RESUMEN
Field-effect transistors (FETs) based on two-dimensional materials (2DMs) with atomically thin channels have emerged as a promising platform for beyond-silicon electronics. However, low carrier mobility in 2DM transistors driven by phonon scattering remains a critical challenge. To address this issue, we propose the controlled introduction of localized tensile strain as an effective means to inhibit electron-phonon scattering in 2DM. Strain is achieved by conformally adhering the 2DM via van der Waals forces to a dielectric layer previously nanoengineered with a gray-tone topography. Our results show that monolayer MoS2 FETs under tensile strain achieve an 8-fold increase in on-state current, reaching mobilities of 185 cm²/Vs at room temperature, in good agreement with theoretical calculations. The present work on nanotopographic grayscale surface engineering and the use of high-quality dielectric materials has the potential to find application in the nanofabrication of photonic and nanoelectronic devices.
RESUMEN
Interfacial regions play a key role in determining the overall power conversion efficiency of thin film solar cells. However, the nanoscale investigation of thin film interfaces using conventional analytical tools is challenging due to a lack of required sensitivity and spatial resolution. Here, we surmount these obstacles using tip-enhanced Raman spectroscopy (TERS) and apply it to investigate the absorber (Sb2Se3) and buffer (CdS) layers interface in a Sb2Se3-based thin film solar cell. Hyperspectral TERS imaging with 10 nm spatial resolution reveals that the investigated interface between the absorber and buffer layers is far from uniform, as TERS analysis detects an intermixing of chemical compounds instead of a sharp demarcation between the CdS and Sb2Se3 layers. Intriguingly, this interface, comprising both Sb2Se3 and CdS compounds, exhibits an unexpectedly large thickness of 295 ± 70 nm attributable to the roughness of the Sb2Se3 layer. Furthermore, TERS measurements provide compelling evidence of CdS penetration into the Sb2Se3 layer, likely resulting from unwanted reactions on the absorber surface during chemical bath deposition. Notably, the coexistence of ZnO, which serves as the uppermost conducting layer, and CdS within the Sb2Se3-rich region has been experimentally confirmed for the first time. This study underscores TERS as a promising nanoscale technique to investigate thin film inorganic solar cell interfaces, offering novel insights into intricate interface structures and compound intermixing.
RESUMEN
The deactivation mechanism of the widely used zeolite ZSM-5 catalysts remains unclear to date due to the lack of analytical techniques with sufficient sensitivity and/or spatial resolution. Herein, a combination of hyperspectral confocal fluorescence microscopy (CFM) and tip-enhanced fluorescence (TEFL) microscopy is used to study the formation of different coke (precursor) species involved in the deactivation of zeolite ZSM-5 during the methanol-to-hydrocarbon (MTH) reaction. CFM submicron-scale imaging shows a preferential formation of graphite-like coke species at the edges of zeolite ZSM-5 crystals within 10 min of the MTH reaction (i.e., working catalyst), whilst the amount of graphite-like coke species uniformly increased over the entire zeolite ZSM-5 surface after 90 min (i.e., deactivated catalyst). Furthermore, TEFL nanoscale imaging with â¼35 nm spatial resolution revealed that formation of coke species on the zeolite ZSM-5 surface is non-uniform and a relatively larger amount of coke is formed at the crystal steps, indicating a higher initial catalytic activity.