In Situ Strain Measurements Within Helmet Padding During Linear Impact Testing.

Drop and Impact testing of helmets are used extensively in the design process and eventual certification of helmets. These techniques have traditionally relied heavily on the measurement of the kinematic response to impact, which provides an indirect measurement of the liner response that is subject to interpretation during the design process. In the present work, we introduce an in situ experimental technique that provides a time-resolved measurement of the deformation of the helmet and its components during an impact event. The data collected from a high-speed X-ray imaging system can provide a full description of the deformation at the component level, which provides a helmet designer further insight into the performance of their helmet, while also returning the traditional kinematic metrics. The data presented focuses on the deformation of a commercial hockey helmet subjected to a series of linear impacts with three different impactor caps at speeds ranging from 2.4 to 4.5 m/s. Deformation of the liner was monitored in the midsagittal and a parasagittal plane of the helmet. The results show that there is a clear dependence on the maximum strain achieved in the foam that is dependent on the impact type, the impactor shape, and the resulting strain rate of deformation in the foam liner. These techniques can provide the first data for a direct validation and calibration of finite element helmet deformation models, while also providing a new tool-set to improve the efficacy of helmet design.

The influence of the tertiary bronchi on dynamic lung deformation.

Finite element models of thoracic injury often treat the lung as a bulk homogeneous and isotropic material, which reduces the computational costs associated with such investigations. Ignoring the heterogeneous structure of the lung may be computationally expedient, but this simplification may inadvertently fail to capture the true lung strain dynamics. In the present work, a series of direct impact experiments were performed on porcine lungs, inflated to a relevant expiratory pressure, and monitored using high-speed X-ray imaging. The lungs were instrumented with radiopaque markers within the parenchyma and tertiary bronchi to monitor the resulting deformation mechanics. The deformation mechanics demonstrate a high degree of strain localization related to the structural heterogeneity of the lung. The relative motion of the tertiary bronchi was measured during the impact event, and used to estimate the parenchyma tissue strains in the inter-bronchial regions. These were shown to exceed the trans-lobe strains by a factor 3 to 5 times higher in their tensile, compressive, and shear strain responses. Our results demonstrate that the lung parenchyma and bronchial tissues form a heterogeneous structure with a substantial stiffness differential that cannot be appropriately modelled as a homogeneous and isotropic monolithic mass without loss of accuracy and predictive relevance.

A Parametric Analysis of Embedded Tissue Marker Properties and Their Effect on the Accuracy of Displacement Measurements.

Datasets obtained from cadaveric experimentation are broadly used in validating finite element models of head injury. Due to the complexity of such measurements in soft tissues, experimentalists have relied on tissue-embedded radiographic or sonomicrometry tracking markers to resolve tissue motion caused by impulsive loads. Dynamic coupling of markers with the surrounding tissue has been a previous concern, yet a thorough sensitivity investigation of marker influences on tissue deformation has not been broadly discussed. Technological improvements to measurement precision have bolstered confidence in acquired data; however, precision is often conflated with accuracy; the inclusion of markers in the tissue may alter its natural response, resulting in a loss of accuracy associated with an altered displacement field. To gain an understanding of how marker properties may influence the measured response to impact, we prepared a set of nine marker designs using a Taguchi L9 array to investigate marker design choice sensitivity. Each of these designs was cast into a block of tissue simulant and subjected to repeated drop tests. Vertical displacement was measured and compared to the response of the neat material, which contained massless tracking markers. Medium density and medium stiffness markers yielded the least deviation from the neat material response. The results provide some design guidelines indicating the importance of maintaining marker matrix density ratio below 1.75 and marker stiffness below 1.0 MPa. These properties may minimize marker interference in tissue deformation. Overall, embedded marker properties must be considered when measuring the dynamic response of tissue.