RESUMEN
Iron-based 1111-type superconductors display high critical temperatures and relatively high critical current densities Jc. The typical approach to increasing Jc is to introduce defects to control dissipative vortex motion. However, when optimized, this approach is theoretically predicted to be limited to achieving a maximum Jc of only â¼30% of the depairing current density Jd, which depends on the coherence length and the penetration depth. Here we dramatically boost Jc in SmFeAsO1-xHx films using a thermodynamic approach aimed at increasing Jd and incorporating vortex pinning centres. Specifically, we reduce the penetration depth, coherence length and critical field anisotropy by increasing the carrier density through high electron doping using H substitution. Remarkably, the quadrupled Jd reaches 415 MA cm-2, a value comparable to cuprates. Finally, by introducing defects using proton irradiation, we obtain high Jc values in fields up to 25 T. We apply this method to other iron-based superconductors and achieve a similar enhancement of current densities.
RESUMEN
In this Letter, a novel mechanism to enhance the magnetoelectric (ME) coupling between electric polarization and magnetism using the dynamic Jahn-Teller (JT) effect is demonstrated. Electric polarization of over 100 µC/m^{2} is induced by the magnetic field owing to the second-order ME effect in the noncentrosymmetric transition metal complex [Mn^{III}(taa)]. This appearance of electric polarization does not require magnetic order in contrast to the linear ME effect in ME multiferroic materials. The value of the electric polarization is 1 order larger than that induced by the second-order ME effect, which originates from the p-d hybridization. Our calculation, taking into account the single-ion-type magnetic anisotropy originating from the spin-orbit interaction and ferrodistortive intermolecular interaction, verifies that the alignment of the JT distortion by the magnetic field results in the large electric polarization observed. Thus, our results provide a new method to gain strong ME coupling by tuning the atomic displacement using a magnetic field.
RESUMEN
For the innovation of spintronic technologies, Dirac materials, in which low-energy excitation is described as relativistic Dirac fermions, are one of the most promising systems because of the fascinating magnetotransport associated with extremely high mobility. To incorporate Dirac fermions into spintronic applications, their quantum transport phenomena are desired to be manipulated to a large extent by magnetic order in a solid. We report a bulk half-integer quantum Hall effect in a layered antiferromagnet EuMnBi2, in which field-controllable Eu magnetic order significantly suppresses the interlayer coupling between the Bi layers with Dirac fermions. In addition to the high mobility of more than 10,000 cm(2)/V s, Landau level splittings presumably due to the lifting of spin and valley degeneracy are noticeable even in a bulk magnet. These results will pave a route to the engineering of magnetically functionalized Dirac materials.
Asunto(s)
Modelos Teóricos , FísicaRESUMEN
Recently, we succeeded in detwinning REBa2Cu3O7 (RE123, RE = rare-earth elements)-coated conductors by annealing under an external uniaxial strain. Using the untwinned RE123 tapes, the uniaxial-strain dependencies of the critical temperature Tc along the a and b crystal axes were investigated over a wide strain region from compression to tension. We found that the strain dependencies of Tc for the a and b axes obey a power law but exhibit opposite slopes. In particular, the maximum value of Tc is obtained when the CuO2 plane becomes a square, and its lattice constant is close to 0.385 nm. It is suggested that a tetragonal structure with a ≈ 0.385 nm is the optimum condition for a high critical temperature in high-Tc cuprates.
RESUMEN
High-performance Sr0.6K0.4Fe2As2 (Sr-122) tapes have been successfully fabricated using hot pressing (HP) process. The effect of HP temperatures (850-925°C) on the c-axis texture, resistivity, Vickers micro-hardness, microstructure and critical current properties has been systematically studied. Taking advantage of high degree of c-axis texture, well grain connectivity and large concentration of strong-pinning defects, we are able to obtain an excellent Jc of 1.2 × 10(5)â A/cm(2) at 4.2â K and 10â T for Sr-122 tapes. More importantly, the field dependence of Jc turns out to be very weak, such that in 14â T the Jc still remains ~ 1.0 × 10(5)â A/cm(2). These Jc values are the highest ever reported so far for iron-pnictide wires and tapes, achieving the level desired for practical applications. Our results clearly strengthen the position of iron-pnictide conductors as a competitor to the conventional and MgB2 superconductors for high field applications.
RESUMEN
Improving transport current has been the primary topic for practical application of superconducting wires and tapes. However, the porous nature of powder-in-tube (PIT) processed iron-based tapes is one of the important reasons for low critical current density (Jc) values. In this work, the superconducting core density of ex-situ Sr0.6K0.4Fe2As2 + Sn tapes, prepared from optimized precursors, was significantly improved by employing a simple hot pressing as an alternative route for final sintering. The resulting samples exhibited optimal critical temperature (Tc), sharp resistive transition, small resistivity and high Vickers hardness (Hv) value. Consequently, the transport Jc reached excellent values of 5.1 × 10(4)â A/cm(2) in 10â T and 4.3 × 10(4)â A/cm(2) in 14â T at 4.2â K, respectively. Our tapes also exhibited high upper critical field Hc2 and almost field-independent Jc. These results clearly demonstrate that PIT pnictide wire conductors are very promising for high-field magnet applications.
RESUMEN
From the application point of view, large critical current densities J(c) (H) for superconducting wires are required, preferably for magnetic fields higher than 5 T. Here we show that strong c-axis textured Sr(1-x)K(x)Fe(2)As(2) tapes with nearly isotropic transport J(c) were fabricated by an ex-situ powder-in-tube (PIT) process. At 4.2 K, the J(c) values show extremely weak magnetic field dependence and reach high values of 1.7 × 10(4) A/cm(2) at 10 T and 1.4 × 10(4) A/cm(2) at 14 T, respectively, these values are by far the highest ever reported for iron based wires and approach the J(c) level desired for practical applications. Transmission electron microscopy investigations revealed that amorphous oxide layers at grain boundaries were significantly reduced by Sn addition which resulted in greatly improved intergranular connectivity. Our results demonstrated the strong potential of using iron based superconductors for high field applications.
RESUMEN
Superconducting materials have contributed significantly to the development of modern materials science and engineering. Specific technological solutions for their synthesis and processing helped in understanding the principles and approaches to the design, fabrication and application of many other materials. In this review, we explore the bidirectional relationship between the general and particular synthesis concepts. The analysis is mostly based on our studies where some unconventional technologies were applied to different superconductors and some other materials. These technologies include spray-frozen freeze-drying, fast pyrolysis, field-assisted sintering (or spark plasma sintering), nanoblasting, processing in high magnetic fields, methods of control of supersaturation and migration during film growth, and mechanical treatments of composite wires. The analysis provides future research directions and some key elements to define the concept of 'beautiful' technology in materials science. It also reconfirms the key position and importance of superconductors in the development of new materials and unconventional synthesis approaches.
RESUMEN
Magnetic resonance imaging with high static magnetic fields (SMFs) has become widely used for medical imaging purposes because SMFs cause fewer genotoxic side effects than ionizing radiation (IR). However, the effect of exposure to high SMFs on global transcription is little understood. We demonstrate that genes involved in motor activity, actin binding, cell adhesion, and cuticles are transiently and specifically induced following exposure to 3 or 5 T SMF in the experimental model metazoan Caenorhabditis elegans. In addition, transient induction of hsp12 family genes was observed after SMF exposure. The small-heat shock protein gene hsp16 was also induced but to a much lesser extent, and the LacZ-stained population of hsp-16.1::lacZ transgenic worms did not significantly increase after exposure to SMFs with or without a second stressor, mild heat shock. Several genes encoding apoptotic cell-death activators and secreted surface proteins were upregulated after IR, but were not induced by SMFs. Real-time quantitative RT-PCR analyses for 12 of these genes confirmed these expression differences between worms exposed to SMFs and IR. In contrast to IR, exposure to high SMFs did not induce DNA double-strand breaks or germline cell apoptosis during meiosis. These results suggest that the response of C. elegans to high SMFs is unique and capable of adjustment during long exposure, and that this treatment may be less hazardous than other therapeutic tools.