Use of a Custom-Made Patellar Groove Replacement in an American Staffordshire Terrier Puppy with a Severe Bone Defect in the Femoral Trochlea Caused by Hematogenous Osteomyelitis.

An 8-month-old male American Staffordshire terrier was referred for a no-weightbearing lameness of the right pelvic limb, hyperthermia, lethargy and inappetence. Two months before, endocarditis was diagnosed and treated in another veterinary hospital. Orthopedic, radiographic and tomographic examinations revealed a bone sequestrum of 4 × 1.4 cm and active periosteal reaction of the caudo-lateral cortical in the metaphysis and the distal third of the right femoral diaphysis, medullary osteolysis and interruption of the cranio-medial cortical profile, with involvement of the femoral trochlea leading to a secondary medial patella luxation. Hematogenous osteomyelitis was the suspected diagnosis. Once skeletally mature, after 4 months from surgical debridement and aggressive antibiotic therapy against Klebsiella oxytoca revealed by a bacteriological exam, the patient underwent prosthetic surgery for the application of a custom-made patellar groove replacement (PGR) to fill the bone defect and restore the femoral trochlea surface. Despite the serious injury that afflicted the right pelvic limb, the surgery had satisfactory outcomes until the last 18-month postoperative follow up.

Patient-Specific 3D-Printed Osteotomy Guides and Titanium Plates for Distal Femoral Deformities in Dogs with Lateral Patellar Luxation.

The aim of this study was to describe the diagnosis and treatment of grade IV lateral patellar luxation (LPL) in two adult large breed dogs with complex femoral deformities using patient-specific three-dimensionally (3D) printed osteotomy guides and implants. Computed tomography (CT) scans were obtained for virtual surgical planning (VSP) using computer-aided design (CAD) software, which allowed for 3D reconstruction and manipulation of the femoral deformities, providing a preoperative view of the correction. Of the two patients, one was affected bilaterally and the other unilaterally, but both dogs were from the same litter. Therefore, the healthy femur of the unilaterally affected patient was used as the physiological reference for the virtual surgical correction. Three distal femoral trapezoid osteotomies (DF-TO) followed by reduction and internal fixation with plates were performed using patient-specific 3D-printed osteotomy guides and implants. This type of osteotomy permitted correction of procurvatum in all the femurs to increase knee extension, raise the dog's lumbar spine and correct the kyphosis. Preoperative, expected and postoperative femoral angles were compared to evaluate the efficacy of virtual surgical planning and the outcome of surgical correction. Radiographic follow-up, passive range of motion and functional recovery were recorded. There were no major complications requiring revision surgery. Significant clinical improvement was observed in both patients. This study suggests that the treatment used represents a viable surgical alternative to restore limb alignment in patients with complex femoral deformities.

Distal femoral osteotomy using a novel deformity reduction device.

Distal femoral osteotomy is a surgical procedure used to correct patellar luxation, secondary to a femoral deformity. A distal femoral osteotomy using the tibial plateau levelling osteotomy-jig to temporarily provide stability of the distal femoral osteotomy, maintaining limb alignment in the frontal and axial planes prior to internal plate fixation of the osteotomy, has been described. This report describes a novel jig named Deformity Reduction Device (DRD). This device was developed with the specific aim of increasing precision and predictability during corrective osteotomy execution in order to be consistent with the preoperative planning. The distal femoral osteotomy DRD-assisted procedure is described in detail, discussing the theoretical and practical principles of the application.