Can biodegradable materials reduce plastic pollution without decreasing catch efficiency in longline fishery?

Longlining is a widely used fishing method. During longline fishing, some of the snoods connecting the hooks to the mainline are often lost at sea. Since snoods are made of nylon or polyester, lost snoods contribute to marine plastic pollution. Replacing nylon or polyester with a new material made of biodegradable plastics can potentially reduce macro- and microplastic pollution that is caused by lost snoods. In this study, we estimated the risk for snood loss in a longline fishery targeting haddock (Melanogrammus aeglefinus (Linnaeus, 1758)) and Atlantic cod (Gadus morhua (Linnaeus, 1758)) in Barents Sea. Further, we compared catch efficiency in this fishery for snoods made of biodegradable and nylon materials. No significant differences were found between the two materials. Therefore, catch efficiency does not represent a barrier for using biodegradable materials in snoods.

Can vertical separation of species in trawls be utilized to reduce bycatch in shrimp fisheries?

Several shrimp trawl fisheries use a Nordmöre sorting grid to avoid bycatch of fish. However, small fish can pass through the grid. Therefore, the retention of juvenile fish often remains an issue during shrimp trawling. We investigated the vertical distribution of deepwater shrimp (Pandalus borealis) and dominant bycatch species at the point where the Nordmöre grid section is installed. This was achieved using a separator frame which split the net vertically into three compartments of equal entry size. Our results showed that shrimp predominately follow the lower part of the trawl belly, whereas species such as redfish (Sebastes spp.), cod (Gadus morhua), polar cod (Boreogadus saida) and American plaice (Hippoglossoides platessoides) preferred the mid-section in the aft of the trawl. Haddock (Melanogrammus aeglefinus) primarily entered through the upper section of the trawl belly. Using these results, we predict that a vertical separation device installed forward of a 19 mm Nordmöre grid combined with a 35 mm codend would result in a significant reduction in bycatch with only minor loss of shrimp.

Predictive models for codend size selectivity for four commercially important species in the Mediterranean bottom trawl fishery in spring and summer: Effects of codend type and catch size.

Models to predict codend size selectivity for four major commercial species-European hake (Merluccius merluccius), Norway lobster (Nephrops norvegicus), deep-water rose shrimp (Parapenaeus longirostris), and Atlantic horse mackerel (Trachurus trachurus)-in Mediterranean bottom trawl fisheries were established based on data collected during fishing trials using the two legal codends: a 40 mm square-mesh codend and a 50 mm diamond-mesh codend. The models were applied to predict the extent to which size selection depend on codend type, also accounting for the potential effect of codend catch size and fishing season. The size selectivity of the two codends was evaluated and compared in identical simulated controlled conditions. Mesh type significantly affected the size selection of Norway lobster alone, with a slightly better performance of the 40 mm square-mesh codend. A high risk of retention of undersized individuals was predicted for both codends for all species except Norway lobster.

Effect of Codend Circumference on the Size Selection of Square-Mesh Codends in Trawl Fisheries.

It is well established that increasing mesh number in the circumference of a diamond-mesh trawl codend can reduce size selection for round fish, whereas selection for flat fish species is unaffected. This effect has also been documented in Mediterranean trawl fisheries. In contrast, no information is available with regard to the effect of increasing mesh number in the circumference of square-mesh codends on the size selection of round fish and flat fish species. A field study was devised to bridge this gap and formulate proposals aimed at improving trawl fishery management. Size selection data were collected for a round fish species, red mullet (Mullus barbatus), and two flat fish species, Mediterranean scaldfish (Arnoglossus laterna) and solenette (Buglossidium luteum). Fishing trials were conducted in the Adriatic Sea (Central Mediterranean) using three square-mesh codends that differed only in mesh number around the circumference. Results demonstrated that increasing the number of meshes from 107 to 213 reduced the 50% retention length (L50) for red mullet by 2.5 cm but did not affect size selection for the two flat fish species. In some fisheries, regulatory provisions regarding the number of meshes in the circumference should therefore be carefully considered both for diamond- and square-mesh codends.