Synthesis and characterization of magnetic biochar adsorbents for the removal of Cr(VI) and Acid orange 7 dye from aqueous solution.

In this study, different types of magnetic biochar nanocomposites were synthesized using the co-precipitation method. Two biochar materials, namely, sewage sludge biochar and woodchips biochar, were prepared at two different temperatures, viz., 450 and 700 °C. These biochars were further modified with magnetic nanoparticles (Fe3O4). The modified biochar nanocomposites were characterized using field emission-scanning electron microscopy (FE-SEM), X-ray diffraction (XRD), transmission electron microscopy (TEM), Brunauer-Emmett-Teller (BET), SQUID analysis, X-ray photoelectron spectroscopy (XPS), and Fourier-transform infrared spectroscopy (FTIR). The potential of prepared adsorbents was examined for the removal of hexavalent chromium (Cr(VI)) and Acid orange 7 (AO7) dye from water as a function of various parameters, namely, contact time, pH of solution, amount of adsorbents, and initial concentrations of adsorbates. Various kinetic and isotherm models were tested to discuss and interpret the adsorption mechanisms. The maximum adsorption capacities of modified biochars were found as 80.96 and 110.27 mg g-1 for Cr(VI) and AO7, respectively. Magnetic biochars showed high pollutant removal efficiency after 5 cycles of adsorption/desorption. The results of this study revealed that the prepared adsorbents can be successfully used for multiple cycles to remove Cr(VI) and AO7 from water. Graphical Abstract.

Using the method of dynamic factors for assessing the transfer of chemical elements from soil to plants from various perspectives.

Environmental, biological, and ecosystem-specific properties may influence the transfer of chemical elements (CEs) from soils to plants, including the variation in the chemical elements' concentration, their types, and physiological parameters, such as biotransformation ability in the plants. The interface between the soil and a plant, or the concentration of a particular chemical element in a plant with respect to its concentration in the soil, is the basis for a widely used biological absorption coefficient, also known as the transfer factor, bioaccumulation factor, mobility ratio, or plant-soil coefficient, which is expressed in terms of the chemical element's concentration in the plant and soil. However, from the biogeochemical perspective, these coefficients/factors can provide a comparison of the chemical element (CE) concentration in different media (plants and soil), but only in a particular place (under typical environmental conditions) and at a particular time. However, factors that highlight the variation in the processes, rather than the variation in the chemical element quantity under the conditions of the environmental variation, are required. The second-level or dynamic factors can be used for this purpose. A quantitative method, using the dynamic factors of bioaccumulation, biophilicity, translocation, bioavailability, and phytoremediation, is offered to assess the variation in the process of the uptake of chemical elements by different plants, to evaluate the influence of soil modification on their participation in the plants' metabolism and to perform quantitative evaluation of phytoremediation efficiency over a particular period of time. The use of dynamic factors for describing the chemical elements' uptake by plants in various cases, representing aerogenic and edaphic chemical elements' transfer, is discussed.

Research and analysis of biogas produced from sewage sludge using a batch bioreactor.

The examined equipment is a batch bioreactor intended to produce biogas from sewage sludge, vegetal and other organic wastes. The maintenance of an optimal temperature and oxygen concentration inside the devise, as well as the intensity of mixing a substrate, result in methane CH4 actively generated by methanogenic bacterial colonies. Manufacturing biotechnologies and biogas deal with environmental protection, energy and economic problems. For research purposes, considering organic loading (hereinafter, VS/L), four different types of the packing material of sewage sludge, including VS/L = 3.5 g L-1, VS/L = 5.0 g L-1, VS/L = 10.0 g L-1 and VS/L = 15.0 g L-1, were used. The highest concentration of CH4 (75.1%) and yield of biogas (36.78 L d-1) were found using a packing material, the organic loading of which made 15.0 g L-1. Throughout the experiment, the temperature of the mesophilic process reached 35-37°C, and the concentration of oxygen was 0.0-0.1%. The research carried out has disclosed the dependencies of the components of biogas on the number of the days of the performed experiment. With reference to experimental research conducted at the laboratory, a small-sized batch bioreactor can be designed and successfully used in a small farm.

Biogeochemical and engineered barriers for preventing spread of contaminants.

The intensive industrial development and urbanization, as well as the negligible return of hazardous components to the deeper layers of the Earth, increases the contamination load on the noosphere (i.e., the new status of the biosphere, the development of which is mainly controlled by the conscious activity of a human being). The need for reducing the spread and mobility of contaminants is growing. The insights into the role of the tree in the reduction of contaminant mobility through its life cycle are presented to show an important function performed by the living matter and its products in reducing contamination. For maintaining the sustainable development, natural materials are often used as the media in the environmental protection technologies. However, due to increasing contamination intensity, the capacity of natural materials is not sufficiently high. Therefore, the popularity of engineered materials, such as biochar which is the thermochemically modified lignocellulosic product, is growing. The new approaches, based on using the contaminant footprint, as well as natural (biogeochemical) and engineered barriers for reducing contaminant migration and their application, are described in the paper.

A biochar-based medium in the biofiltration system: Removal efficiency, microorganism propagation, and the medium penetration modeling.

UNLABELLED: Biofiltration is a method of biological treatment belonging to cleaner technologies because it does not produce secondary air pollutants, but helps to integrate natural processes in microorganisms for decomposing volatile air pollutants and solving odor problems. The birch wood biochar has been chosen as a principal material for biofilter bed medium. The experiments were conducted at the temperatures of 24, 28, and 32 °C, while the concentration of acetone, xylene, and ammonium reached 300 mg/m(3) and the flow rate was 100 m(3)/hr. Before passing through the stage of the experimental research into the packing material inside biofilters, microorganisms were introduced. Four strains of microorganisms (including micromycetes Aspergillus versicolor BF-4 and Cladosporium herbarum 7KA, as well as yeast Exophiala sp. BF1 and bacterium Bacillus subtilis B20) were selected. At the inlet loading rate of 120 g/m(3)/hr, the highest elimination capacity of xylene in the biochar-based biofilter with the inoculated medium was 103 g/m(3)/hr, whereas that of ammonia was 102 g/m(3)/hr and that of acetone was 97 g/m(3)/hr, respectively. The maximum removal efficiency reached 86%, 85%, and 81%, respectively. The temperature condition (though characterized by some rapid changes) can hardly have a considerable influence on the biological effect (i.e., microbiological activity) of biofiltration; however, it can cause the changes in physical properties (e.g., solubility) of the investigated compounds. IMPLICATIONS: The birch biochar can be successfully used in the biofiltration system for propagation of inoculated microorganisms, biodegrading acetone, xylene, and ammonia. At the inlet loading rate of 120 g/m(3)/hr, the highest elimination capacity of xylene was 103 g/m(3)/hr, that of ammonia was 102 g/m(3)/hr, and that of acetone was 97 g/m(3)/hr, respectively. The morphological structure of biochar can be affected by the aggressive air contaminants, causing the change in the medium specific surface area, which is one of the factors controlling the biofilter performance. Although biological effects in biofiltration are typically considered to be more important than physical effects, the former may be more important for compounds with high Henry's Law coefficient values, and the biofilter design should thus provide conditions for better compound absorption.

Mitigating heavy metal accumulation into rice (Oryza sativa L.) using biochar amendment--a field experiment in Hunan, China.

A field experiment was conducted to investigate the effect of bean stalk (BBC) and rice straw (RBC) biochars on the bioavailability of metal(loid)s in soil and their accumulation into rice plants. Phytoavailability of Cd was most dramatically influenced by biochars addition. Both biochars significantly decreased Cd concentrations in iron plaque (35-81 %), roots (30-75 %), shoots (43-79 %) and rice grain (26-71 %). Following biochars addition, Zinc concentrations in roots and shoots decreased by 25.0-44.1 and 19.9-44.2 %, respectively, although no significant decreases were observed in iron plaque and rice grain. Only RBC significantly reduced Pb concentrations in iron plaque (65.0 %) and roots (40.7 %). However, neither biochar significantly changed Pb concentrations in rice shoots and grain. Arsenic phytoavailability was not significantly altered by biochars addition. Calculation of hazard quotients (HQ) associated with rice consumption revealed RBC to represent a promising candidate to mitigate hazards associated with metal(loid) bioaccumulation. RBC reduced Cd HQ from a 5.5 to 1.6. A dynamic factor's way was also used to evaluate the changes in metal(loid) plant uptake process after the soil amendment with two types of biochar. In conclusion, these results highlight the potential for biochar to mitigate the phytoaccumulation of metal(loid)s and to thereby reduce metal(loid) exposure associated with rice consumption.

Multilingual education of students on a global scale and perspective-international networking on the example of bioindication and biomonitoring (B&B technologies).

Living or formerly living organisms are being used to obtain information on the quality of the general health status of our environment by bioindication and biomonitoring methods for many decades. Thus, different roads toward this common scientific goal were developed by a lot of different international research groups. Global cooperation in between various scientific teams throughout the world has produced common ideas, scientific definitions, and highly innovative results of this extremely attractive working field. The transdisciplinary approach of different and multifaceted scientific areas-starting from biology, analytical chemistry, via health physics, up to social and economic issues-have surpassed mental barriers of individual scientists, so that "production" of straightforward common results related to the influence of material and immaterial environmental factors to the well-being of organisms and human life has now reached the forefront of international thinking. For the further sustainable development of our common scientific "hobby" of bioindication and biomonitoring, highest personal energy has to be given by us, being teachers to our students and to convince strategically decision makers as politicians to invest (financially) into the development of education and research of this innovative technique. Young people have to be intensively convinced on the "meaning" of our scientific doing, e.g., by extended forms of education. One example of multilingual education of students on a global scale and perspective is given here, which we started about 3 years ago.

Integrated evaluation of aerogenic pollution by air-transported heavy metals (Pb, Cd, Ni, Zn, Mn and Cu) in the analysis of the main deposit media.

The composition of the ambient air is constantly changing; therefore, the monitoring of ambient air quality to detect the changes caused by aerogenic pollutants makes the essential part of general environmental monitoring. To achieve more effective improvement of the ambient air quality, the Directive 2008/50/EC on 'Ambient Air Quality and Cleaner Air for Europe' was adopted by the European Parliament and the European Council. It informed the public and enterprises about a negative effect of pollution on humans, animals and plants, as well as about the need for monitoring aerogenic pollutants not only at the continuous monitoring stations but also by using indicator methods, i.e. by analysing natural deposit media. The problem of determining the relationship between the accumulation level of pollutants by a deposit medium and the level of air pollution and its risks is constantly growing in importance. The paper presents a comprehensive analysis of the response of the main four deposit media, i.e. snow cover, soil, pine bark and epigeic mosses, to the long-term pollution by aerogenic pollutants which can be observed in the area of oil refinery influence. Based on the quantitative expressions of the amounts of the accumulated pollutants in the deposit media, the territory of the oil refinery investigated in this paper has been referred to the areas of mild or moderate pollution.

Analysis of snow-cap pollution for air quality assessment in the vicinity of an oil refinery.

Snow-cap can be used as a simple and effective indicator of industrial air pollution. In this study snow-cap samples were collected from 11 sites located in the vicinity of an oil refinery in Mazeikiai, a region in the north-west of Lithuania, in the winter of 2011. Analysis of snowmelt water and snow-dust was used to determine anthropogenic pollutants such as: sulphates and chlorides, nitrites, nitrates, ammonium nitrogen, total carbon, total nitrogen; heavy metals: lead (Pb), copper (Cu), chromium (Cr), cadmium (Cd). Concentrations of heavy metals in snow-dust were detected thousands of times higher than those in the snowmelt water. In this study, analysis of heavy metal concentration was conducted considering different distances and the wind direction within the impact zone of the oil refinery. The sequence of heavy metals according to their mean concentrations in the snow-dust samples was the following: Pb > Cr > Cu > Cd. Heavy metals highly correlated among each other. The load of snow-dust was evaluated to determine the pollution level in the study area. The highest daily load of snow-dust was 45.81 +/- 12.35 mg/m2 in the north-western direction from the oil refinery. According to classification of the daily load of snow-dust a lower than medium-risk level of pollution was determined in the vicinity of the oil refinery.

Atmospheric BTEX concentrations in the vicinity of the crude oil refinery of the Baltic region.

Among chemical industries, petroleum refineries have been identified as large emitters of a wide variety of pollutants. Benzene, toluene, ethylbenzene, and xylene (BTEX) form an important group of aromatic volatile organic compounds (VOCs) because of their role in the troposphere chemistry and the risk posed to human health. A very large crude oil refinery of the Baltic States (200,000 bbl/day) is situated in the northern, rural part of Lithuania, 10 km from the town of Mazeikiai (Lithuania). The objectives of this study were: (1) to determine of atmospheric levels of BTEX in the region rural and urban parts at the vicinity of the crude oil refinery; and (2) to investigate the effect of meteorological parameters (wind speed, wind direction, temperature, pressure, humidity) on the concentrations measured. The averaged concentration of benzene varied from 2.12 ppbv in the rural areas to 2.75 ppbv in the urban areas where the traffic was determined to be a dominant source of BTEX emissions. Our study showed that concentration of benzene, as strictly regulated air pollutant by EU Directive 2008/50/EC, did not exceed the limit of 5 ppbv in the region in the vicinity of the crude oil refinery during the investigated period. No significant change in air quality in the vicinity of the oil refinery was discovered, however, an impact of the industry on the background air quality was detected. The T/B ratio (0.50-0.81) that was much lower than 2.0, identified other sources of pollution than traffic.