Leaching characteristics of encapsulated controlled low-strength materials containing arsenic-bearing waste precipitates from refractory gold bioleaching.

We report on the leaching of heavy elements from cemented waste flowable fill, known as controlled low-strength materials (CLSM), for potential mine backfill application. Semi-dynamic tank leaching tests were carried out on laboratory-scale monoliths cured for 28 days and tested over 64 days of leaching with pure de-ionised water as leachant. Mineral processing waste include flotation tailings from a Spanish nickel-copper sulphide concentrate, and two bioleach neutralisation precipitates (from processing at 35°C and 70°C) from a South African arsenopyrite concentrate. Encapsulated CLSM formulations were evaluated to assess the reduction in leaching by encapsulating a 'hazardous' CLSM core within a layer of relatively 'inert' CLSM. The effect of each bioleach waste in CLSM core and tailings in CLSM encapsulating medium, are assessed in combination and in addition to CLSM with ordinary silica sand. Results show that replacing silica sand with tailings, both as core and encapsulating matrix, significantly reduced leachability of heavy elements, particularly As (from 0.008-0.190 mg/l to 0.008-0.060 mg/l), Ba (from 0.435-1.540 mg/l to 0.050-0.565 mg/l), and Cr (from 0.006-0.458 mg/l to 0.004-0.229 mg/l), to below the 'Dutch List' of groundwater contamination intervention values. Arsenic leaching was inherently high from both bioleach precipitates but was significantly reduced to below guideline values with encapsulation and replacing silica sand with tailings. Tailings proved to be a valuable encapsulating matrix largely owing to small particle size and lower hydraulic conductivity reducing diffusion transport of heavy elements. Field-scale trials would be necessary to prove this concept of encapsulation in terms of scale and construction practicalities, and further geochemical investigation to optimise leaching performance. Nevertheless, this work substantiates the need for alternative backfill techniques for sustainable management of hazardous finely-sized bulk mineral residues.

Developing methods to evaluate odour control products.

An economical and practical alternative to the standard end-of-pipe odour control methods is the application of liquid odour control products. Currently, there are no established product-testing methods. The data that are available are often of questionable quality and may have limited relevance to waste management. Waste facilities receive differing streams of waste at varying loading volumes. Whilst in operation this exposes control products to a wide variety of environmental conditions, further increasing the difficulty of selecting an effective means of control. The current study initially identifies commercially available odour control products applicable for solid and liquid waste management operations. Bench-scale batch absorption tests have been carried out to investigate odorous gas abatement for a range of selected commercial products and water at a range of pH values. Hydrogen sulphide was the test odorous gas, as it is commonly associated with waste processes. Gas-phase volumetric mass-transfer coefficients (KGa) have been calculated to determine mass-transfer performance. The development of a pilot-scale spray tower is then presented as the testing apparatus for future work. This is an attempt to construct a repeatable testing method for evaluating abatement performance of odour control products, and control the problems encountered when applying odour control products to open sites. KGa values and data collected from tests in this study will be considered in future work as design parameters for the rig.