Dispersive liquid-liquid microextraction based on solidification of floating organic drop and high-performance liquid chromatography to the analysis of cocaine's major adulterants in human urine.

A simple method has been proposed for the determination of cocaine's major adulterants (caffeine, levamisole, lidocaine, phenacetin, diltiazem, and hydroxyzine) in human urine by dispersive liquid-liquid microextraction based on solidification of floating organic drop (DLLME-SFO) in combination with high-performance liquid chromatography - photodiode array detector (HPLC-PDA). The reversed-phase chromatographic separation was obtained with a column C18 extended (250×4.6mm; 5µm; 80Å) in gradient elution mode using acetonitrile-trifluoroacetic acid 0.026% (v,v) (pH=2.5) at 1mLmin-1 as mobile phase, at 25°C, and detection at 235nm. The analysis time was 25min. This condition had the best resolution factors (>1.15), retention factors (>0.68), number of plates (>2094.9), and separation factors (>1.05) for all targets, indicating a good separation. The kind of extraction and dispersive solvent were investigated for unifactorial design. The buffer pH, the volume of extraction and disperser solvent, and the amount of salt were optimized for full factorial design. Under optimum conditions, human urine samples were alkalized with 0.5M sodium phosphate buffer (pH 10) and added to sodium chloride (20%m/v). Acetonitrile (150µL) and 1-dodecanol (30µL) were used as dispersive and extraction solvent, respectively. The method presented linear range of 312.5-3125ngmL-1 to caffeine and levamisole and 187.5-1875ngmL-1 to lidocaine, phenacetin, diltiazem, and hydroxyzine. The limit of quantification was 187.5ngmL-1 to lidocaine, phenacetin, diltiazem, and hydroxyzine and 312.5ngmL-1 for caffeine and levamisole. The recovery mean values were between 6.0 and 42.6%. The method showed good precision and accuracy, with within- and between-run relative standard deviation and relative error less than 15%. The samples were stable after freeze-thaw cycle and short-term room temperature stability tests. Besides, this method was satisfactorily applied in urine of cocaine users. It is expected that this method, which was the first to combine the use of DLLME-SFO and HPLC-PDA for the determination of cocaine's major adulterants in human urine, will contribute to the accuracy in the diagnosis of acute intoxication, the proper planning of therapeutic measures, as well as to the favorable prognostic of cocaine intoxicated patients.

Determination of ethyl carbamate in cachaça produced from copper stills by HPLC.

Ethyl carbamate (EC) is a common substance in fermented foods and drinks, and its quantification is important because of its carcinogenic nature and its usually presence in alcoholic beverages. The present work involved the development and validation of an analytical method for the evaluation of EC in cachaça by HPLC-FLD after previous derivatization with xanthydrol. The method presented a mean recovery of 94.88%, an intra-day precision of 4.19% (30.0 µgL(-1)) and 3.32% (75.0 µgL(-1)), a coefficient of determination (r(2)) equal to 0.9985, and limits of detection and quantification equal to 6.39 and 21.32 µgL(-1), respectively. The results show that the analytical method is accurate, reproducible and linear over the concentration range from 5.0 to 160 µg of EC per litre. The method was applied to the analysis of EC in cachaça, the analyses being rapid and efficient.

Validation of an analytical method for analysis of cannabinoids in hair by headspace solid-phase microextraction and gas chromatography-ion trap tandem mass spectrometry.

The development of an analytical method for the determination of Delta(9)-tetrahydrocannabinol (THC), cannabidiol (CBD) and cannabinol (CBN) in samples of human hair is described. Samples were subjected to a procedure based on the combination of headspace solid-phase microextraction (HS-SPME) with gas chromatography linked with mass spectrometry operating in tandem mode (GC-MS/MS). A 10 mg aliquot of sample was firstly decontaminated using petroleum ether, deionized water and dichloromethane (2 mL of each solvent), for 10 min under sonication, and then digested in alkaline solution (1 mol L(-1) NaOH). The method variables evaluated were pH, mass of hair, fiber type, extraction temperature, desorption time, ionic strength, pre-equilibrium time and extraction time. Parameters concerning operation of the tandem mode MS/MS were also assessed and optimized. Validation of the method demonstrated excellent linearity in the range 0.1-8.0 ng mg(-1), with regression coefficients better than 0.994. Precision was determined using two different concentrations (upper and lower limits of the linear range), and RSD values were between 6.6 and 16.4%. Absolute recoveries (measured in triplicate) were in the range 1.1-8.7%, and limits of detection and quantification were 0.007-0.031 ng mg(-1) and 0.012-0.062 ng mg(-1), respectively. The LOQ for THC (0.062 ng mg(-1)) was below the cut-off value (LOQ < or = 0.1 ng mg(-1)) established by the Society of Hair Testing (SOHT), the Society of Toxicological and Forensic Chemistry (STFCh) and the Société Française de Toxicologie Analytique (SFTA). The optimized SPME method was applied in analysis of hair samples from Cannabis drug users, showing that CBN and CBD were present in all samples analyzed.

Hollow fiber-based liquid phase microextraction with factorial design optimization and gas chromatography-tandem mass spectrometry for determination of cannabinoids in human hair.

A new method, based on hollow fiber liquid-phase microextraction (HF-LPME) and gas chromatography-tandem mass spectrometry (GC-MSMS), was developed for determination of Delta(9)-tetrahydrocannabinol (THC), cannabidiol (CBD) and cannabinol (CBN) in samples of human hair. Since hair is a solid matrix, the samples were subjected to alkaline digestion using NaOH. The aqueous solutions obtained were extracted using a 6cm polypropylene fiber (600microm i.d., 200microm wall thickness, 0.2microm pore size) for each extraction. A 2(5-1) fractional factorial design for screening, and a central composite design for optimization of significant variables, was applied during development of the extraction method. The variables evaluated were the type of extraction solvent, pH, stirring speed, extraction time, and acceptor phase volume. The optimized conditions for the proposed extraction procedure were 10mg of hair sample; 20microL of butyl acetate; aqueous (pH 14) donor phase containing 6.8% NaCl; 600rpm stirring speed; 20min extraction time. A linear response was obtained in the ranges 1-500pgmg(-1) (CBD and CBN) and 20-500pgmg(-1) (THC), with regression coefficients >0.99. Precision, determined as the relative standard deviation, was 3.3-8.9% (intra-day) and 4.4-13.7% (inter-day). Absolute recoveries varied in the ranges 4.4-4.8% (CBD), 7.6-8.9% (THC) and 7.7-8.2% (CBN). Limits of detection (LOD, S/N=3) and quantification (LOQ, S/N=10) were 0.5-15pgmg(-1) and 1-20pgmg(-1), respectively. The method was successfully used to determine CBD, THC and CBN in hair samples from patients in a drug dependency rehabilitation center. Concentrations varied in the ranges 1-18pgmg(-1) (CBD), 20-232pgmg(-1) (THC) and 9-107pgmg(-1) (CBN), confirming the suitability of the method for monitoring studies.

Multivariate optimization of a solid phase microextraction-headspace procedure for the determination of benzene, toluene, ethylbenzene and xylenes in effluent samples from a waste treatment plant.

A method based on solid-phase microextraction (SPME) and gas chromatography with flame ionization detection (GC-FID) has been optimized for the determination of benzene, toluene, ethylbenzene and xylenes (BTEX) in water released from a waste treatment plant. The extraction step was optimized using fractional factorial and central composite designs including the following experimental factors: saline concentration; extraction time; desorption time; agitation velocity; headspace volume. A multiple function was used to describe the experimental conditions for simultaneous extraction of the compounds. The procedure, based on direct SPME at 50 degrees C, using a polydimethylsiloxane fiber, showed good linearity (r>0.997 over a concentration range 2-200 microg L(-1)) and repeatability (relative standard deviation (RSD)<4.23%) for all compounds, with limits of detection ranging from 0.05 to 0.28 microg L(-1), and limits of quantification ranging from 0.14 to 0.84 microg L(-1). Concentrations of the target compounds in these samples were between 145.8 and 1891 microg L(-1).

Simultaneous determination of eight pesticide residues in coconut using MSPD and GC/MS.

A simple and effective extraction method based on matrix solid-phase dispersion (MSPD) was developed to determine dimethoate, malathion, lufenuron, carbofuran, 3-hydroxycarbofuran, thiabendazole, difenoconazole and trichlorfon in coconut pulp using gas chromatography-mass spectrometry with selected ion monitoring (GC/MS, SIM). Different parameters of the method were evaluated, such as type of solid-phase (C(18), alumina, silica-gel and Florisil), the amount of solid-phase and eluent (dichloromethane, acetone, ethyl acetate, acetonitrile, n-hexane and n-hexane:ethyl acetate (1:1, v/v)). The best results were obtained using 0.5 g of coconut pulp, 1.0 g of C(18) as dispersant sorbent, 1.0 g of Florisil as clean-up sorbent and acetonitrile saturated with n-hexane as eluting solvent. The method was validated using coconut pulp samples fortified with pesticides at different concentration levels (0.25-1.0 mg kg(-1)). Average recoveries (four replicates) ranged from 70.1% to 98.7%, with relative standard deviations between 2.7% and 14.7%, except for lufenuron and difenoconazole, for which recoveries were 47.2% and 48.2%, respectively. Detection and quantification limits for coconut pulp ranged from 0.02 to 0.17 mg kg(-1) and from 0.15 to 0.25 mg kg(-1), respectively.

MSPD procedure for determining buprofezin, tetradifon, vinclozolin, and bifenthrin residues in propolis by gas chromatography-mass spectrometry.

A simple and effective extraction method based on matrix solid-phase dispersion (MSPD) was developed to determine bifenthrin, buprofezin, tetradifon, and vinclozolin in propolis using gas chromatography-mass spectrometry in selected ion monitoring mode (GC-MS, SIM). Different method conditions were evaluated, for example type of solid phase (C(18), alumina, silica, and Florisil), the amount of solid phase and eluent (n-hexane, dichloromethane, dichloromethane-n-hexane (8:2 and 1:1, v/v) and dichloromethane-ethyl acetate (9:1, 8:2 and 7:3, v/v)). The best results were obtained using 0.5 g propolis, 1.0 g silica as dispersant sorbent, 1.0 g Florisil as clean-up sorbent, and dichloromethane-ethyl acetate (9:1, v/v) as eluting solvent. The method was validated by analysis of propolis samples fortified at different concentration levels (0.25 to 1.0 mg kg(-1)). Average recoveries (four replicates) ranged from 67% to 175% with relative standard deviation between 5.6% and 12.1%. Detection and quantification limits ranged from 0.05 to 0.10 mg kg(-1) and 0.15 to 0.25 mg kg(-1) propolis, respectively.