In vitro degradation and in vivo biocompatibility study of a new linear poly(urethane urea).

Segmented poly(urethane urea)s (PUUs) with hard segments derived only from methyl 2,6-diisocyantohexanoate (LDI) without the use of a chain extender have previously been described. These materials, which contain hard segments with multiple urea linkages, show exceptionally high strain capability (1600-4700%). In the study reported here, the rate and effect of hydrolysis of these materials were determined for gamma-sterilized and nonsterilized samples. Materials investigated contained PCL, PTMC, P(TMC-co-CL), P(CL-co-DLLA), or P(TMC-co-DLLA) as soft segments and, as well as their mechanical properties, changes in mass, inherent viscosity (I.V.), and thermal properties were studied over 20 weeks. Results showed that the degradation rate was dependant on the soft segment structure, with a higher rate of degradation for the polyester-dominating PUUs exhibiting a substantial loss in I.V. A tendency of reduction of tensile strength and strain hardening was seen for all samples. Also, loss in elongation at break was detected, for PUU-P(CL-DLLA) it went from 1600% to 830% in 10 weeks. Gamma radiation caused an initial loss in I.V. and induced more rapid hydrolysis compared with nonsterilized samples, except for PUU-PTMC. A cytotoxicity test using human fibroblasts demonstrated that the material supports cell viability. In addition, an in vivo biocompatibility study showed a typical foreign body reaction after 1 and 6 weeks.

Effects of hydrolysis on a new biodegradable co-polymer.

The aim of this study was to examine the feasibility of using a new low-modulus biodegradable thermoplastic elastomer for in vivo application as a stent cover. The new polymer, a thermoplastic elastomer, consists of a three-armed co-polymer of poly(lactide)acid (PLLA), poly(trimethylene carbonate) (PTMC) and poly(caprolactone) (PCL). A degradation study was performed in a buffer solution at 37 degrees C for 4 and 6 weeks. The effect of degradation on mechanical properties was studied by stress-strain measurements and explained by using modulated DSC, GPC and mass measurements. A tapered block of PLLA and trimethylene carbonate connecting the crystalline outer part and the inner elastic part was highly susceptible to hydrolysis and caused rapid degradation and subsequent loss of mechanical properties. Random chain scission and homogenous hydrolysis resulted in a loss in mass and molecular weight. After 6 weeks of in vitro hydrolysis the molecular weight had decreased 54% and the elongation-at-break dropped from more than 300% to 90%. A medium free cell seeding study showed that endothelial cells adhered well to the polymeric material. An indicative animal study with the polymer acting as a stent cover showed very low levels of inflammation; however, pronounced neointima thickening was observed which was probably due to the premature failure of the material.