RESUMEN
This work reports on the integration of ZnO pellets for use as a virtual sensor array (VSA) of volatile organic compounds (VOCs). ZnO pellets consist of nano-powder prepared using a sol-gel technique. The microstructure of the obtained samples was characterized by XRD and TEM methods. The response to VOCs at different concentrations was measured over a range of operating temperatures (250-450 °C) using DC electrical characterization. The ZnO based sensor showed a good response towards ethanol, methanol, isopropanol, acetone and toluene vapors. We note that the highest sensitivity (0.26 ppm-1) is obtained with ethanol while the lowest one (0.041 ppm-1) corresponds to methanol. Consequently, the limit of detection (LOD) estimated analytically reached 0.3 ppm for ethanol and 2.0 ppm for methanol at an operating temperature of 450 °C. The sensing mechanism of the ZnO semiconductor was developed on the basis of the reaction between the reducing VOCs with the chemisorbed oxygen. We verify through the Barsan model that mainly O- ions in the layer react with VOC vapor. Furthermore, dynamic response was investigated to construct mathematical features with distinctly different values for each vapor. Basic linear discrimination analysis (LDA) shows a good job of separating two groups by combining features. In the same way we have shown an original reason embodying the distinction between more than two volatile compounds. With relevant features and VSA formalism, the sensor is clearly selective towards individual VOCs.
RESUMEN
This work reports the thickness effect on the sensing performances of In2S3 material for some Volatile Organic Compounds (VOCs). In2S3 films were deposited on glass substrates by the spray pyrolysis technique. Different samples were prepared via changing the spray time in the range of 10-90 min. The film thickness varies from 0.8 µm to 6.1 µm. The X-ray diffraction results demonstrate that the In2S3 films are polycrystalline in nature and exhibit a cubic structure. Additionally, Scanning Electron Microscopy (SEM) and 3D profilometry examinations show that the surface roughness increases with the rising spray time. On the other hand, the oxygen adsorption versus working temperature was investigated. Sensing measurements with ethanol, methanol and acetone gases were carried out by a dynamic control of the current passing through the sensitive layers. The best sensitivity was obtained for the film matching a 70 min deposit time. An understanding of the detection mechanism based on the oxidation reaction between reduced vapors and chemisorbed oxygen was confirmed. The selectivity of the sensor was analyzed for several volatile organic compounds (VOCs).
RESUMEN
Transition metal oxides as transparent conducting oxides (TCOs) films, with high optical transparency (≥82%), various valence states and p-type conductivity are used in a several physical domains. This work covers the physical study of Zr doped Mn3O4 semiconductor thin films using a spray pyrolysis method where Zr content varies in starting solutions from 0 to 20at.%. The impact of this work is to offer some understanding of microscopic effects of relatively high doping Zr and then correlate these effects with the macroscopic properties for interesting applications especially gas sensor. In fact, the addition of Zr ions pointed out the reduction of crystallite size (24.1 (nm)) with 20at.% doping allowing a better adsorption of gas molecules. In addition, it promotes the increase of optical gap (2.92eV) with 6at.% doping which is a useful parameter for some optical devices. X-ray diffraction (XRD), Raman spectroscopy, FTIR spectroscopy, atomic force microscopy (AFM) and EDAX techniques were used. It is found that these films crystallized in spinel type tetragonal hausmmanite structure. The gas sensing activity of these thin films (0, 6, 12 and 20at.% Zr) was examined with Ethanol. The performances of these last four sensing layers were compared. All the tests were performed at different working temperatures Twork=125, 150, 175 and 225°C and under two gas concentrations: 0.1% and 0.5% ethanol using dry air as carrier gas. The films exhibited noticeably ethanol sensing especially the sample doped with 6% of zirconium exhibits the most excellent sensing performance since it showed a clear response already at a low ethanol concentration of 0.1%.
