Environmental formaldehyde analysis by active diffusive sampling with a bundle of polypropylene porous capillaries followed by capillary zone electrophoretic separation and contactless conductivity detection.

Compared to other volatile carbonylic compounds present in outdoor air, formaldehyde (CH(2)O) is the most toxic, deserving more attention in terms of indoor and outdoor air quality legislation and control. The analytical determination of CH(2)O in air still presents challenges due to the low-level concentration (in the sub-ppb range) and its variation with sampling site and time. Of the many available analytical methods for carbonylic compounds, the most widespread one is the time consuming collection in cartridges impregnated with 2,4-dinitrophenylhydrazine followed by the analysis of the formed hydrazones by HPLC. The present work proposes the use of polypropylene hollow porous capillary fibers to achieve efficient CH(2)O collection. The Oxyphan fiber (designed for blood oxygenation) was chosen for this purpose because it presents good mechanical resistance, high density of very fine pores and high ratio of collection area to volume of the acceptor fluid in the tube, all favorable for the development of air sampling apparatus. The collector device consists of a Teflon pipe inside of which a bundle of polypropylene microporous capillary membranes was introduced. While the acceptor passes at a low flow rate through the capillaries, the sampled air circulates around the fibers, impelled by a low flow membrane pump (of the type used for aquariums ventilation). The coupling of this sampling technique with the selective and quantitative determination of CH(2)O, in the form of hydroxymethanesulfonate (HMS) after derivatization with HSO(3)(-), by capillary electrophoresis with capacitively coupled contactless conductivity detection (CE-C(4)D) enabled the development of a complete analytical protocol for the CH(2)O evaluation in air.

Measurements of biogenic hydrocarbons and carbonyl compounds emitted by trees from temperate warm Atlantic rainforest, Brazil.

This study is part of a three-year project on biogenic volatile organic compound (VOC) emissions from trees of the temperate warm Atlantic rainforest found in the metropolitan area of Sao Paulo City (MASP). No study of VOC emission rates from plant species has been carried out in the temperate warm Atlantic rainforest of Brazil prior to this work. Eleven species were selected (Alchornea sidifolia, Cupania oblongifolia, Cecropia pachystachia, Syagrus romanzoffiana, Casearia sylvestris, Machaerium villosum, Trema micrantha, Croton floribundus, Myrcia rostrata, Solanum erianthum and Ficus insipida) and some of them were studied in urban, sub-urban and forest areas inside the MASP in order to evaluate biogenic VOC composition at sites characterized by different emission sources. Biogenic VOC emissions were determined by placing branches of plants in a dynamic enclosure system, an all-Teflon cuvette, and by sampling the compounds in the air leaving the cuvette. Pre-concentration using adsorbents to retain the VOC, followed by GC-MS after thermal desorption of the sample, was employed to determine the amount of biogenic hydrocarbons. The collection of carbonyl compounds on a 2,4-dinitrophenylhydrazine coated silica followed by HPLC-UV was used to analyze low molecular weight carbonyl compounds. Emission rates of isoprene, alpha-pinene, camphene and limonene ranged from 0.01 to 2.16 microg C h(-1) g(-1) and emission rates of aldehydes (C(2)-C(6)), acrolein, methacrolein and 2-butanone ranged from 1.5 x 10(-2) to 2.3 micro g C h(-1) g (-1). Ambient and leaf temperatures, relative humidity, light intensity, O(3) and NO(x) levels in the local atmosphere were monitored during experiments. It was possible to identify different biogenic VOCs emitted from typical plants of temperate warm Atlantic rainforest. The emission rates were reported as a function of the type of site investigated and were only provided for compounds for which quantification was feasible. Other biogenic compounds were only identified.

Dioxins and furans in the atmosphere of São Paulo City, Brazil.

Air samples were collected simultaneously at three urban sites in São Paulo City, Brazil, in winter, spring, summer and fall (in 2000 and 2001). Andersen PUF samplers were used for gas and particles sequential sampling. Samples were analyzed using HRGC/HRMS according to US EPA Method 8290. The greater metropolitan area of São Paulo is the largest industrialized region of Latin America and has a highly polluted atmosphere. Concentrations of dioxins and furans, which are well-known toxic chemicals, ranged from 1.14 pg m-3 to 13.8 pg m-3 (0.047 pg I-TEQ m-3 to 0.751 pg I-TEQ m-3). Principal component analysis showed that all the variables are highly correlated with one another except the 2,3,7,8-TCDD one. This is consistent with the similar concentration profiles observed for the tetra, penta, hexa, hepta and octa-homologous groups of the three sampling sites studied. At all sites, the most abundant compounds were the hepta and octa congeners. The 2,3,4,7,8-PeCDF accounted for 37-46% of the total toxicity and the 2,3,7,8-TCDD accounted for 7-16%. Highest mass concentrations of PCDD/Fs were found in the site where there is influence of industrial activities and heavy vehicular traffic fueled by gasohol, diesel, and ethanol.

Artifact evidence in carbonyl compound sampling using the enclosure technique with cuvette system.

Biogenic hydrocarbon emission rates from individual plant species have been estimated experimentally placing small plants or branches in enclosures and measuring the emission rates of the compounds. All-Teflon chambers (cuvettes) where air samples are drawn through tubes packed with adsorbents, have been commonly used for plant enclosure. Sampling of carbonyl compounds emitted from plants has been done using 2,4-dinitrophenylhydrazine coated particles and the derivative carbonyl compounds have been analyzed by HPLC-UV. In this work, the enclosure technique using a cuvette for measurements of carbonyl compound emissions from plants was evaluated. Blank measurements in an empty cuvette have revealed quite different results for experiments performed under laboratory and field conditions. Rigorous univariate statistical analysis of the data obtained indicate that the analytical procedure to determine carbonyl compounds at trace levels in emission samples using the cuvette may lead to positive artifacts during field sampling. This analysis applied to laboratory measurements showed no difference in the results for the cuvette and external lines. Multivariate statistical calculations point out that solar light intensity accounts for the high carbonyl compound levels, especially for acetaldehyde, in the empty cuvette.

Gas chromatographic-mass spectrometric method for quantification of 3-chloro-4-(dichloromethyl)-5-hydroxy-2[5H]-furanone in chlorinated water samples.

A method for the determination of 3-chloro-4-(dichloromethyl)-5-hydroxy-2[5H]-furanone (MX), in drinking water by GC-MS with a limit of detection of 3.0 microg/l and a limit of quantification of 7.0 microg/l is presented. Clean-up by SPE and extraction of water samples with dichloromethane were carried out before the preconcentration of MX, which was derivatized directly in the injector of the GC, and the MX trimethylsilyl derivative was identified and quantitatively determined by MS.