RESUMEN
Aqueous electrolytes composed of 0.1 M zinc bis(trifluoromethylsulfonyl)imide (Zn(TFSI)2) and acetonitrile (ACN) were studied using combined experimental and simulation techniques. The electrolyte was found to be electrochemically stable when the ACN V% is higher than 74.4. In addition, it was found that the ionic conductivity of the mixed solvent electrolytes changes as a function of ACN composition, and a maximum was observed at 91.7 V% of ACN although the salt concentration is the same. This behavior was qualitatively reproduced by molecular dynamics (MD) simulations. Detailed analyses based on experiments and MD simulations show that at high ACN composition the water network existing in the high water composition solutions breaks. As a result, the screening effect of the solvent weakens and the correlation among ions increases, which causes a decrease in ionic conductivity at high ACN V%. This study provides a fundamental understanding of this complex mixed solvent electrolyte system.
RESUMEN
Irreversible changes to the morphology of glassy carbon (GC) electrodes at potentials between 3.5 and 4.5 V vs Li/Li+ in propylene carbonate (PC) solvent containing lithium hexafluorophosphate (LiPF6) are reported. Analysis of cyclic voltammetry (CV) experiments in the range of 3.0 to 6.0 V shows that the capacitance of the electrochemical double-layer increased irreversibly beginning at potentials as low as 3.5 V. These changes resulted from nonfaradaic interactions, and were not due to oxidative electrochemical decomposition of the electrode and electrolyte, anion intercalation, nor caused by the presence of water, a common impurity in organic electrolyte solutions. Atomic force microscopy (AFM) images revealed that increasing the potential of a bare GC surface from 3.0 to 4.5 V resulted in a 6× increase in roughness, in good agreement with the changes in double-layer capacitance. Treating the GC surface via exposure to trichloromethylsilane vapors resulted in a stable double-layer capacitance between 3.0 and 4.5 V, and this treatment also correlated with less roughening. These results inform future efforts aimed at controlling surface composition and morphology of carbon electrodes.
RESUMEN
The voltammetry of Cu underpotential deposition (UPD) onto Pt dendrimer-encapsulated nanoparticles (DENs) containing an average of 147 Pt atoms (Pt(147)) is correlated to density functional theory (DFT) calculations. Specifically, the voltammetric peak positions are in good agreement with the calculated energies for Cu deposition and stripping on the Pt(100) and Pt(111) facets of the DENs. Partial Cu shells on Pt(147) are more stable on the Pt(100) facets, compared to the Pt(111) facets, and therefore, Cu UPD occurs on the 4-fold hollow sites of Pt(100) first. Finally, the structures of Pt DENs having full and partial monolayers of Cu were characterized in situ by X-ray absorption spectroscopy (XAS). The results of XAS studies are also in good agreement with the DFT-optimized models.
RESUMEN
Dendrimer-encapsulated nanoparticles (DENs) containing averages of 55, 147, and 225 Pt atoms immobilized on glassy carbon electrodes served as the electroactive surface for the underpotential deposition (UPD) of a Cu monolayer. This results in formation of core@shell (Pt@Cu) DENs. Evidence for this conclusion comes from cyclic voltammetry, which shows that the Pt core DENs catalyze the hydrogen evolution reaction before Cu UPD, but that after Cu UPD this reaction is inhibited. Results obtained by in situ electrochemical X-ray absorption spectroscopy (XAS) confirm this finding.
RESUMEN
Dendrimer-encapsulated Au nanoparticles comprised of an average of 147 atoms were synthesized and immobilized on a glassy carbon electrode. A one-atom-thick shell of Cu was added to the Au core by electrochemical underpotential deposition, and then this shell was replaced with Pt by galvanic exchange. The results indicate that this synthetic approach leads to well-defined core/shell nanoparticles <2 nm in diameter. The rates of oxygen reduction at the Au@Pt electrocatalysts were compared to Pt-only and Au-only, 147-atom dendrimer-encapsulated nanoparticles.
RESUMEN
The stability of Pd dendrimer-encapsulated nanoparticles (DENs) in air-, N(2)-, and H(2)-saturated aqueous solutions is reported. The DENs consisted of an average of 147 atoms per sixth-generation, poly(amidoamine) dendrimer. Elemental analysis and UV-vis spectroscopy indicate that there is substantial oxidation of the Pd DENs in the air-saturated solution, less oxidation in the N(2)-saturated solution, and no detectable oxidation when the DENs are in contact with H(2). Additionally, the stability improves when the DEN solutions are purified by dialysis to remove Pd(2+)-complexing ligands such as chloride. For the air- and N(2)-saturated solutions, most of the oxidized Pd recomplexes to the interiors of the dendrimers, and a lesser percentage escapes into the surrounding solution. The propensity of Pd DENs to oxidize so easily is a likely consequence of their small size and high surface energy.
