RETROSPECTIVE DOSIMETRY USING SALTED SNACKS AND NUTS: A FEASIBILITY STUDY.

The possibility of using ordinary household table salt for dosimetry is suggested by its high sensitivity to ionising radiation, which generates a readout of optically stimulated luminescence (OSL). However, to exploit this finding for retrospective human dosimetry, it would be needed to find salt in close proximity to the exposed individual. Finding salty snacks frequently tucked into handbags, backpacks or pockets seemed to be a possibility; these items therefore became the test materials of the present study. The aluminium or cardboard packages used to exclude the moisture that makes crisps and nuts go soft and stale also helps to retain the induced OSL signal. Therefore, different snacks, either their salt component alone or mixed with the snack, are exposed to ionising radiation and then were assessed for their dosimetric properties. The results indicate the feasibility of using some salty snacks for dosimetry, with a minimum detectable dose as low as 0.2 mGy.

Laboratory diagnosis of Lyme neuroborreliosis: a comparison of three CSF anti-Borrelia antibody assays.

The diagnosis of Lyme neuroborreliosis (LNB) requires the detection of intrathecal synthesis of Borrelia-specific antibodies, but in very early disease, the sensitivity may be low. We compared the performance of the second-generation IDEIA Lyme Neuroborreliosis test (Oxoid), based on purified native flagellum antigen, with two newly developed tests based on several recombinant antigens for the diagnosis of LNB. Patients investigated for LNB during 2003 through 2007 were included (n = 175); 52 with definite LNB, four with possible LNB and 119 non-LNB patients. Serum and cerebrospinal fluid (CSF) were analysed with the IDEIA Lyme Neuroborreliosis (Oxoid), VIDAS Lyme IgG (bioMérieux) and recomBead Borrelia IgM and IgG (Mikrogen) assays. Intrathecal antibody indices (AIs) were calculated according to the manufacturers' protocols. The IDEIA test performed with an overall sensitivity (IgM and IgG AIs taken together) of 88 % and a specificity of 99 %. The VIDAS test showed a sensitivity of 86 % and a specificity of 97 %. An overall sensitivity of 100 % and a specificity of 97 % were achieved by the recomBead test. We conclude that the three assays performed equally well regarding specificity, but our data suggest an improved diagnostic sensitivity with the recomBead Borrelia test.

Using an optimised OSL single-aliquot regenerative-dose protocol for low-dose retrospective dosimetry on household salt.

The single-aliquot regenerative-dose (SAR) protocols used in retrospective dosimetry for optically stimulated luminescence measurements have been mainly developed for archaeological and geological dating of quartz and feldspar. The aim in this study is to find a read-out protocol that can generate the most reproducible signal for household salt (NaCl) at absorbed doses below 100 mGy. The relation between the reproducibility of the signal, in terms of the ratio between given absorbed dose and SAR-calculated dose, and parameters such as test-dose pre-heat temperature has been studied. It was found that a temperature of 200 °C yielded the best reproducibility in the SAR-calculated dose, which is a somewhat higher pre-heat temperature than what is used for dating of quartz.

Identification of proteins in human cerebrospinal fluid using liquid-phase isoelectric focusing as a prefractionation step followed by two-dimensional gel electrophoresis and matrix-assisted laser desorption/ionisation mass spectrometry.

Cerebrospinal fluid (CSF) is in close proximity to the brain and changes in the protein composition of CSF may be indicative of altered brain protein expression in neurodegenerative disorders. Analysis of brain-specific proteins in CSF is complicated by the fact that most CSF proteins are derived from the plasma and tend to obscure less abundant proteins. By adopting a prefractionation step prior to two-dimensional gel electrophoresis (2-DE), less abundant proteins are enriched and can be detected in complex proteomes such as CSF. We have developed a method in which liquid-phase isoelectric focusing (IEF) is used to prefractionate individual CSF samples; selected IEF fractions are then analysed on SYPRO-Ruby-stained 2-D gels, with final protein identification by matrix-assisted laser desorption/ionisation time-of-flight mass spectrometry (MALDI-TOFMS). To optimise the focusing of the protein spots on the 2-D gel, the ampholyte concentration in liquid-phase IEF was minimised and the focusing time in the first dimension was increased. When comparing 2-D gels from individual prefractionated and unfractionated CSF samples it is evident that individual protein spots are larger and contain more protein after prefractionation of CSF. Generally, more protein spots were also detected in the 2-D gels from prefractionated CSF compared with direct 2-DE separations of CSF. Several proteins, including cystatin C, IgM-kappa, hemopexin, acetyl-coenzyme A carboxylase-alpha, and alpha-1-acid glycoprotein, were identified in prefractionated CSF but not in unfractionated CSF. Low abundant forms of posttranslationally modified proteins, e.g. alpha-1-acid glycoprotein and alpha-2-HS glycoprotein, can be enriched, thus better resolved and detected on the 2-D gel. Liquid-phase IEF, as a prefractionation step prior to 2-DE, reduce sample complexity, facilitate detection of less abundant protein components, increases the protein loads and the protein amount in each gel spot for MALDI-MS analysis.

Anaerobic desulfurization of ground rubber with the thermophilic archaeon Pyrococcus furiosus--a new method for rubber recycling.

The anaerobic sulfur-reducing archaeon Pyrococcus furiosus was investigated regarding its capacity to desulfurize rubber material. The microorganism's sensitivity towards common rubber elastomers and additives was tested and several were shown to be toxic to P. furiosus. The microorganism was shown to utilize sulfur in vulcanized natural rubber and an increase in cell density was obtained when cultivated in the presence of spent tire rubber. Ethanol-leached cryo-ground tire rubber treated with P. furiosus for 10 days was vulcanized together with virgin rubber material (15% w/w) and the mechanical properties of the resulting material were determined. The increase in the stress at break value and the decrease in swell ratio and stress relaxation rate obtained for material containing microbially treated rubber (compared to untreated material) show the positive effects of microbial desulfurization on rubber.

Biotechnological possibilities for waste tyre-rubber treatment.

Every year large amounts of spent rubber material, mainly from rubber tyres, are discarded. Of the annual total global production of rubber material, which amounts to 16-17 million tonnes, approximately 65% is used for the production of tyres. About 250 millions spent car tyres are generated yearly in USA only. This huge amount of waste rubber material is an environmental problem of great concern. Various ways to remediate the problem have been proposed. Among these are road fillings and combustion in kilns. Spent tyres, however, comprise valuable material that could be recycled if a proper technique can be developed. One way of recycling old tyres is to blend ground spent rubber with virgin material followed by vulcanization. The main obstacle to this recycling is bad adhesion between the crumb and matrix of virgin rubber material due to little formation of interfacial sulphur crosslinks. Micro-organisms able to break sulphur-sulphur and sulphur-carbon bonds can be used to devulcanize waste rubber in order to make polymer chains on the surface more flexible and facilitate increased binding upon vulcanization. Several species belonging to both Bacteria and Archaea have this ability. Mainly sulphur oxidizing species, such as different species of the genus Thiobacillus and thermoacidophiles of the order of Sulfolobales, have been studied in this context. The present paper will give a background to the problem and an overview of the biotechnological possibilities for solutions of waste rubber as an environmental problem, focusing on microbial desulphurization.