Celiac Disease: Risks of Cross-Contamination and Strategies for Gluten Removal in Food Environments.

Celiac disease (CD) is the chronic immune-mediated enteropathy of the small bowel, manifesting when exposure to gluten occurs in genetically predisposed individuals. Nowadays, the only treatment considered safe for CD is a gluten-free diet (GFD). However, one of the problems faced by celiac patients is the cross-contamination of gluten-free food when preparing meals, in addition to utensils, surfaces and equipment. This study aimed to evaluate cross-contamination in gluten-free products and strategies for removing gluten from cross-contamination in cooking environments. The selection of papers for this integrative review was carried out by searching different databases. Gluten cross-contamination is a global concern for celiac patients in food environments. Although some practices are positive, such as gluten labeling on processed food in several countries, it is crucial to promote good practices in food services around the world. Only a few studies showed effective results in removing gluten from surfaces and utensils; furthermore, sampling was limited, making it difficult to identify appropriate procedures to reduce cross-contamination. The variation in contamination in different kitchen environments also highlighted that celiac patients must continue paying attention to the methods used to prepare gluten-free food. More research is needed, especially into methods of removing gluten from surfaces and utensils, to ensure food safety for celiac patients in many food environments.

Carvacrol-loaded nanoemulsions produced with a natural emulsifier for lettuce sanitization.

Carvacrol is an antimicrobial agent that shows potential for eliminating microorganisms in vegetables, increasing food safety. However, intense odor and low water solubility of carvacrol are limiting factors for its application for fresh vegetables sanitization, which can be overcome by nanotechnology. Two different nanoemulsions containing carvacrol (11 mg/mL) were developed by probe sonication: carvacrol-saponin nanoemulsion (CNS) and carvacrol-polysorbate 80 nanoemulsion (CNP). Formulations presented appropriate droplet sizes (from 74.7 nm to 168.2 nm) and high carvacrol encapsulation efficiency (EE) (from 89.5 % to 91.5 %). CNS showed adequate droplet size distribution (PDI < 0.22) and high zeta potential values (around -30 mV) compared to CNP, with saponin chosen for the following experiments. Carvacrol nanoemulsions presented Bacterial Inactivation Concentration (BIC) against the Salmonella cocktail from 5.51 to 0.69 mg/mL and for the E. coli cocktail from 1.84 to 0.69 mg/mL. Among all tested nanoemulsions, CNS1 presented the lowest BIC (0.69 mg/mL) against both bacterial cocktails. Damage to bacterial cells in lettuce treated with nanoemulsion was confirmed by scanning electron microscopy. For lettuce sanitization, CNS1 showed a similar effect to unencapsulated carvacrol, with a high bacterial reduction (>3 log CFU/g) after lettuce immersion for 15 min at 2 × BIC. Using the same immersion time, the CNS1 (2 × BIC) demonstrated equal or better efficacy in reducing both tested bacterial cocktails (>3 log CFU/g) when compared to acetic acid (6.25 mg/mL), citric acid (25 mg/mL), and sodium hypochlorite solution (150 ppm). Lettuce immersed in CNS1 at both concentrations (BIC and 2 × BIC) did not change the color and texture of leaves, while the unencapsulated carvacrol at 2 × BIC darkened them and reduced their firmness. Consequently, carvacrol-saponin nanoemulsion (CNS1) proved to be a potential sanitizer for lettuce.