Mechanistic insights into CO2 conversion to CO using cyano manganese complexes.

Without the use of a photosensitizer, [Mn(bpy)(CO)3(CN)] (MnCN) can photochemically form [Mn(bpy)(CO)3]-, the active species for CO2 reduction. While cases of the axial X-ligand dissociating upon irradiation of fac-[M(N-N)(CO)3X] complexes (M = Mn or Re; N-N = bipyridine (bpy) ligand; X = halogen or pseudohalogen) are well documented, the axial cyanide ligand is retained when either [Mn(bpy)(CO)3(CN)] or [Mn(mesbpy)(CO)3(CN)], MnCN(mesbpy), are irradiated anaerobically. Infrared and UV-vis spectroscopies indicate the formation of [Mn(bpy)(CO)2(MeCN)(CN)] (s-MnCN) as the primary product during the irradiation of MnCN. An in-depth analysis of the photochemical mechanism for the formation of [Mn(bpy)(CO)3]- from MnCN is presented. MnCN(mesbpy) is too sterically hindered to undergo the same photochemical mechanism as MnCN. However, MnCN(mesbpy) is found to be electrocatalytically active for CO2 reduction to CO. Thus providing an interesting distinction between photochemical and electrochemical charge transfer.

Elucidating the mechanism of photochemical CO2 reduction to CO using a cyanide-bridged di-manganese complex.

The complex, [{[Mn(bpy)(CO)3]2}(µ-CN)]+ (Mn2CN+), has previously been shown to photochemically reduce CO2 to CO. The detailed mechanism behind its reactivity was not elucidated. Herein, the photoevolution of this reaction is studied in acetonitrile (MeCN) using IR and UV-vis spectroscopy. Samples were excited into the MnI → π* bpy metal-to-ligand charge transfer (MLCT) absorption band triggering CO loss, and rapid MeCN solvent ligation at the open coordination site. It is concluded that this process occurs selectively at the Mn axial ligation site that is trans to the C-end of the bridging cyanide. Upon further photolysis, the metal-metal bonded dimeric species, [(CO)3(bpy)Mn-Mn(bpy)(CO)3] (Mn-Mn) is observed to form under anaerobic conditions. The presence of this dimeric species coincides with the observation of CO production. When oxygen is present, CO2 photoreduction does not occur, which is attributed to the inability of Mn2CN+ to convert to the metal-metal bonded dimer. Photolysis experiments, where the Mn-Mn dimer is formed photochemically under argon first and then exposed to CO2, reveal that it is the radical species, [Mn(bpy)(CO)3˙] (Mn˙), that interacts with the CO2. Since the presence of Mn-Mn and light is required for CO production, [Mn(bpy)(CO)3˙] is proposed to be a photochemical reagent for the transformation of CO2 to CO.

Using Light and Electrons to Bend Carbon Dioxide: Developing and Understanding Catalysts for CO2 Conversion to Fuels and Feedstocks.

Our global society generates an unwieldy amount of CO2 per unit time. Therefore, the capture of this greenhouse gas must involve a diverse set of strategies. One solution to this problem is the conversion of CO2 into a more useful chemical species. Again, a multiplicity of syntheses and products will be necessary. No matter how elegant the chemistry is, commercial markets often have little use for a small set of compounds made in tremendous yield. Following this reasoning, the Bocarsly Research Group seeks to develop new electrochemical and photochemical processes that may be of utility in the conversion of CO2 to organic compounds. We focus on investigating proton-coupled charge transfer mechanisms that produce both C1 and carbon-carbon bonded products (C2+).In early work, we considered the reduction of CO2 to formate at electrocatalytic indium and tin electrodes. These studies demonstrated the key role of surface oxides in catalyzing the reduction of CO2. This work generated efficient systems for the formation of formate and paved the way to studies using non-copper, intermetallic electrocatalysts for the generation of C2+ species. Most notable is the efficient formation of oxalate at an oxidized Cr3Ga electrode. Oxalate has recently been suggested as a potential nonfossil, alternate organic feedstock.Separately, we have focused on the electrocatalytic effects of pyridine on the reduction of CO2 in aqueous electrolyte. These studies demonstrated that electrodes that normally yield a low hydrogen overpotential (Pd and Pt) show suppressed H2 evolution and strongly enhanced activity for CO2 reduction in the presence of pyridinium. Methanol was observed to form in high Faradaic yield at low overpotential using this system. The 6-electron, 6-proton reduction of CO2 in the presence of pyridinium was intriguing, and significant effort was placed on understanding the mechanism of this reaction both on metal electrodes and on semiconducting photocathodes. P-GaP electrodes were found to provide exceptional behavior for the formation of methanol using only light as the energy source.The pyridinium studies highlighted the role of protons in the overall reduction of CO2, stimulating our interest in the chemistry of MnBr(bpy)(CO)3 and related compounds. This complex was reported to electrochemically reduce CO2 to CO. We saw these reports as an opportunity to study the detailed nature of the proton-coupled electron transfer (PCET) mechanism associated with CO2 reduction. Our investigation of this system revealed the role of hydrogen-bonding in CO2 reduction and pointed the way for the construction of a photochemical process for CO generation using a [(bpy)(CO)3Mn(CN)Mn(bpy)(CO)3]+ photocatalyst.Based on our studies to date, it appears likely that heterogeneous systems can be assembled to convert CO2 into products that are "beyond C2 products." This may open up new practical chemistry in the area of fossil-based replacements for both synthesis and fuels. Systems with pragmatic efficiencies are close to reality. Electrochemical reactors using heterogeneous electrocatalysts show the stability and product selectivity needed to generate industrial opportunities. Continued growth of mechanistic understanding is expected to facilitate the chemical design of cogent systems for the taming of CO2.