RESUMEN
The BOUT++ transport code is run to study the effects of plasma drifts on the divertor out-in asymmetries (DOIAs) of particle and heat fluxes and their decay widths for EAST lower single null H-mode discharges. The diamagnetic drift seems to have no effects on the DOIAs of total particle and heat fluxes due to its divergence-free nature. However, it could significantly increase the DOIAs of peak particle and heat fluxes and the flux decay widths. The E × B drift is found to induce a large plasma flow to the divertor region, enhancing the DOIAs of both total and peak particle and heat fluxes and the flux decay widths. Both the radial and poloidal components of the E × B drift are necessary in increasing the DOIAs, however, the radial E × B drift seems to play a more important role. The effects on the DOIAs caused by both diamagnetic and E × B drifts are reversed with the reverse of toroidal magnetic field. The heat flux decay width λq and spreading width Sq are important physical and engineering parameters for the divertors and could be obtained by fitting the heat flux profiles at divertor targets. The λq at the outer target from the simulation case with all drifts could well match with the multi-machine scaling proposed by Eich and the DOIA of λq is in reasonable agreement with the scaling proposed by Goldston.
RESUMEN
In order to achieve long-pulse H-mode plasma scenario over 400 s with high heating power in the Experimental Advanced Superconducting Tokamak (EAST) device, the lower graphite divertor will be upgraded into a tungsten (W) divertor with active water cooling, which consists of the W/Cu monoblock units and the W flat-tile units as the divertor plasma facing components. As a fundamental diagnostic tool, the divertor Langmuir probe (Div-LP) diagnostic system will be upgraded accordingly. This paper presents the design of two kinds of new Div-LP systems, which are planned to be utilized on the W/Cu monoblock units and the W flat-tile units for the upgraded lower tungsten divertor, respectively, including their structures and preliminary poloidal and toroidal layouts. The Div-LP diagnostic system can measure the plasma parameters with the schemes of triple-probe, double-probe, and single-probe, to obtain the spatial and temporal distribution of plasma behavior on the divertor targets, which is useful for the discharge control and operation in EAST. In addition, the thermal analysis of the two kinds of probe assemblies is also carried out by using the three-dimensional finite element code ANSYS, which is aimed to get the optimal designs to withstand the long-pulse and high-power operation in EAST future experiments.
RESUMEN
In order to withstand rapid increase in particle and power impact onto the divertor and demonstrate the feasibility of the ITER design under long pulse operation, the upper divertor of the EAST tokamak has been upgraded to actively water-cooled, ITER-like tungsten mono-block structure since the 2014 campaign, which is the first attempt for ITER on the tokamak devices. Therefore, a new divertor Langmuir probe diagnostic system (DivLP) was designed and successfully upgraded on the tungsten divertor to obtain the plasma parameters in the divertor region such as electron temperature, electron density, particle and heat fluxes. More specifically, two identical triple probe arrays have been installed at two ports of different toroidal positions (112.5-deg separated toroidally), which can provide fundamental data to study the toroidal asymmetry of divertor power deposition and related 3-dimension (3D) physics, as induced by resonant magnetic perturbations, lower hybrid wave, and so on. The shape of graphite tip and fixed structure of the probe are designed according to the structure of the upper tungsten divertor. The ceramic support, small graphite tip, and proper connector installed make it possible to be successfully installed in the very narrow interval between the cassette body and tungsten mono-block, i.e., 13.5 mm. It was demonstrated during the 2014 and 2015 commissioning campaigns that the newly upgraded divertor Langmuir probe diagnostic system is successful. Representative experimental data are given and discussed for the DivLP measurements, then proving its availability and reliability.
RESUMEN
To investigate the relationship between the expression of the PTEN (phosphatase and tensin homolog deleted on chromosometen) and VEGF (vascular endothelial growth factor) and the clinicopathological features in canine mammary gland tumours, the expression levels of PTEN and VEGF protein were assessed in 50 cases of canine mammary gland tumours tissues and 4 cases of normal mammary gland tissues with using immunohistochemical method. The over-expression rate of PTEN protein was 100% in normal and well-differentiated mammary gland tissues and 67% in breast cancer cases respectively with a significant difference between the two groups (P<0.01). Expression of PTEN was not related to age and tumour size, but closely correlated to lymph node metastasis (P<0.01). The over-expression rate of VEGF protein was 33.3% in normal mammary gland tissues, and 78% in canine mammary gland tumours with a significant difference between the two groups (P<0.01). Expression of VEGF was not related to age or tumour size, but closely correlated with lymph node metastasis and clinical stage (P<0.05). Therefore the combination detection of PTEN and VEGF could serve as an important index to estimate the biological behavior and prognosis of canine mammary gland tumours. Reduced expression of PTEN might be involved in carcinogenesis and progression of canine breast cancer by up-regulating the VEGF expression to enhance angiogenesis.
