A Bacillus licheniformis pectin acetylesterase is specific for homogalacturonans acetylated at O-3.

A recombinant acetylesterase from Bacillus licheniformis DSM13, belonging to carbohydrate esterase family 12, was purified and biochemically characterized. The purified enzyme, termed BliPAE, was capable of deacetylating acetylated pectins, e.g. sugar beet pectin (SBP). Contrary to its provisional annotation as rhamnogalacturonan acetylesterase, the enzyme specifically removed acetyl groups from the homogalacturonan region classifying it as a PAE. The recombinant enzyme has a molecular mass of 26.7 kDa and shows optimal activity at pH 8.0 and 50°C. It is stable in the range pH 5.0-7.0 and below 50°C. Methylesterification of the galacturonic acid (GalA) moieties reduces the deacetylation efficacy of BliPAE. The enzyme efficiently removes acetyl groups from SBPs with low degree of methylesterification (DM) 9-30, releasing about 75% of the acetyl groups present in the homogalacturonan. Furthermore, (1)H NMR of polymer and LC-HILIC-MS(n) after endo-PGII and PL degradation were used to structurally characterize the BliPAE-modified pectins. The results show that BliPAE removes acetyl groups specifically when substituted at the O-3 position of GalA moieties.

Descriptive parameters for revealing substitution patterns of sugar beet pectins using pectolytic enzymes.

Enzymatic fingerprinting was applied to sugar beet pectins (SBPs) modified by either plant or fungal pectin methyl esterases and alkali catalyzed de-esterification to reveal the ester distributions over the pectin backbone. A simultaneous pectin lyase (PL) treatment to the commonly used endo-polygalacturonase (endo-PG) degradation showed to be effective in degrading both high and low methylesterified and/or acetylated homogalaturonan regions of SBP simultaneously. Using LC-HILIC-MS/ELSD, we studied in detail all the diagnostic oligomers present, enabling us to discriminate between differently prepared sugar beet pectins having various levels of methylesterification and acetylation. Furthermore, distinction between commercially extracted and de-esterified sugar beet pectin having different patterns of substitution was achieved by using novel descriptive pectin parameters. In addition to DBabs approach for nonmethylesterified sequences degradable by endo-PG, the "degree of hydrolysis" (DHPG) representing all partially saturated methylesterified and/or acetylated galacturonic acid (GalA) moieties was introduced as a new parameter. Consequently, the description DHPL has been introduced to quantify all esterified unsaturated GalA oligomers.

Enzymatically and chemically de-esterified lime pectins: characterisation, polyelectrolyte behaviour and calcium binding properties.

A series of pectins with different levels and patterns of methyl esterification was produced by treatment of a very highly methylated pectin with acid, alkali, plant pectin methyl esterase and fungus pectin methyl esterase. The intrinsic pK values, as well as the free fractions of monovalent and calcium counterions, were determined on pectin salt-free solutions. The variations of pK(a) versus the ionisation degree were found to depend on the de-esterification process but a unique value of 2.90+/-0.15 was estimated for the intrinsic pK value. Calcium binding properties of chemically and enzymatically de-esterified pectins were investigated and experimental results were compared to Manning's theoretical values. A progressive dimerisation process for pectins with a blockwise distribution of carboxyl groups in the presence of calcium ions is hypothesised.

Modulation of the degree and pattern of methyl-esterification of pectic homogalacturonan in plant cell walls. Implications for pectin methyl esterase action, matrix properties, and cell adhesion.

Homogalacturonan (HG) is a multifunctional pectic polysaccharide of the primary cell wall matrix of all land plants. HG is thought to be deposited in cell walls in a highly methyl-esterified form but can be subsequently de-esterified by wall-based pectin methyl esterases (PMEs) that have the capacity to remove methyl ester groups from HG. Plant PMEs typically occur in multigene families/isoforms, but the precise details of the functions of PMEs are far from clear. Most are thought to act in a processive or blockwise fashion resulting in domains of contiguous de-esterified galacturonic acid residues. Such de-esterified blocks of HG can be cross-linked by calcium resulting in gel formation and can contribute to intercellular adhesion. We demonstrate that, in addition to blockwise de-esterification, HG with a non-blockwise distribution of methyl esters is also an abundant feature of HG in primary plant cell walls. A partially methyl-esterified epitope of HG that is generated in greatest abundance by non-blockwise de-esterification is spatially regulated within the cell wall matrix and occurs at points of cell separation at intercellular spaces in parenchymatous tissues of pea and other angiosperms. Analysis of the properties of calcium-mediated gels formed from pectins containing HG domains with differing degrees and patterns of methyl-esterification indicated that HG with a non-blockwise pattern of methyl ester group distribution is likely to contribute distinct mechanical and porosity properties to the cell wall matrix. These findings have important implications for our understanding of both the action of pectin methyl esterases on matrix properties and mechanisms of intercellular adhesion and its loss in plants.

Analysis of different de-esterification mechanisms for pectin by enzymatic fingerprinting using endopectin lyase and endopolygalacturonase II from A. niger.

A series of pectins with different distribution patterns of methyl ester groups was produced by treatment with either plant (p-PME) or fungal pectin methyl esterases (f-PME) and compared with those obtained by base catalysed de-esterification. The products generated by digestion of these pectins with either endopectin lyase (PL) or endopolygalacturonase II (PG II) from Aspergillus niger were analysed using matrix assisted laser desorption ionisation mass spectrometry (MALDIMS) and high-performance anion-exchange chromatography with pulsed amperometric or UV detection (HPAEC-PAD/UV). Time course analysis using MALDIMS was used to identify the most preferred substrate for each enzyme. For PL, this was shown to be fully methyl esterified HG whereas for PG II, long regions of HG without any methyl esterification, as produced by p-PME was the optimal substrate. The blockwise de-esterification caused by p-PME treatment gave a decrease of partly methylated oligomers in PL fingerprints, which did not effect the relative composition of partly methylated oligomers. PG II fingerprints showed a constant increase of monomers and oligomers without any methyl ester groups with decreasing degree of esterification (DE), but almost no change in the concentration of partly methylated compounds. PL fingerprints of f-PME and chemically treated pectins showed decreasing amounts of partly methyl esterified oligomers with decreasing DE, together with a relative shift towards longer oligomers. PG II fingerprints were characterised by an increase of partly methylated and not methylated oligomers with decreasing DE. But differences were also seen between these two forms of homogenous de-esterification. Introduction of a certain pattern of methyl ester distribution caused by selective removal of certain methyl ester groups by f-PME is the most reasonable explanation for the detected differences.

Analysis of pectic epitopes recognised by hybridoma and phage display monoclonal antibodies using defined oligosaccharides, polysaccharides, and enzymatic degradation.

The structure of epitopes recognised by anti-pectin monoclonal antibodies (mAbs) has been investigated using a series of model lime-pectin samples with defined degrees and patterns of methyl esterification, a range of defined oligogalacturonides and enzymatic degradation of pectic polysaccharides. In immuno-dot-assays, the anti-homogalacturonan (HG) mAbs JIM5 and JIM7 both bound to samples with a wide range of degrees of methyl esterification in preference to fully de-esterified samples. In contrast, the anti-HG phage display mAb PAM1 bound most effectively to fully de-esterified pectin. In competitive inhibition ELISAs using fully methyl-esterified or fully de-esterified oligogalacturonides with 3-9 galacturonic acid residues, JIM5 bound weakly to a fully de-esterified nonagalacturonide but JIM7 did not bind to any of the oligogalacturonides tested. Therefore, optimal JIM5 and JIM7 binding occurs where specific but undefined methyl-esterification patterns are present on HG domains, although fully de-esterified HG samples contain sub-optimal JIM5 epitopes. The persistence of mAb binding to epitopes in pectic antigens, with 41% blockwise esterification (P41) and 43% random esterification (F43) subject to fragmentation by endo-polygalacturonase II (PG II) and endo-pectin lyase (PL), was also studied. Time course analysis of PG II digestion of P41 revealed that JIM5 epitopes were rapidly degraded, but a low level of PAM1 and JIM7 epitopes existed even after extensive digestion, indicating that some HG domains were more resistant to cleavage by PG II. The chromatographic separation of fragments produced by the complete digestion of P41 by pectin lyase indicated that a very restricted population of fragments contained the PAM1 epitope while a (1-->4)-beta-D-galactan epitope occurring on the side chains of pectic polysaccharides was recovered in a broad range of fractions.

Quantification of the amount of galacturonic acid residues in blocksequences in pectin homogalacturonan by enzymatic fingerprinting with exo- and endo-polygalacturonase II from Aspergillus niger.

A method to determine the amount of galacturonic acid in blocksequence (BS) in pectin homogalacturonan (HG) is described. The method is based on a combination of endopolygalacturonase II (endo-PG II) and exopolygalacturonase (exo-PG) digestion followed by quantification of the liberated galacturonic acid monomer. The amount of monomers released is directly related to the amount of non-esterified galacturonic acid units located between two other non-esterified galacturonic acids units on the HG chain. The amount released for exo-PG digestion only corresponds to the BS located at the non-reducing end of the polymer. The difference between total- and exo-BS was calculated to be the amount of endo-BS located either within or on the reducing end of the HG. Three series of model pectins obtained by de-esterification of a high-ester pectin with either plant pectin methyl-esterase (p-PME, P-series), fungal pectin methyl-esterase (f-PME, F-series) and chemical de-esterification using base (B-series) were analysed and compared with a fully de-esterified pectic acid sample obtained from the same raw material. Clear differences for the increase of the amounts of blocksequence could be seen between de-esterification of the P- and F-series samples supporting a blockwise and a homogenous de-esterification mechanism, respectively. f-PME and base treatment showed only minor differences in the increase of galacturonic acid units in BS, despite differences seen in their methyl-esterification pattern. Differences between the amounts of galacturonic acid located in exo- and endo-BS, provided evidence for the need of a certain start side or blocklength for p-PME to de-esterify blockwise.

[Novel Bis-sulfonic Acid Esters with Cytostatic Activity (author's transl)]. / Neue Bis-sulfonsäureester mit zytostatischer wirkung

The introduction of electron-withdrawing groups into the group R of piposulfan analogs R--SO2--O--X--O--SO2--R substantially increases their antileukemic activity in animal tests (leukemia L 1210). The central moiety X can be varied considerably (provided it contains amide groups) without appreciable loss of activity. A number of busulfan analogs as well as busulfan itself proved to be practically inactive against murine leukemia L 1210. Among a total of 122 bis-sulfonic acid esters tested 35 gave a survival time index of 150% or more after i.p. application and 5 after oral application.