Increased dissolution rate and bioavailability through comicronization with microcrystalline cellulose.

Micronization is a commonly used enabling technology to improve the bioavailability of compounds where absorption is dissolution rate limited. However, decreasing particle size often results in increased Van der Waals' interactions and electrostatic attraction between particles. This causes agglomeration of particles, thereby compromising the increase in surface area gained by micronization. Comicronization with excipients has been reported to offer significant advantages over neat micronization. The present work describes the comicronization of a model compound CI-1040 at a high drug load that shows an increase in the dissolution rate and bioavailability in male Wistar rats. Physicochemical characterization of the comicronized and neat micronized material is presented to help explain the in-vitro and in-vivo data.

Dissolution behavior of a poorly water soluble compound in the presence of Tween 80.

PURPOSE: To investigate the mechanism by which Tween 80 impedes the dissolution of CI-1041, a poorly water-soluble compound in its free form. METHODS: Bulk powder and intrinsic dissolution (ID) of CI-1041 in 0.1 N HCl with various concentrations of Tween 80 were conducted. The residual solids of the dissolution experiments were characterized. The surface tension and the critical micellar concentration (CMC) of Tween 80 in 0.1 N HCl were determined. RESULTS: CI-1041 underwent solvent mediated conversion to its chloride salt (CS) in 0.1 N HCl. The coating of the CS on the surface of the CI-1041 pellet decreased the ID rate 20 to 30 fold. When the Tween 80 concentration in 0.1 N HCl was below 0.5 mg/ml, the CS formation rate increased with increasing Tween 80 concentration. Above 0.5 mg/ml of Tween 80 in 0.1 N HCl, opposite trend was observed. The change in trend at 0.5 mg/ml Tween 80 coincided approximately with the CMC of Tween 80 in 0.1 N HCl. CONCLUSIONS: The authors propose the following mechanism mediated by Tween 80. Below CMC, reduced surface tension caused by addition of Tween 80 increases the rate of nucleation of insoluble CS, causing the formation of CS on the surface of the CI-1041 free form. This, in turn, decreases the dissolution rate by decreasing the release of compound into solution. Above CMC, the effect of reduced surface tension on the CS nucleation and therefore its formation may be negated by other factors, such as an increase in viscosity or adsorption of surfactant on the crystal surface.

Dissolution testing of a poorly soluble compound using the flow-through cell dissolution apparatus.

Dissolution of Pfizer Compound PD198306, a poorly soluble compound, was studied in 25 mM pH 9 sodium phosphate solution with 0.5% SLS using the flow-through cell dissolution apparatus. Unmicronized and micronized drug powders were tested. Several methods of loading the drug powder into the flow-through dissolution cells and their impact on dissolution were investigated. The influence of flow rate of the dissolution medium on the rate and extent of dissolution were studied. PD198306 has poor wettability even in the presence of 0.5% SLS. It was found that loading the drug powder into the dissolution cell in the form of a suspension provided the best dissolution profile in terms of the rate and extent of dissolution. The flow rate of 4 ml/min resulted in good particle size discrimination.