 V), high ON/OFF ratio (>10(3)), good retention characteristics (>10,000 s), and stability in ambient storage (>3 months).