Effect of different surface treatment protocols on the bond strength between lithium disilicate and resin cements.

Because the use of hydrofluoric acid (HF) poses health risks if handled improperly, many clinicians prefer to have the ceramic restorations pre-etched in dental laboratories. However, during the try-in procedure, the pre-etched glass-ceramic restorations may be contaminated with saliva resulting in reduced bond strength. This in-vitro study aimed to investigate the effect of different surface treatments on the bond strength of lithium disilicate (LD) glass-ceramic restorations (IPS e.max Press, Ivoclar Vivadent) to two resin cements. One-hundred eighty blocks (4X4X3mm) of LD glass-ceramic were divided into twelve groups (n = 15), of which six received Variolink Esthetic DC (VE) cement and six received RelyX Ultimate (RU) cement, following the surface treatments: G1) Control: Hydrofluoric Acid + Silane (HF + Sil); G2) Hydrofluoric Acid + Saliva + Silane (HF + S + Sil); G3) Hydrofluoric Acid + Saliva + Ivoclean + Silane (HF + S + IC + Sil); G4) Hydrofluoric Acid + Saliva + Phosphoric Acid + Silane (HF + S + P + Sil); G5) Hydrofluoric Acid + Saliva + Monobond Etch & Prime (HF + S + EP); G6) Monobond Etch & Prime (EP). Following treatment, a resin-cement cylinder (2.3 mm diameter) was built on the glass-ceramic surface, photocured (20 s), stored in distilled water (37 °C, 24 h) and submitted to the shear bond strength test. Bond strength data (MPa) were subjected to two-way ANOVA and Tukey (α = 0.01). Cement type and surface treatment had a significant effect on the bond strength (p < 0.001) (Table 4). Single-step Monobond Etch & Prime (EP) significantly improved the bond strength of resin-cements to glass-ceramic with and without saliva contamination.

Retention of tooth-colored restorations in non-carious cervical lesions--a systematic review.

OBJECTIVES: The aim of this review was to assess the effect of different adhesive systems and tooth preparation on the retention of tooth-colored restorative materials placed in non-carious cervical lesions (NCCLs). METHODS: Randomized clinical trials with a minimum of 3 years of follow-up that evaluated the effectiveness of tooth-colored materials, adhesive systems, and preparation techniques for the restoration of NCCLs were selected. The Cochrane Central Register of Controlled Trials (CENTRAL), EMBASE (OVID), the Latin American and Caribbean Health Sciences Literature database (LILACS), and Medline (OVID) electronic databases were searched from 1990 to 2013. RESULTS: Twenty-seven randomized clinical trials were included and reviewed. Meta-analysis was used to determine the relative risk of loss of tooth-colored NCCL restorations between different categories of adhesive systems. The effect of tooth preparation could not be similarly analyzed. CONCLUSION: The current best evidence indicates that a glass ionomer cement has a significantly lower risk of loss of a NCCL restoration compared to either a three-step etch-and-rinse or a two-step etch-and-rinse adhesive system; a three-step etch-and-rinse adhesive system has a significantly lower risk of loss of a NCCL restoration compared to a two-step etch-and-rinse adhesive system. No significant difference could be observed in the risk of loss of a tooth-colored NCCL restoration between a three-step etch-and-rinse adhesive system and either a two-step self-etch or a one-step self-etch adhesive system.

The Performance of ICDAS-II Using Low-Powered Magnification with Light-Emitting Diode Headlight and Alternating Current Impedance Spectroscopy Device for Detection of Occlusal Caries on Primary Molars.

Early detection of occlusal caries in children is challenging for the dentists, because of the morphology of pit and fissures. The aim of this study was to compare in vitro the diagnostic performance of low-powered magnification with light-emitting diode headlight (LPMLED) using ICDAS-II criteria and AC Impedance Spectroscopy (ACIS) device, on occlusal surfaces of primary molars. The occlusal surfaces of 18 extracted primary molars were examined blindly by two examiners. The teeth were sectioned and examined under light microscopy using Downer's histological criteria as gold standard. Good to excellent inter- and intraexaminer reproducibility, higher sensitivity, specificity, and AUC values were achieved by LPMLED at D1 threshold. Also the relationship between histology and LPMLED was statistically significant. In conclusion visual aids have the potential to improve the performance of early caries detection and clinical diagnostics in children. Despite its potential, ACIS device should be considered as an adjunct method in detecting caries on primary teeth.

Use of Stafne's mandibular defect in improving retention of mandibular complete dentures.

In 1942, Stafne was the first to report radiographic findings of "static bone cavities" situated near the angle of the mandible. The typical radiographic appearance of Stafne's mandibular defect is a radiolucency below the inferior alveolar canal, between the mandibular premolars and the angle of the mandible. Stafne's mandibular defect ranges from 10 mm to 30 mm in diameter. The size has been shown to be remarkably constant in diagnosed lesions followed over time. In the majority of cases, the lesion is symptomless. Routine surgical exploration is not indicated. It is suggested that the lesion is a radiographic rather than a pathological entity; therefore, consideration was given to making use of these anatomical retentive areas in a prosthetic manner. In this article, a literature review of Stafne's mandibular defect is presented and attempts to improve the retention and stability of the lower complete dentures by using this anatomical entity are described.

Using tissue conditioner material in neutral zone technique.

The looseand unstable lower complete denture is a common problem faced by denture patients. One method used to solve this problem is the neutral zone technique. The neutral zone is the area where the displacing forces of the lips, cheeks and tongue are in balance. In the clinical report presented here, a severely resorbed lower alveolar ridge was treated by determining the neutral zone with tissue conditioner material (Visco-gel, Dentsply Ltd., Weybridge, U.K.). The neutral zone approach with Visco-gel is a more practical and economically feasible treatment for patients having atrophic mandibular ridge.