Highly Sensitive Protein Detection by Asymmetric Mach-Zehnder Interferometry for Biosensing Applications.

The sensitivity and performance of an asymmetric Mach-Zehnder interferometer (aMZI) were compared to those of quartz crystal microbalance with dissipation (QCM-D). The binding of streptavidin to sensor chips coated with poly-l-lysine (PLL), modified with biotin and oligoethyleneglycol (OEG) (PLL-biotin), was used to compare the binding signals obtained from both technologies. PLL-biotin proved to be an efficient method to add bioreceptors to both the QCM-D and aMZI chips. The final, saturated value of streptavidin binding was compared with those from aMZI (253 ng cm-2) and QCM-D (460 ng cm-2). These values were then used to evaluate that 45% of the measured streptavidin mass in the QCM-D came from hydrodynamically coupled water. Importantly, the signal-to-noise ratio of the aMZI was found to be 200 times higher than that of the QCM-D. These results indicate the potential of the aMZI platform for highly sensitive and accurate biosensing applications.

Modulation-frequency encoded multi-color fluorescent DNA analysis in an optofluidic chip.

We introduce a principle of parallel optical processing to an optofluidic lab-on-a-chip. During electrophoretic separation, the ultra-low limit of detection achieved with our set-up allows us to record fluorescence from covalently end-labeled DNA molecules. Different sets of exclusively color-labeled DNA fragments-otherwise rendered indistinguishable by spatio-temporal coincidence-are traced back to their origin by modulation-frequency-encoded multi-wavelength laser excitation, fluorescence detection with a single ultrasensitive, albeit color-blind photomultiplier, and Fourier analysis decoding. As a proof of principle, fragments obtained by multiplex ligation-dependent probe amplification from independent human genomic segments, associated with genetic predispositions to breast cancer and anemia, are simultaneously analyzed.

High-resolution electrophoretic separation and integrated-waveguide excitation of fluorescent DNA molecules in a lab on a chip.

By applying integrated-waveguide laser excitation to an optofluidic chip, fluorescently labeled DNA molecules of 12 or 17 different sizes are separated by CE with high operating speed and low sample consumption of approximately 600 pL. When detecting the fluorescence signals of migrating DNA molecules with a PMT, the LOD is as low as 2.1 pM. In the diagnostically relevant size range (approximately 150-1000 base-pairs) the molecules are separated with reproducibly high sizing accuracy (> 99%) and the plug broadening follows Poissonian statistics. Variation of the power dependence of migration time on base-pair size--probably with temperature and condition of the sieving gel matrix--indicates that the capillary migration cannot be described by a simple physical law. Integrated-waveguide excitation of a 12-microm narrow microfluidic segment provides a spatio-temporal resolution that would, in principle, allow for a 20-fold better accuracy than the currently supported by state-of-the-art electrophoretic separation in microchips, thereby demonstrating the potential of this integrated optical approach to fulfill the resolution demands of future electrophoretic microchips.

Fluorescence monitoring of microchip capillary electrophoresis separation with monolithically integrated waveguides.

Using femtosecond laser writing, optical waveguides were monolithically integrated into a commercial microfluidic lab-on-a-chip device, with the waveguides intersecting a microfluidic channel. Continuous-wave laser excitation through these optical waveguides confines the excitation window to a width of 12 microm, enabling high-resolution monitoring of the passage of different types of fluorescent analytes when migrating and being separated in the microfluidic channel by microchip capillary electrophoresis. Furthermore, we demonstrate on-chip-integrated waveguide excitation and detection of a biologically relevant species, fluorescently labeled DNA molecules, during microchip capillary electrophoresis. Well-controlled plug formation as required for on-chip integrated capillary electrophoresis separation of DNA molecules, and the combination of waveguide excitation and a low limit of detection, will enable monitoring of extremely small quantities with high spatial resolution.

Angle-scanning SPR imaging for detection of biomolecular interactions on microarrays.

In this paper we describe the use of a commercial surface plasmon resonance (SPR) imaging instrument for monitoring the binding of biomolecules on user-defined regions of interest of a microarray. By monitoring the angle shift of the SPR-dip using a continuous angle-scanning mode instead of monitoring the change in reflectivity at a fixed angle, a linear relationship with respect to the mass density change on the surface will remain over a wide dynamic angle range of 8 degrees. Peptides (2.4 kDa) and proteins (150 kDa) were both spotted on the same sensor chip to illustrate that both, low and high molecular weight ligands with initial large differences in off-set SPR angles, can be applied within the same experiment. By using a fluorescently labeled antibody, SPR results can be confirmed by means of fluorescence microscopy after completion of a SPR experiment. SPR imaging in angle-scanning operation provides sensitive, accurate, and label-free detection of analyte binding on microarrays containing different molecular weight ligands.

Biomolecular interaction monitoring of autoantibodies by scanning surface plasmon resonance microarray imaging.

A new commercial surface plasmon resonance (SPR) imaging analysis system with a novel SPR dip angle scanning principle allows the measurement, without the need for labeling, of the exact SPR dip angle. With this system hundreds of biomolecular interactions can be monitored on microarrays simultaneously and with great precision. The potency of this system is demonstrated by automatically monitoring the interactions between citrullinated peptides and serum autoantibodies of 50 rheumatoid arthritis (RA) patients and 29 controls in a single step. The smallest antibody concentration that could be measured in this experimental setup was 0.5 pM.

Free-flow zone electrophoresis and isoelectric focusing using a microfabricated glass device with ion permeable membranes.

This paper describes a microfabricated free-flow electrophoresis device with integrated ion permeable membranes. In order to obtain continuous lanes of separated components an electrical field is applied perpendicular to the sample flow direction. This sample stream is sandwiched between two sheath flow streams, by hydrodynamic focusing. The separation chamber has two open side beds with inserted electrodes to allow ventilation of gas generated during electrolysis. To hydrodynamically isolate the separation compartment from the side electrodes, a photo-polymerizable monomer solution is exposed to UV light through a slit mask for in situ membrane formation. These so-called salt-bridges resist the pressure driven fluid, but allow ion transport to enable electrical connection. In earlier devices the same was achieved by using open side channel arrays. However, only a small fraction of the applied voltage was effectively utilized across the separation chamber during free-flow electrophoresis and free-flow isoelectric focusing. Furthermore, the spreading of the carrier ampholytes into the side channels resulted in a very restricted pH gradient inside the separation chamber. The chip presented here allows at least 10 times more efficient use of the applied potential and a nearly linear pH gradient from pH 3 to 10 during free-flow isoelectric focusing could be established. Furthermore, the application of hydrodynamic focusing in combination with free-flow electrophoresis can be used for guiding the separated components to specific chip outlets. As a demonstration, several standard fluorescent markers were separated and focused by free-flow zone electrophoresis and by free-flow isoelectric focusing employing a transversal voltage of up to 150 V across the separation chamber.

Electroosmotic guiding of sample flows in a laminar flow chamber.

The so-called address-flow principle is described: a valveless, electroosmotically driven technology used for controlling the stream profile in a laminar flow chamber. The method is explained, and a theoretical description and experimental verification are presented. Adjustment of the flow of two electroosmotically controlled guiding streams, running parallel to a central sample stream, can be used for positioning the sample stream in the dimension perpendicular to the flow direction. The results presented show that address-flow microfluidics allow easy and accurate control of sample stream position and width. The electroosmotic flow (EOF)-controlled guiding of microfluidic flows described in this paper, is a new unit operation that might aid in separation and collection in microfluidic devices. One possible application of address-flow microfluidics is guiding of capillary electrophoresis-separated components over a multisensor array, in order to perform affinity assays.

Signal amplification on planar and gel-type sensor surfaces in surface plasmon resonance-based detection of prostate-specific antigen.

This article describes surface plasmon resonance (SPR)-based detection of prostate-specific antigen (PSA), comparing amplification with colloidal gold (10nm diameter) and latex microspheres (120 nm diameter) on planar- and gel-type sensor surfaces. As matrix, 3% BSA in PBS was used. Experimental data were compared with model calculations that predict the SPR signal that results from covering of the different sensor surfaces with each of the particles used. Amplification with latex particles gave a higher signal than did that with colloidal gold. However, the limit of detection (LOD) attained by latex amplification was not as good as that obtained after gold amplification, and this was unexpected. LOD and sensitivity of the amplified PSA assays when performed with the planar-type sensor disc were equally good or better compared with those when performed with the gel-type sensor disc. Indirect evidence indicates a restricted accessibility of the gel layer on the gel-type sensor toward the colloidal gold. Application of colloidal gold led to a sensitivity increase of approximately three orders of magnitude compared with nonamplified detection. The corresponding LOD was approximately 0.15 ng PSA/ml, which is sufficient for measuring enhanced, clinically relevant PSA levels (>4 ng/ml).

Recirculation of nanoliter volumes within microfluidic channels.

A microfluidic device is described, capable of recirculating nanoliter volumes in restricted microchannel segments. The device consists of a PDMS microfluidic structure, reversibly sealed to a glass substrate with integrated platinum electrodes. The integrated electrodes generate electroosmotic flow locally, which results in a cycling flow in the channel segment between the two electrodes in case one channel exit is closed (dead-end channel). This cycling flow is a consequence of the counterbalancing hydrodynamic pressure against the electroosmotically generated flow. Acid-base indicators were employed to study the formation of H(+) and OH(-) at both the in-channel electrodes. The formation of acid can locally change the zeta-potential of the channel wall, which will affect the flow profile. Using this method, small analyte volumes can be mixed for prolonged times within well-defined channel segments and/or exposed to in-channel sensor surfaces.

Laser-assisted optical rotational cell analyzer measurements reveal early changes in human RBC deformability induced by photodynamic treatment.

BACKGROUND: The ability to deform is important for circulating RBCs in vivo, and earlier studies showed that this property can objectively be measured in vitro by the LORCA. In this study it was investigated whether photodynamic treatment of human RBCs (meant to inactivate contaminating pathogens) affects deformability. STUDY DESIGN AND METHODS: WBC-reduced RBC suspensions (30% Hct) were treated with 1,9-dimethylmethylene blue (DMMB) and red light. Changes in deformability were analyzed by LORCA measurements, in which elongation of the cells is measured at increasing shear stress. The effect of DMMB concentration and light dose was determined as well as the interfering effect of two scavengers of reactive oxygen species, that is, dipyridamole and Trolox. RESULTS: Photodynamic treatment with DMMB resulted in clear changes in RBC deformability. Deformability changes occurred before onset of hemolysis. Under relatively mild treatment conditions, especially deformability at low shear stress was decreased, whereas deformability changes at high shear stress only occurred under harsher treatment conditions. Inclusion of dipyridamole and/or Trolox primarily prevented deformability changes at high shear stress. CONCLUSION: LORCA measurements can effectively be used to detect changes in deformability that are induced by photodynamic treatment of human RBCs. A change in deformability represents an early marker of RBC damage under these conditions.