Photoelectron spectroscopy and electronic structure calculations of d1 vanadocene compounds with chelated dithiolate ligands: implications for pyranopterin Mo/W enzymes.

Gas-phase photoelectron spectroscopy and density functional theory have been used to investigate the electronic structures of open-shell bent vanadocene compounds with chelating dithiolate ligands, which are minimum molecular models of the active sites of pyranopterin Mo/W enzymes. The compounds Cp2V(dithiolate) [where dithiolate is 1,2-ethenedithiolate (S2C2H2) or 1,2-benzenedithiolate (bdt), and Cp is cyclopentadienyl] provide access to a 17-electron, d1 electron configuration at the metal center. Comparison with previously studied Cp2M(dithiolate) complexes, where M is Ti and Mo (respectively d0 and d2 electron configurations), allows evaluation of d0, d1, and d2 electronic configurations of the metal center that are analogues for the metal oxidation states present throughout the catalytic cycle of these enzymes. A "dithiolate-folding effect" that involves an interaction between the vanadium d orbitals and sulfur p orbitals is shown to stabilize the d1 metal center, allowing the d1 electron configuration and geometry to act as a low-energy electron pathway intermediate between the d0 and d2 electron configurations of the enzyme.

Pulsed EPR investigations of systems modeling molybdenum enzymes: hyperfine and quadrupole parameters of oxo-17O in [Mo 17O(SPh)4]-.

Ka band ESEEM spectroscopy was used to determine the hyperfine (hfi) and nuclear quadrupole (nqi) interaction parameters for the oxo-17O ligand in [Mo 17O(SPh)4]-, a spectroscopic model of the oxo-Mo(V) centers of enzymes. The isotropic hfi constant of 6.5 MHz found for the oxo-17O is much smaller than the values of approximately 20-40 MHz typical for the 17O nucleus of an equatorial OH(2) ligand in molybdenum enzymes. The 17O nqi parameter (e2qQ/h = 1.45 MHz, eta approximately = 0) is the first to be obtained for an oxo group in a metal complex. The parameters of the oxo-17O ligand, as well as other magnetic resonance parameters of [Mo 17O(SPh)4]- predicted by quasi-relativistic DFT calculations, were in good agreement with those obtained in experiment. From the electronic structure of the complex revealed by DFT, it follows that the SOMO is almost entirely molybdenum d(xy) and sulfur p, while the spin density on the oxo-17O is negative, determined by spin polarization mechanisms. The results of this work will enable direct experimental identification of the oxo ligand in a variety of chemical and biological systems.

Electronic structure of bent titanocene complexes with chelated dithiolate ligands.

Gas-phase photoelectron spectroscopy and density functional theory have been utilized to investigate the interactions between the p orbitals of dithiolate ligands and d orbitals of titanium in bent titanocene complexes as minimum molecular models of active site features of pyranopterin Mo/W enzymes. The compounds Cp(2)Ti(S-S) [where (S-S) is 1,2-ethenedithiolate (S(2)C(2)H(2)), 1, 1,2-benzenedithiolate (bdt), 2, or 1,3-propanedithiolate (pdt), 3, and Cp(-) is cyclopentadienyl] provide access to a formal 16-electron d(0) electronic configuration at the metal. A "dithiolate-folding-effect" involving an interaction of metal and sulfur orbitals is demonstrated in complexes with arene- and enedithiolates. This effect is not observed for the alkanedithiolate in complex 3.

Structural and functional analogue of the active site of polysulfide reductase from Wolinella succinogenes.

Synthesis of [PPh4]2[Mo(SPh)2(S2C2(CN)2)2] (2) from [PPh4]2[MoO(S2C2(CN)2)2] (1) has been achieved to mimic the postulated [Mo(S)6] core of polysulfide reductase with two thiolates and two bis(ene-dithiolate) ligands. Compound 2 reacts with polysulfide to yield H2S, modeling the function of polysulfide reductase. The facile conversion of 2 back to 1 in moist solvent suggests that the interconversion of the [MoIV = O] and [MoIV - X] (X = O-Ser, S-Cys, Se-Cys) moieties might occur in the DMSO reductase class of enzymes under appropriate hydrophobic/hydrophilic conditions.

Investigation of metal-dithiolate fold angle effects: implications for molybdenum and tungsten enzymes.

Gas-phase photoelectron spectroscopy and density functional theory have been used to investigate the interactions between the sulfur pi-orbitals of arene dithiolates and high-valent transition metals as minimum molecular models of the active site features of pyranopterin MoW enzymes. The compounds (Tp*)MoO(bdt) (compound 1), Cp(2)Mo(bdt) (compound 2), and Cp(2)Ti(bdt) (compound 3) [where Tp* is hydrotris(3,5-dimethyl-1-pyrazolyl)borate, bdt is 1,2-benzenedithiolate, and Cp is eta(5)- cyclopentadienyl] provide access to three different electronic configurations of the metal, formally d(1), d(2), and d(0), respectively. The gas-phase photoelectron spectra show that ionizations from occupied metal and sulfur based valence orbitals are more clearly observed in compounds 2 and 3 than in compound 1. The observed ionization energies and characters compare very well with those calculated by density functional theory. A "dithiolate-folding-effect" involving an interaction of the metal in-plane and sulfur-pi orbitals is proposed to be a factor in the electron transfer reactions that regenerate the active sites of molybdenum and tungsten enzymes.

New oxovanadium bis(1,2-dithiolate) compounds that mimic the hydrogen-bonding interactions at the active sites of mononuclear molybdenum enzymes.

Reaction of VO(acac)(2) with 1,2-dithiols in the presence of triethylamine gives pentacoordinate oxovanadium complexes [HNEt(3)](2)[VO(bdt)(2)] (1), [HNEt(3)](2)[VO(tdt)(2)] (2), and [HNEt(3)](2)[VO(bdtCl(2))(2)] (3) (where H(2)bdt = 1,2-benzenedithiol, H(2)tdt = 3,4-toluenedithiol, and H(2)bdtCl(2) = 3,6-dichloro-1,2-benzenedithiol). Compounds 1-3 have been characterized by IR, UV/visible, EPR, and mass spectroscopies. The X-ray crystal stuctures of 1 and 2 show hydrogen-bonding interactions between the terminal oxo atom and triethylammonium counterions and between ligand sulfur atoms and the counterions. These interactions are comparable with those found at the active sites of mononuclear molybdenum enzymes.

Probing the electronic structure of [MoOS(4)](-) centers using anionic photoelectron spectroscopy.

Using photodetachment photoelectron spectroscopy (PES) in the gas phase, we investigated the electronic structure and chemical bonding of six anionic [Mo(V)O](3+) complexes, [MoOX(4)](-) (where X = Cl (1), SPh (2), and SPh-p-Cl (3)), [MoO(edt)(2)](-) (4), [MoO(bdt)(2)](-) (5), and [MoO(bdtCl(2))(2)](-) (6) (where edt = ethane-1,2-dithiolate, bdt = benzene-1,2-dithiolate, and bdtCl(2) = 3,6-dichlorobenzene-1,2-dithiolate). The gas-phase PES data revealed a wealth of new electronic structure information about the [Mo(V)O](3+) complexes. The energy separations between the highest occupied molecular orbital (HOMO) and HOMO-1 were observed to be dependent on the O-Mo-S-C(alpha) dihedral angles and ligand types, being relatively large for the monodentate ligands, 1.32 eV for Cl and 0.78 eV for SPh and SPhCl, compared to those of the bidentate dithiolate complexes, 0.47 eV for edt and 0.44 eV for bdt and bdtCl(2). The threshold PES feature in all six species is shown to have the same origin and is due to detaching the single unpaired electron in the HOMO, mainly of Mo 4d character. This result is consistent with previous theoretical calculations and is verified by comparison with the PES spectra of two d(0) complexes, [VO(bdt)(2)](-) and [VO(bdtCl(2))(2)](-). The observed PES features are interpreted on the basis of theoretical calculations and previous spectroscopic studies in the condensed phase.