Implementing enhanced extracorporeal membrane oxygenation for CPR (ECPR) in the emergency department.

Refractory out-of-hospital cardiac arrest (OHCA) has a very poor prognosis, with survival rates at around 10%. Extracorporeal membrane oxygenation (ECMO) for patients in refractory arrest, known as ECPR, aims to provide perfusion to the patient whilst the underlying cause of arrest can be addressed. ECPR use has increased substantially, with varying survival rates to hospital discharge. The best outcomes for ECPR occur when the time from cardiac arrest to implementation of ECPR is minimised. To reduce this time, systems must be in place to identify the correct patient, expedite transfer to hospital, facilitate rapid cannulation and ECMO circuit flows. We describe the process of activation of ECPR, patient selection, and the steps that emergency department clinicians can utilise to facilitate timely cannulation to ensure the best outcomes for patients in refractory cardiac arrest. With these processes in place our survival to hospital discharge for OHCA patients is 35%, with most patients having a good neurological function.

Platelet Adhesion and Activation in an ECMO Thrombosis-on-a-Chip Model.

Use of extracorporeal membrane oxygenation (ECMO) for cardiorespiratory failure remains complicated by blood clot formation (thrombosis), triggered by biomaterial surfaces and flow conditions. Thrombosis may result in ECMO circuit changes, cause red blood cell hemolysis, and thromboembolic events. Medical device thrombosis is potentiated by the interplay between biomaterial properties, hemodynamic flow conditions and patient pathology, however, the contribution and importance of these factors are poorly understood because many in vitro models lack the capability to customize material and flow conditions to investigate thrombosis under clinically relevant medical device conditions. Therefore, an ECMO thrombosis-on-a-chip model is developed that enables highly customizable biomaterial and flow combinations to evaluate ECMO thrombosis in real-time with low blood volume. It is observed that low flow rates, decelerating conditions, and flow stasis significantly increased platelet adhesion, correlating with clinical thrombus formation. For the first time, it is found that tubing material, polyvinyl chloride, caused increased platelet P-selectin activation compared to connector material, polycarbonate. This ECMO thrombosis-on-a-chip model can be used to guide ECMO operation, inform medical device design, investigate embolism, occlusion and platelet activation mechanisms, and develop anti-thrombotic biomaterials to ultimately reduce medical device thrombosis, anti-thrombotic drug use and therefore bleeding complications, leading to safer blood-contacting medical devices.