Normalized Quantitative PCR Measurements as Predictors for Ethene Formation at Sites Impacted with Chlorinated Ethenes.

Quantitative PCR (qPCR) targeting Dehalococcoides mccartyi ( Dhc) biomarker genes supports effective management at sites impacted with chlorinated ethenes. To establish correlations between Dhc biomarker gene abundances and ethene formation (i.e., detoxification), 859 groundwater samples representing 62 sites undergoing monitored natural attenuation or enhanced remediation were analyzed. Dhc 16S rRNA genes and the vinyl chloride (VC) reductive dehalogenase genes bvcA and vcrA were detected in 88% and 61% of samples, respectively, from wells with ethene. Dhc 16S rRNA, bvcA, vcrA, and tceA (implicated in cometabolic reductive VC dechlorination) gene abundances all positively correlated with ethene formation. Significantly greater ethene concentrations were observed when Dhc 16S rRNA gene and VC RDase gene abundances exceeded 107 and 106 copies L-1, respectively, and when Dhc 16S rRNA- and bvcA + vcrA-to-total bacterial 16S rRNA gene ratios exceeded 0.1%. Dhc 16S rRNA gene-to- vcrA/ bvcA ratios near unity also indicated elevated ethene; however, no increased ethene was observed in 19 wells where vcrA and/or bvcA gene copy numbers exceeded Dhc cell numbers 10- to 10 000-fold. Approximately one-third of samples with detectable ethene lacked bvcA, vcrA, and tceA, suggesting that comprehensive understanding of VC detoxification biomarkers has not been achieved. Although the current biomarker suite is incomplete, the data analysis corroborates the value of the available Dhc DNA biomarkers for prognostic and diagnostic groundwater monitoring at sites impacted with chlorinated ethenes.

Monitoring gene expression to evaluate oxygen infusion at a gasoline-contaminated site.

Increasingly, molecular biological tools, most notably quantitative polymerase chain reaction (qPCR), are being employed to provide a more comprehensive assessment of bioremediation of petroleum hydrocarbons and fuel oxygenates. While qPCR enumeration of key organisms or catabolic genes can aid in site management decisions, evaluation of site activities conducted to stimulate biodegradation would ideally include a direct measure of gene expression to infer activity. In the current study, reverse-transcriptase (RT) qPCR was used to monitor gene expression to evaluate the effectiveness of an oxygen infusion system to promote biodegradation of BTEX and MTBE. During system operation, dissolved oxygen (DO) levels at the infusion points were greater than 30 mg/L, contaminant concentrations decreased, and transcription of two aromatic oxygenase genes and Methylibium petroleiphilum PM1-like 16S rRNA copies increased by as many as 5 orders of magnitude. Moreover, aromatic oxygenase gene transcription and PM1 16s rRNA increased at downgradient locations despite low DO levels even during system operation. Conversely, target gene expression substantially decreased when the system was deactivated. RT-qPCR results also corresponded to increases in benzene and MTBE attenuation rates. Overall, monitoring gene expression complemented traditional groundwater analyses and conclusively demonstrated that the oxygen infusion system promoted BTEX and MTBE biodegradation.

Quantification of aromatic oxygenase genes to evaluate enhanced bioremediation by oxygen releasing materials at a gasoline-contaminated site.

Subsurface injection of oxygen-releasing materials (ORMs) is frequently performed at petroleum-contaminated sites to stimulate aerobic bioremediation of benzene, toluene, ethylbenzene, and xylenes (BTEX). In this study, qPCR enumeration of aromatic oxygenase genes and PCR-DGGE profiles of bacterial 16S rRNA genes were combined with groundwater monitoring to determine the impact of ORM injection on BTEX bioremediation at a gasoline-contaminated site. Prior to injection, BTEX concentrations were greater than 3 mg/L and DO levels were typically lessthan 2 mg/L, butphenol hydroxylase (PHE) and ring-hydroxylating toluene monooxygenase (RMO) genes were detected in impacted wells indicating the potential for aerobic BTEX biodegradation. Following injection, DO increased, BTEX concentrations decreased substantially, and PHE and RMO genes copies increased by 1-3 orders of magnitude. In addition, naphthalene dioxygenase (NAH) and xylene monooxygenase (TOL) genes were intermittently detected during periods of increased DO. Following depletion of the ORM, DO decreased, BTEX concentrations rebounded, and oxygenase genes were no longer detected. Temporal changes in PCR-DGGE microbial community profiles reflected the dynamic changes in subsurface conditions. Overall, the combination of chemical and geochemical analyses with quantification of aromatic oxygenase genes demonstrated that injection stimulated BTEX biodegradation until the ORM was depleted.

Enumeration of aromatic oxygenase genes to evaluate biodegradation during multi-phase extraction at a gasoline-contaminated site.

Multi-phase extraction (MPE) is commonly used at petroleum-contaminated sites to volatilize and recover hydrocarbons from the vadose and saturated zones in contaminant source areas. Although primarily a physical treatment technology, the induced subsurface air flow can potentially increase oxygen supply and promote aerobic biodegradation of benzene, toluene, ethylbenzene, and xylenes (BTEX), the contaminants of concern at gasoline-contaminated sites. In this study, real-time PCR enumeration of aromatic oxygenase genes and PCR-DGGE profiles were used to elucidate the impact of MPE operation on the aquifer microbial community structure and function at a gasoline-contaminated site. Prior to system activation, ring-hydroxylating toluene monooxygenase (RMO) and naphthalene dioxygenase (NAH) gene copies were on the order of 10(6) to 10(10)copies L(-1) in groundwater samples obtained from BTEX-impacted wells. Aromatic oxygenase genes were not detected in groundwater samples obtained during continuous MPE indicating decreased populations of BTEX-utilizing bacteria. During periods of pulsed MPE, total aromatic oxygenase gene copies were not significantly different than prior to system activation, however, shifts in aromatic catabolic genotypes were noted. The consistent detection of RMO, NAH, and phenol hydroxylase (PHE), which catabolizes further oxidation of hydroxylated BTEX metabolites indicated the potential for aerobic biodegradation of dissolved BTEX during pulsed MPE.

Enumeration of aromatic oxygenase genes to evaluate monitored natural attenuation at gasoline-contaminated sites.

Monitoring groundwater benzene, toluene, ethylbenzene, and xylene (BTEX) concentrations is the typical method to assess monitored natural attenuation (MNA) and bioremediation as corrective actions at gasoline-contaminated sites. Conclusive demonstration of bioremediation, however, relies on converging lines of chemical and biological evidence to support a decision. In this study, real-time PCR quantification of aromatic oxygenase genes was used to evaluate the feasibility of MNA at two gasoline-impacted sites. Phenol hydroxylase (PHE), ring-hydroxylating toluene monooxygenase (RMO), naphthalene dioxygenase (NAH), toluene monooxygenase (TOL), toluene dioxygenase (TOD), and biphenyl dioxygenase (BPH4) genes were routinely detected in BTEX-impacted wells. Aromatic oxygenase genes were not detected in sentinel wells outside the plume indicating that elevated levels of oxygenase genes corresponded to petroleum hydrocarbon contamination. Total aromatic oxygenase gene copy numbers detected in impacted wells were on the order of 10(6)-10(9)copies L(-1). PHE, RMO, NAH, TOD, and BPH4 gene copies positively correlated to total BTEX concentration. Mann-Kendall analysis of benzene concentrations was used to evaluate the status of the dissolved BTEX plume. The combination of trend analysis of contaminant concentrations with quantification of aromatic oxygenase genes was used to assess the feasibility of MNA as corrective measures at both sites.

Detection and enumeration of aromatic oxygenase genes by multiplex and real-time PCR.

Our abilities to detect and enumerate pollutant-biodegrading microorganisms in the environment are rapidly advancing with the development of molecular genetic techniques. Techniques based on multiplex and real-time PCR amplification of aromatic oxygenase genes were developed to detect and quantify aromatic catabolic pathways, respectively. PCR primer sets were identified for the large subunits of aromatic oxygenases from alignments of known gene sequences and tested with genetically well-characterized strains. In all, primer sets which allowed amplification of naphthalene dioxygenase, biphenyl dioxygenase, toluene dioxygenase, xylene monooxygenase, phenol monooxygenase, and ring-hydroxylating toluene monooxygenase genes were identified. For each primer set, the length of the observed amplification product matched the length predicted from published sequences, and specificity was confirmed by hybridization. Primer sets were grouped according to the annealing temperature for multiplex PCR permitting simultaneous detection of various genotypes responsible for aromatic hydrocarbon biodegradation. Real-time PCR using SYBR green I was employed with the individual primer sets to determine the gene copy number. Optimum polymerization temperatures for real-time PCR were determined on the basis of the observed melting temperatures of the desired products. When a polymerization temperature of 4 to 5 degrees C below the melting temperature was used, background fluorescence signals were greatly reduced, allowing detection limits of 2 x 10(2) copies per reaction mixture. Improved in situ microbial characterization will provide more accurate assessment of pollutant biodegradation, enhance studies of the ecology of contaminated sites, and facilitate assessment of the impact of remediation technologies on indigenous microbial populations.