Challenge of uncontrolled enteroatmospheric fistulas.

INTRODUCTION: With the popularization of damage control surgery and the use of the open abdomen, a new permutation of fistula arose; the enteroatmospheric fistula (EAF), an opening of exposed intestine spilling uncontrollably into the peritoneal cavity. EAF is the most devastating complication of the open abdomen. We describe and analyze a single institution's experience in controlling high-output EAFs in patients with peritonitis. METHODS: We analyzed 189 consecutive procedures to achieve and maintain definitive control of 24 EAFs in 13 patients between 2006 and 2017. EAFs followed surgery for either trauma (seven patients) or non-traumatic abdominal conditions (six patients). All procedures were mapped onto an operative timeline and analyzed for: success in achieving definitive control, number of reoperations, and feasibility of bedside procedures in the surgical intensive care unit. The end point was controlled enteric drainage through a healed abdominal wound. RESULTS: There was a mean delay of 8.5 days (range 2-46 days) from the index operation until the EAF was identified. Most EAFs required several attempts (mean: 2.7 per patient, range 1-7) until definitive control was achieved. Multiple reoperations were then required to maintain control (mean: 13). While the most effective techniques were endoscopic (1) and proximal diversion (1), these were applicable only in select circumstances. A 'floating stoma' where the fistula edges are sutured to an opening in a temporary closure device, while technically effective, required multiple reoperations. Tube drainage through a negative pressure dressing (tube vac) required the most maintenance usually through bedside procedures. Primary closure almost always failed. Twelve of the 13 patients survived. CONCLUSION: An EAF is a highly complex surgical challenge. Successful source control of the potentially lethal ongoing peritonitis requires tenacity and tactical flexibility. The appropriate control technique is often found by trial and error and must be creatively tailored to the individual circumstances of the patient.

Radiographic and metabolic response rates following image-guided stereotactic radiotherapy for lung tumors.

PURPOSE: To evaluate radiographic and metabolic response after stereotactic body radiotherapy (SBRT) for early lung tumors. MATERIALS AND METHODS: Thirty-nine tumors were treated prospectively with SBRT (dose=48-60 Gy, 4-5 Fx). Thirty-six cases were primary NSCLC (T1N0=67%; T2N0=25%); three cases were solitary metastases. Patients were followed using CT and PET at 6, 16, and 52 weeks post-SBRT, with CT follow-up thereafter. RECIST and EORTC criteria were used to evaluate CT and PET responses. RESULTS: At median follow-up of 9 months (0.4-26), RECIST complete response (CR), partial response (PR), and stable disease (SD) rates were 3%, 43%, 54% at 6 weeks; 15%, 38%, 46% at 16 weeks; 27%, 64%, 9% at 52 weeks. Mean baseline tumor volume was reduced by 46%, 70%, 87%, and 96%, respectively at 6, 16, 52, and 72 weeks. Mean baseline maximum standardized uptake value (SUV) was 8.3 (1.1-20.3) and reduced to 3.4, 3.0, and 3.7 at 6, 16, and 52 weeks after SBRT. EORTC metabolic CR/PR, SD, and progressive disease rates were 67%, 22%, 11% at 6 weeks; 86%, 10%, 3% at 16 weeks; 95%, 5%, 0% at 52 weeks. CONCLUSIONS: SBRT yields excellent RECIST and EORTC based response. Metabolic response is rapid however radiographic response occurs even after 1-year post treatment.

Identification of chondrocyte proliferation following laser irradiation, thermal injury, and mechanical trauma.

BACKGROUND AND OBJECTIVE: Cartilage has a limited regenerative capacity, and there are a lack of reliable techniques and methods to stimulate growth of new tissue to treat degenerative diseases and trauma. This study focused on identifying chondrocyte cell proliferation in ex vivo cartilage tissue following heating Nd:YAG laser using whole-mount analysis and flow cytometry, and compared findings with results produced by contact, and water bath heating methods, mechanical injury, and the addition of transforming growth factor-beta (TGF-beta). STUDY DESIGN/MATERIALS AND METHODS: Ex vivo rabbit nasal septal cartilages were either irradiated with an Nd:YAG laser (lambda = 1.32 microm, 2-16 seconds, 6 W/cm(2)), heated by immersion in a warm saline bath, heated by direct contact with a metal rod, or mechanically damaged by scoring with a scalpel or crushing. After treatment, specimens were incubated for 7 or 14 days in growth media containing 10 microM bromodeoxyuridine (BrdU). Additional specimens were cultured with both BrdU and TGF-beta. Both whole-mount BrdU-double-antibody detection techniques and flow cytometry were used to determine the presence of DNA replication as a marker of proliferation. RESULT: An annular region of regenerating chondrocytes was identified surrounding the laser irradiation zone in whole-mount tissue specimens, and the diameter of this region increased with irradiation time. Using whole-mount analysis, no evidence of chondrocyte DNA replication was observed in tissues heated using non-laser methods, grown in TGF-beta, or mechanically traumatized. In contrast, flow cytometry identified the presence of BrdU-positive cells in the S-phase of the cell cycle (synthesis of DNA) for all protocols, indicating chondrocyte proliferation. The percentage of cells that are in S-phase increased with irradiation time. CONCLUSION: These data provide evidence that laser irradiation, along with other thermal and mechanical treatments, causes a proliferative response in chondrocytes, and this is observed ex vivo in the absence of cellular and humoral repair mechanisms. The advantage of using optical methods to generate heat in cartilage is that microspot injuries could be created in tissue and scanned across surfaces in clinical applications.

Clinical implications of different image reconstruction parameters for interpretation of whole-body PET studies in cancer patients.

UNLABELLED: The standardized uptake value (SUV) is the most commonly used parameter to quantify the intensity of radiotracer uptake in tumors. Previous studies suggested that measurements of (18)F-FDG accumulation in tissue might be affected by the image reconstruction method, but the clinical relevance of these findings has not been assessed. METHODS: Phantom studies were performed and clinical whole-body (18)F-FDG PET images of 85 cancer patients were analyzed. All images were reconstructed using either filtered backprojection (FBP) with measured attenuation correction (MAC) or iterative reconstruction (IR) with segmented attenuation correction (SAC). In a subset of 15 patients, images were reconstructed using all 4 combinations of IR+SAC, IR+MAC, FBP+SAC, and FBP+MAC. For phantom studies, a sphere containing (18)F-FDG was placed in a water-filled cylinder and the activity concentration of that sphere was measured in FBP and IR reconstructed images using all 4 combinations. Clinical studies were displayed simultaneously and identical regions of interest (ROIs, 50 pixels) were placed in liver, urinary bladder, and tumor tissue in both image sets. SUV max (maximal counts per pixel in ROI) and SUV avg (average counts per pixel) were measured. RESULTS: In phantom studies, measurements from FBP images underestimated the true activity concentration to a greater degree than those from IR images (20% vs. 5% underestimation). In patient studies, SUV derived from FBP images were consistently lower than those from IR images in both normal and tumor tissue: Tumor SUV max with IR+SAC was 9.6 +/- 4.5, with IR+MAC it was 7.7 +/- 3.5, with FBP+MAC it was 6.9 +/- 3.0, and with FBP+SAC it was 8.6 +/- 4.1 (all P < 0.01 vs. IR+SAC). Compared with IR+SAC, SUV from FBP+MAC images were 25%-30% lower. Similar discrepancies were noted for liver and bladder. Discrepancies between measurements became more apparent with increasing (18)F-FDG concentration in tissue. CONCLUSION: SUV measurements in whole-body PET studies are affected by the applied methods for both image reconstruction and attenuation correction. This should be considered when serial PET studies are done in cancer patients. Moreover, if SUV is used for tissue characterization, different cutoff values should be applied, depending on the chosen method for image reconstruction and attenuation correction.

Measurement of the elastic modulus of rabbit nasal septal cartilage during Nd:YAG (lambda = 1.32 microm) laser irradiation.

BACKGROUND AND OBJECTIVES: The objective of this study was to quantitatively measure changes in the elastic moduli of rabbit nasal septal cartilage during laser heating. While the efficacy of laser cartilage reshaping has been established for use in nasal surgery, few studies have investigated the temperature-dependent viscoelastic behavior of cartilage. STUDY DESIGN/MATERIALS AND METHODS: Cyclic force versus displacement curves were generated during the Nd:YAG laser (lambda = 1.32 microm, 10 second exposure time, 21.22 W/cm2) irradiation of cartilage specimens secured in cantilevered geometry. Samples were irradiated three times with 30 second cooling intervals between each laser exposure. Measurements were recorded before, during, and after laser irradiation, and then following complete rehydration in normal saline (NS) for 1 hour at 25 degrees C. Elastic modulus was calculated assuming linear viscoelastic behavior. RESULTS: The elastic modulus in native tissue decreased during and after successive laser exposures from about 6 to 3.5 MPa. After rehydration, the modulus returned to near-baseline value. Surface temperature reached a maximum of 65 degrees C. CONCLUSIONS: The laser irradiation of cartilage using parameters similar to those used in reshaping does not produce significant irreversible changes in the mechanical properties of the tissue. Measurement of the elastic modulus is an effective means of characterizing alterations in cartilage mechanical behavior during and after laser heating.

The effect of optical design on micromanipulator spot size using CO2 laser irradiation.

OBJECTIVE: The study goal was to compare the laser spot size created using reflective and refractive micromanipulators with a CO(2) laser and to determine the sensitivity of spot size to laser power. STUDY DESIGN AND SETTING: A CO(2) laser and operating microscope (400-mm focal length) was coupled to either a reflective (Cassegrain-like) or refractive micromanipulator. Laser spot size was determined by measuring the region of ablation created by laser irradiation of wood (dry tongue depressors), exposed photographic film, and agar gel using optical micrometry. Laser power varied from 0.5 to 20 W with pulse durations of 0.1 and 0.5 second. RESULTS: The reflective micromanipulator demonstrated overall smaller spot sizes for a given laser power and lower incremental change in spot size with increasing power. The reflective design demonstrated less sensitivity to increases in laser power. CONCLUSIONS: Micromanipulator optical design can result in significant differences in laser spot size. The reflective device used in this study demonstrated less sensitivity to increasing laser power.