RESUMEN
Hard-scattered parton probes produced in collisions of large nuclei indicate large partonic energy loss, possibly with collective produced-medium response to the lost energy. We present measurements of π^{0} trigger particles at transverse momenta p{T}{t}=4-12 GeV/c and associated charged hadrons (p{T}{a}=0.5-7 GeV/c) vs relative azimuthal angle ΔÏ in Au+Au and p+p collisions at sqrt[s{NN}]=200 GeV. The Au+Au distribution at low p{T}{a}, whose shape has been interpreted as a medium effect, is modified for p{T}{t}<7 GeV/c. At higher p{T}{t}, the data are consistent with unmodified or very weakly modified shapes, even for the lowest measured p{T}{a}, which quantitatively challenges some medium response models. The associated yield of hadrons opposing the trigger particle in Au+Au relative to p+p (I{AA}) is suppressed at high p{T} (I{AA}≈0.35-0.5), but less than for inclusive suppression (R{AA}≈0.2).
RESUMEN
The production of e+ e- pairs for m(e+ e-)<0.3 GeV/c2 and 1
RESUMEN
The momentum distribution of electrons from semileptonic decays of charm and bottom quarks for midrapidity |y|<0.35 in p+p collisions at square root of s=200 GeV is measured by the PHENIX experiment at the Relativistic Heavy Ion Collider over the transverse momentum range 2
RESUMEN
The double helicity asymmetry in neutral pion production for pT=1 to 12 GeV/c was measured with the PHENIX experiment to access the gluon-spin contribution, DeltaG, to the proton spin. Measured asymmetries are consistent with zero, and at a theory scale of micro2=4 GeV2 a next to leading order QCD analysis gives DeltaG[0.02,0.3]=0.2, with a constraint of -0.7
RESUMEN
For Au + Au collisions at 200 GeV, we measure neutral pion production with good statistics for transverse momentum, pT, up to 20 GeV/c. A fivefold suppression is found, which is essentially constant for 5 < pT < 20 GeV/c. Experimental uncertainties are small enough to constrain any model-dependent parametrization for the transport coefficient of the medium, e.g., q in the parton quenching model. The spectral shape is similar for all collision classes, and the suppression does not saturate in Au + Au collisions.
RESUMEN
Neutral pion transverse momentum (p(T)) spectra at midrapidity (|y| less than or approximately 0.35) were measured in Cu+Cu collisions at sqrt[s(NN)]=22.4, 62.4, and 200 GeV. Relative to pi_(0) yields in p+p collisions scaled by the number of inelastic nucleon-nucleon collisions (N(coll) the pi_(0) yields for p(T) more than or approximately 2 GeV/c in central Cu+Cu collisions are suppressed at 62.4 and 200 GeV whereas an enhancement is observed at 22.4 GeV. A comparison with a jet-quenching model suggests that final state parton energy loss dominates in central Cu+Cu collisions at 62.4 and 200 GeV, while the enhancement at 22.4 GeV is consistent with nuclear modifications in the initial state alone.
RESUMEN
Yields for J/psi production in Cu+Cu collisions at sqrt s_NN=200 GeV have been measured over the rapidity range |y|<2.2 and compared with results in p+p and Au+Au collisions at the same energy. The Cu+Cu data offer greatly improved precision over existing Au+Au data for J/psi production in collisions with small to intermediate numbers of participants, in the range where the quark-gluon plasma transition threshold is predicted to lie. Cold nuclear matter estimates based on ad hoc fits to d+Au data describe the Cu+Cu data up to N_part approximately 50, corresponding to a Bjorken energy density of at least 1.5 GeV/fm(3).
RESUMEN
Reaction mechanism analyses performed with a 4pi detector for the systems 208Pb + Ge, 238U + Ni and 238U + Ge, combined with analyses of the associated reaction time distributions, provide us with evidence for nuclei with Z=120 and 124 living longer than 10(-18) s and arising from highly excited compound nuclei. By contrast, the neutron deficient nuclei with Z=114 possibly formed in 208Pb + Ge reactions have shorter lifetimes, close to or below the sensitivity limit of the experiment.
RESUMEN
J/psi production in p+p collisions at square root s=200 GeV has been measured by the PHENIX experiment at the BNL Relativistic Heavy Ion Collider over a rapidity range of -2.2
RESUMEN
The PHENIX experiment at the BNL Relativistic Heavy Ion Collider (RHIC) has measured J/psi production for rapidities -2.2
RESUMEN
Differential measurements of elliptic flow (v2) for Au+Au and Cu+Cu collisions at sqrt[sNN]=200 GeV are used to test and validate predictions from perfect fluid hydrodynamics for scaling of v2 with eccentricity, system size, and transverse kinetic energy (KE T). For KE T identical with mT-m up to approximately 1 GeV the scaling is compatible with hydrodynamic expansion of a thermalized fluid. For large values of KE T mesons and baryons scale separately. Quark number scaling reveals a universal scaling of v2 for both mesons and baryons over the full KE T range for Au+Au. For Au+Au and Cu+Cu the scaling is more pronounced in terms of KE T, rather than transverse momentum.
RESUMEN
The momentum distribution of electrons from decays of heavy flavor (charm and bottom) for midrapidity absolute value of y < 0.35 in p + p collisions at square root of s = 200 GeV has been measured by the PHENIX experiment at the BNL Relativistic Heavy Ion Collider over the transverse momentum range 0.3 < pT < 9 GeV/c. Two independent methods have been used to determine the heavy-flavor yields, and the results are in good agreement with each other. A fixed-order-plus-next-to-leading-log perturbative QCD calculation agrees with the data within the theoretical and experimental uncertainties, with the data/theory ratio of 1.71+/-0.02stat+/-0.18sys for 0.3 < pT < 9 GeV/c. The total charm production cross section at this energy has also been deduced to be sigma cc = 567+/-57stat+/-193sys microb.
RESUMEN
Isotopic effects in the fragmentation of excited target residues following collisions of 12C on (112,124)Sn at incident energies of 300 and 600 MeV per nucleon were studied with the INDRA 4pi detector. The measured yield ratios for light particles and fragments with atomic number Z < or = 5 obey the exponential law of isotopic scaling. The deduced scaling parameters decrease strongly with increasing centrality to values smaller than 50% of those obtained for the peripheral event groups. Symmetry-term coefficients, deduced from these data within the statistical description of isotopic scaling, are near gamma = 25 MeV for peripheral and gamma < 15 MeV for central collisions.
RESUMEN
Quantum tunnelling through a potential barrier (such as occurs in nuclear fusion) is very sensitive to the detailed structure of the system and its intrinsic degrees of freedom. A strong increase of the fusion probability has been observed for heavy deformed nuclei. In light exotic nuclei such as 6He, 11Li and 11Be (termed 'halo' nuclei), the neutron matter extends much further than the usual nuclear interaction scale. However, understanding the effect of the neutron halo on fusion has been controversial--it could induce a large enhancement of fusion, but alternatively the weak binding energy of the nuclei could inhibit the process. Other reaction channels known as direct processes (usually negligible for ordinary nuclei) are also important: for example, a fragment of the halo nucleus could transfer to the target nucleus through a diminished potential barrier. Here we study the reactions of the halo nucleus 6He with a 238U target, at energies near the fusion barrier. Most of these reactions lead to fission of the system, which we use as an experimental signature to identify the contribution of the fusion and transfer channels to the total cross-section. At energies below the fusion barrier, we find no evidence for a substantial enhancement of fusion. Rather, the (large) fission yield is due to a two-neutron transfer reaction, with other direct processes possibly also involved.
RESUMEN
Tensile and fracture tests were conducted on thin panels of a fiber-reinforced bioabsorbable material. The composites were made of polycarbonate matrix and calcium phosphate fibers. Both matrix and fibers were bioabsorbable orthopaedic biomaterials. The fibers were short and randomly distributed. The properties were compared for composites with and without a coating of methane on the fibers. Composites with the methane coating had a higher elastic modulus, a higher proportional limit, but a lower load at failure on pre-cracked panels. Electron microscopy showed that the coating resulted in a better bond between the matrix and the fiber.
RESUMEN
Tyrosine-derived polycarbonates are a new class of degradable polymers developed for orthopedic applications. In this study the long-term (48 week) in vivo degradation kinetics and host bone response to poly(DTE carbonate) and poly(DTH carbonate) were investigated using a canine bone chamber model. Poly(L-lactic acid) (PLA) served as a control material. Two chambers of each test material were retrieved at 6-, 12-, 24-, and 48-week time points. Tyrosine-derived polycarbonates were found to exhibit degradation kinetics comparable to PLA. Each test material lost approximately 50% of its initial molecular weight (Mw) over the 48-week test period. Poly(DTE carbonate) and poly(DTH carbonate) test chambers were characterized by sustained bone ingrowth throughout the 48 weeks. In contrast, bone ingrowth into the PLA chambers peaked at 24 weeks and dropped by half at the 48-week time point. A fibrous tissue layer was found surrounding the PLA implants at all time points. This fibrous tissue layer was notably absent at the interface between bone and the tyrosine-derived polycarbonates. Histologic sections revealed intimate contact between bone and tyrosine-derived polycarbonates. From a degradation-biocompatibility perspective, the tyrosine-derived polycarbonates appear to be comparable, if not superior, to PLA in this canine bone chamber model.
Asunto(s)
Materiales Biocompatibles , Biopolímeros , Huesos , Lactatos , Ácido Láctico , Polímeros , Tirosina/análogos & derivados , Animales , Huesos/citología , Perros , Fémur , Cinética , Masculino , Poliésteres , Prótesis e Implantes , Factores de TiempoRESUMEN
Calcium phosphate fibers designed for reinforcement of bioabsorbable fracture fixation devices were evaluated for their properties upon annealing. The composition of these fibers were 54% PO4, 27% Ca, 12% ZnO, 2.5% NaPO3, and 4.5% Fe2O3, and they were either not annealed, annealed at 250 degrees C, or annealed at 420 degrees C. Chemical degradation, mass loss, and morphology upon degradation were studied. Chemical degradation was performed in Tris-buffered HCl, while mass loss and morphologic studies were performed in both physiologic and nonphysiologic solutions. The results showed that degradation rates for fibers were inversely proportional to the annealing temperature. Mass loss analysis of fibers immersed in the two physiologic solutions (calf serum and simulated body fluid) revealed little change in fiber diameter up to 60 days. Morphologic examination revealed little change in fibers immersed in the two physiologic solutions until 60 days, after which thin shells were found to be peeling off the outer coating of the fiber. Samples in tris-buffered HCl revealed a dramatic difference in mode of degradation among the three fibers. Fibers not annealed and those annealed at lower temperatures underwent a delaminating type of degradation that appeared to destroy the overall integrity of the fiber, whereas fibers annealed at 420 degrees C underwent crater-like deterioration in which the overall alignment of the fiber remained intact. It is therefore concluded that annealing fibers at higher temperatures also undergo a mode of degradation that allows them to maintain their structural integrity. Although annealing fibers close to glass transition temperature may produce an initially weaker fiber, chemical and physical degradation occur much slower, making these fibers most suitable for reinforcement of biodegradable implants.