RESUMEN
Non-thermal plasma (NTP) has proven to be a green method in the agricultural field for the stimulation of germination, growth, and production of nutraceutical compounds in some cases. However, the process is far from being fully understood and depends on the targeted plant species and the NTP used. In this work, we focus on the production of alfalfa sprouts from NTP-treated seeds under different voltage conditions. A flexible electrode configuration was used to produce the NTP, which can also be placed on packages for in-package treatments. The surface of the seeds was analyzed, indicating that the microstructure was strongly affected by NTP treatment. Biometric measurements evidenced the possibility of stimulating the sprout growth in some conditions by up to 50% compared to the sprouts obtained from untreated seeds. Biochemical traits for the sprouts obtained in different processing conditions were also studied, such as the concentrations of chlorophyll pigments, flavonoids and polyphenols, and antioxidant activity. Most NTP treatments led to inhibitory effects, proving the strong dependence between NTP treatment and targeted plant species.
RESUMEN
The possibility to stimulate the production of some nutraceutical properties of fenugreek (Trigonella foenum-graecum L.) sprouts by non-thermal plasma (NTP) processing of the seeds in different conditions was studied. The non-thermal plasma used in this work was a surface dielectric barrier discharge. Two types of processing were performed: direct NTP treatment and NTP with a cover treatment, to simulate the processing of packaged seeds. For all treatments, the effect of pre-soaking of the seeds was studied as well. The analyses of the seeds after processing indicated an increase of the hydrophilicity of their surface for NTP direct treatment as resulted from the water contact angle measurements, which could be due to the strong etching evidenced by scanning electron microscopy imaging. A significant (p < 0.05) increase of the seedling growth, by up to 50%, was found especially for the pre-soaked seeds. These results were correlated with the increase of chlorophyll pigments concentrations, with higher concentrations in the case of NTP direct treatment than for the NTP with cover treatments. Direct NTP treatment for 30 s of dry seeds led to the highest increase of the flavonoid concentration of about three times compared to that obtained for untreated seeds. For the polyphenols and antioxidant activity, NTP with cover treatments proved to be better, with a significant increase, especially for 90 s treatment of the pre-soaked seeds. All the results indicate the possibility of tuning the nutraceutical properties of fenugreek sprouts by NTP treatment.
Asunto(s)
Trigonella , Suplementos Dietéticos , Clorofila , Flavonoides , SemillasRESUMEN
Flower-like ZnO architectures assembled with many nanorods were successfully synthesized through Thermionic Vacuum Arc, operated both in direct current (DC-TVA) and a pulsed mode (PTVA), and coupled with annealing in an oxygen atmosphere. The prepared coatings were analysed by scanning-electron microscopy with energy-dispersive X-ray-spectroscopy (SEM-EDX), X-ray-diffraction (XRD), and photoluminescence (PL) measurements. By simply modifying the TVA operation mode, the morphology and uniformity of ZnO nanorods can be tuned. The photocatalytic performance of synthesized nanostructured ZnO coatings was measured by the degradation of methylene-blue (MB) dye and ciprofloxacin (Cipro) antibiotic. The ZnO (PTVA) showed enhancing results regarding the photodegradation of target contaminants. About 96% of MB molecules were removed within 60 min of UV irradiation, with a rate constant of 0.058 min-1, which is almost nine times higher than the value of ZnO (DC-TVA). As well, ZnO (PTVA) presented superior photocatalytic activity towards the decomposition of Cipro, after 240 min of irradiation, yielding 96% degradation efficiency. Moreover, the agar-well diffusion assay performance against both Gram-positive and Gram-negative bacteria confirms the degradation of antibiotic molecules by the UV/ZnO (PTVA) approach, without the formation of secondary hazardous products during the photocatalysis process. Repeated cyclic usage of coatings revealed excellent reusability and operational stability.
RESUMEN
The surface functionalization of radio frequency magnetron-sputtered zinc oxide (ZnO) thin films tailored by low-pressure Ar/NH3 mixture surface-wave plasmas (SWPs) is discussed based on the results of photoluminescence (PL), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and spectrophotometric measurements. At an Ar/NH3 gas mixture ratio of 70%/30%, both the PL intensity of the near-band-edge emission and the XRD intensity of the ZnO(002) reflection peak were enhanced by about 5.5 and 8 times, respectively, compared to the values for the as-grown sample. Furthermore, the XPS and spectrophotometric analyses using the fluorescent dye showed that the amine group functionalization over the surface of the ZnO films reached their maximum values at the same gas ratio. From the results of optical emission spectroscopic and ion mass spectrometric measurements in the Ar/NH3 mixture SWPs, it is inferred that the nitrogen-containing reactive species, such as NH x+ ( x = 1-4) ions and NH y ( y = 1, 2) molecules in addition to H radicals might crucially interact with the defective ZnO surface lattices to repair the ZnO thin films from compressive to strain-free crystallized structures, enhance the PL intensity, and produce the amine group surface functionalization.
RESUMEN
Hollow carbon nanospheres with controlled morphologies were synthesized via the copper-carbon direct current arc discharge method by alternating the concentrations of methane in the reactant gas mixture. A self-healing process to keep the structural integrity of encapsulated graphitic shells was evolved gradually by adding methane gas from 0% to 20%. The outer part of the coated layers expanded and hollow nanospheres grew to be large fluffy ones with high methane concentrations from 30% to 50%. A self-repairing function by the reattachment of broken graphitic layers initiated from near-electrode space to distance was also distinctly exhibited. By comparing several comparable metals (e.g. copper, silver, gold, zinc, iron and nickel)-carbon arc discharge products, a catalytic carbon-encapsulation mechanism combined with a core-escaping process has been proposed. Specifically, on the basis of the experimental results, copper could be applied as a unique model for both the catalysis of graphitic encapsulation and as an adequate template for the formation of hollow nanostructures.