Exploiting the Synergistic Electronic Interaction between Pt-Skin Wrapped Intermetallic PtCo Nanoparticles and Co-N-C Support for Efficient ORR/EOR Electrocatalysis in a Direct Ethanol Fuel Cell.

The development of low-Pt catalysts with high activity and durability is critical for fuel cells. Here, Pt-skin wrapped sub-5 nm PtCo intermetallic nanoparticles are successfully mounted on single atom Co-N-C support by exploiting the barrier effect of Co-anchor. According to a collaborative experimental and computational investigation, the increased oxygen reduction reaction activity of PtCo/Co-N-C arises from the direct electron transfer from PtCo to Co-N-C, and the resulting optimal d-band center of Pt. Owing to such unique electronic structure interaction and synergistic effect, the specific and mass activities of PtCo/Co-N-C are up to 4.20 mA cm-2 and 2.71 A mgPt-1 , respectively, with barely degraded stability after 40 000 CV cycles. The PtCo/Co-N-C also exhibits outstanding activity as an ethanol electrocatalyst. This work shows a new and effective route to boost the overall efficiency of direct ethanol fuel cells in acidic media by integrating intermetallic low-Pt alloys and single atom carbon support.

Bioprintable, Stiffness-Tunable Collagen-Alginate Microgels for Increased Throughput 3D Cell Culture Studies.

3D culture platforms with tunable stiffness have the potential to improve many applications, such as drug discovery, organoid studies, and stem cell differentiation. Both dimensionality and stiffness regulate crucial and relevant cellular processes. However, 3D culture models are often limited in throughput and difficult to adopt for widespread use. Here, we demonstrate an accessible 3D, stiffness-tunable tissue culture platform, based on an interpenetrating network of collagen-1 and alginate. When blended with polymers that induce phase separation, these networks can be bioprinted at microliter volumes, using standard liquid handling infrastructure. We demonstrate robust reproducibility in printing these microgels, consistent tunability of mechanical properties, and maintained viability of multiple printed cell types. To highlight the utility and importance of this system, we demonstrate distinct morphological changes to cells in culture, use the system to probe the role of matrix mechanics and soluble factors in a collagen contraction assay, and perform a prototype viability screen against a candidate chemotherapeutic, demonstrating stiffness-dependent responses.

Harvesting a 3D N-Doped Carbon Network from Waste Bean Dregs by Ionothermal Carbonization as an Electrocatalyst for an Oxygen Reduction Reaction.

Three-dimensional nitrogen-doped carbon (3D-NCN) has been synthesized via the ionothermal carbonization method using waste soybean dregs (SD) as the precursor. N2 adsorption/desorption isotherms show that the as-prepared 3D-NCN formed a hierarchically porous structure with a specific BET surface area of 1093.4 m² g-1 and a total pore volume of 1.77 cm³ g-1. The TEM images clearly show that graphene-like carbon sheets were formed on the edge of the networks. The characterization of the samples collected at different temperature indicated that salt melt plays the key role in the formation of the network structure and rich pores. When 3D-NCN is as electrocatalyst for ORR, it shows an onset potential of 0.945 V with a more positive half-wave potential (0.846 V), which is comparable to that of commercial Pt/C. In addition, the long-term cycle results show that the onset potential and half-wave potential only negatively shifted by 6 mV and 8 mV after 10,000 cycles respectively, which are smaller than those values of commercial Pt/C. Due to its high ORR activity, durability, and low-cost, producing 3D-NCN from SD in molten salt medium provides a promising approach to replace the Pt-based catalysts for use in fuel cells.