RESUMEN
We report the first demonstration of Raman amplification in a fiber of a single Bessel-like higher order mode using a multimode pump source. We amplify the LP08-mode with a 559-µm2 effective mode area at a signal wavelength of 1115 nm in a pure-silica-core step-index fiber. A maximum of 18 dB average power gain is achieved in a 9-m long gain fiber, with output pulse energy of 115 µJ. The Raman pump source comprises a pulsed 1060 nm ytterbium-doped fiber amplifier with V-value ~30, which is matched to the Raman gain fiber. The pump depletion as averaged over the signal pulses reaches 36.7%. The conversion of power from the multimode pump into the signal mode demonstrates the potential for efficient brightness enhancement with low amplification-induced signal mode purity degradation.
RESUMEN
We consider the general problem of free-space beam shaping for coupling in and out of higher order modes (HOMs) in optical fibers with high purity and low loss. We compare the performance of two simple phase structures - binary phase plates (BPPs) and axicons - for converting Gaussian beams to HOMs and vice versa. Both axicons and BPPs allow for excitation of modes with high purity (>15 dB parasitic mode suppression), or conversion of HOMs to near-Gaussian beams (M2 < 1.25). Axicon coupling in single-clad fibers allows for lower loss (0.85 ± 0.1 dB) conversion than BPPs (1.7 ± 0.1 dB); but BPPs are compatible with any fiber design, and allow for rapid switching between modes. The experiments detailed here use all commercial components and fibers, allowing for a simple means to investigate the unique properties of multi-mode fibers.
RESUMEN
We correct a few typographical errors in the original manuscript.
RESUMEN
We implement cross-correlated imaging in the frequency domain (fC(2)) in order to reconstruct different modes propagating in a multi-mode optical fiber, and measure their relative powers. Our system can complete measurements in under a second (950 ms), with a maximum signal to noise ratio of 25 dB. The system is capable of group-delay temporal resolution as high as 720 fs, and this number can be tailored for a variety of modal discrimination levels by choice of apodization functions and effective bandwidths of the tunable source we use. Measurements are made on a double-clad test fiber to demonstrate simultaneous reconstruction of six guided modes. Finally, the system is used to optimize alignment into the fiber under test and achieve mono-mode purity > 95%, underscoring the utility of fC(2) imaging for near-real-time modal content analysis.