RESUMEN
In this work, the tensile deformation behavior of an as-extruded AZ80 magnesium alloy under pulsed current (PC) was investigated based on microstructure observations. We found that compared with the tensile tests at room temperature (RT) and given temperature (GT), the flow stress is reduced due to both thermal and athermal effects of pulsed current. A quasi-in-situ electron backscatter diffraction (EBSD) analysis reveals that at the same strain, the geometrically necessary dislocation (GND) density of the RT sample is the highest, followed by the GT sample and the PC sample. This proves that the athermal effect can promote the annihilation of dislocations and slow down dislocation pileup, which reduces the flow stress. In addition, the twinning behavior under different deformation conditions was studied; the twins are {10-12} tension twins, which are activated with the assistance of local stress. We found that the twin fraction in the PC sample is lower than that in the RT and GT samples, due to the least accumulation of GNDs at grain boundaries, which decreases the nucleation of {10-12} tension twins.
RESUMEN
The high-temperature superplastic deformation behavior of rolled Mg-8Al-2Sn (AT82) and Mg-8Al-1Sn-1Zn (ATZ811) alloys were investigated in this study. During tensile deformation at 573 K, no obvious grain growth occurred in both alloys, because of the high-volume fraction of second phases located at grain boundaries. Meanwhile, texture weakening was observed, suggesting that grain boundary sliding (GBS) is the dominant superplastic deformation mechanism, which agreed well with the strain rate sensitivity (m) and the activation energy (Q) calculations. The microstructural evolution during tensile deformation manifested that there were more and larger cavities in AT82 than ATZ811 during high-temperature tensile deformation. Therefore, superior superplasticity was found in the ATZ811 alloy that presented a tensile elongation of ~510% under a strain rate of 10-3 s-1 at 573 K, in contrast to the relatively inferior elongation of ~380% for the AT82 alloy. Meanwhile, good tensile properties at ambient temperature were also obtained in ATZ811 alloy, showing the ultimate tensile strength (UTS) of ~355 MPa, yield strength (YS) of ~250 MPa and elongation of ~18%. Excellent mechanical performance at both ambient and elevated temperatures can be realized by using economical elements and conventional rolling process, which is desirable for the industrial application of Mg alloy sheets.
