Waveguide-Coupled Light Photodetector Based on Two-Dimensional Molybdenum Disulfide.

The integration of transition metal dichalcogenides with photonic structures such as sol-gel SiOx:TiOy optical waveguides (WGs) makes possible the fabrication of photonic devices with the desired characteristics in the visible spectral range. In this study, we propose and experimentally demonstrate a MoS2-based photodetector integrated with a sol-gel SiOx:TiOy WG. Based on the spectroscopic measurements performed for our device, we concluded that the light entering the WG is almost completely channeled out from the WG and absorbed by the MoS2 flake, which is deposited on the WG. Therefore, this device works as a photodetector. The light coupling into the MoS2 region in this device construction is due to the high contrast of refractive index between the van der Waals crystal and the sol-gel WG, which is ∼4 and ∼1.8, respectively. The obtained MoS2-based photodetectors exhibit a photoresponsivity of 0.3 A W-1 (n-type MoS2) and 7.53 mA W-1 (p-type MoS2) at a bias voltage of 2 V. These results reveal great potential in the integration of sol-gel WGs with van der Waals crystals in optoelectronic applications.

Concentration-Dependent Emission of Annealed Sol-Gel Layers Incorporated with Rhodamine 19 and 6G as the Route to Tunable High-Temperature Luminescent Materials.

The sol-gel technology allows for the development of materials for nonlinear optics and photonics through the synthesis of multifunctional ceramic materials. Although the nature of the amorphous matrix allows the material to be doped with a large amount of the active components without quenching, it may affect the spectroscopic characteristics of the dye (e.g., result in a shift of absorption and emission peaks with drying time, presumably with a change of concentration). This study presents the material (SiO2 impregnated with organic dyes-Rhodamine 6G and 19) with tunable emissions obtained by the authors upon annealing at different temperatures within the range of 100-300 °C. Possible observed effects were discussed based on spectroscopic properties and thermal studies of the synthesized material. Concerning annealing at different temperatures, an effect on concentration was observed. At the same time, a longer heating process at 300 °C revealed a protective function of sol-gel-derived silica for the organic dye; the longer heating did not cause any further significant changes in the dye's emission, which indicates the preservative role of the sol-gel layers. Furthermore, etching tests of thin layers were conducted, resulting in smooth side edges of the waveguide. The tests have shown that it is possible to use dye-doped sol-gel layers as active components in photonics platforms.

Investigation of thermal effects in through-silicon vias using scanning thermal microscopy.

Results of quantitative investigations of copper through-silicon vias (TSVs) are presented. The experiments were performed using scanning thermal microscopy (SThM), enabling highly localized imaging of thermal contrast between the copper TSVs and the surrounding material. Both dc and ac active-mode SThM was used and differences between these variants are shown. SThM investigations of TSVs may provide information on copper quality in TSV, as well as may lead to quantitative investigation of thermal boundaries in micro- and nanoelectronic structures. A proposal for heat flow analysis in a TSV, which includes the influence of the boundary region between the TSV and the silicon substrate, is presented; estimation of contact resistance and boundary thermal conductance is also given.