RESUMEN
By collecting simultaneously optical and chemical/morphological data from nanoscale volumes, the Photonic Atom Probe (PAP) can be applied not only to the study of the relationship between optical and structural properties of quantum emitter but also to evaluate the influence of other factors, such as the presence of point defects, on the photoluminescence. Through the analysis of multiple layers of InGaN/GaN quantum dots (QDs), grown so that the density of structural defects is higher with increasing distance from the substrate, we establish that the light emission is higher in the regions exhibiting a higher presence of structural defects. While the presence of intrinsic point defects with non-radiative recombination properties remains elusive, our result is consistent with the fact that QD layers closer to the substrate behave as traps for non-radiative point defects. This result demonstrates the potential of the PAP as a technique for the study of the optical properties of defects in semiconductors.
RESUMEN
The measurement of the composition of ε-Ga2O3 and the quantification of Sn doping in ε-Ga2O3:Sn by laser-assisted atom probe tomography (APT) may be inaccurate depending on the experimental conditions. Both the role of the laser energy and surface electric field were investigated, and the results clearly indicate that deviations from stoichiometry are observed changing the electric field conditions during APT. The measured atomic fraction of Ga can change from 0.45 at low field to 0.38 at high field, to be compared with the expected 0.4. This was interpreted in terms of preferential evaporation of Ga at high field and deficit of O at low field, which was caused by the formation of neutrals. The quantification of Sn-doping is accurate at low-field conditions, with an overestimation of the detected Sn-metallic fraction at high field. This suggests that Sn has a higher evaporation field compared to Ga. Finally, multiple detection events were in-depth studied, revealing that three dissociation reactions occur during APT: GaO2+ â Ga+ + O+; Ga2O22+ â Ga+ + GaO2+; Ga3O22+ â Ga+ + Ga2O2+. Nevertheless, only 2% of the detected events are related to such dissociation reactions, too small a fraction to fully explain the observed deviation from the stoichiometric composition in ε-Ga2O3.
RESUMEN
Attaining low-resistivity AlxGa1-xN layers is one keystone to improve the efficiency of light-emitting devices in the ultraviolet spectral range. Here, we present a microstructural analysis of AlxGa1-xN/Ge samples with 0 ≤ x ≤ 1, and a nominal doping level in the range of 1020 cm-3, together with the measurement of Ge concentration and its spatial distribution down to the nanometer scale. AlxGa1-xN/Ge samples with x ≤ 0.2 do not present any sign of inhomogeneity. However, samples with x > 0.4 display µm-size Ge crystallites at the surface. Ge segregation is not restricted to the surface: Ge-rich regions with a size of tens of nanometers are observed inside the AlxGa1-xN/Ge layers, generally associated with Ga-rich regions around structural defects. With these local exceptions, the AlxGa1-xN/Ge matrix presents a homogeneous Ge composition which can be significantly lower than the nominal doping level. Precise measurements of Ge in the matrix provide a view of the solubility diagram of Ge in AlxGa1-xN as a function of the Al mole fraction. The solubility of Ge in AlN is extremely low. Between AlN and GaN, the solubility increases linearly with the Ga mole fraction in the ternary alloy, which suggests that the Ge incorporation takes place by substitution of Ga atoms only. The maximum percentage of Ga sites occupied by Ge saturates around 1%. The solubility issues and Ge segregation phenomena at different length scales likely play a role in the efficiency of Ge as an n-type AlGaN dopant, even at Al concentrations where Ge DX centers are not expected to manifest. Therefore, this information can have direct impact on the performance of Ge-doped AlGaN light-emitting diodes, particularly in the spectral range for disinfection (≈260 nm), which requires heavily doped alloys with a high Al mole fraction.
RESUMEN
Atom Probe Tomography (APT) is a microscopy technique allowing for the 3D reconstruction of the chemical composition of a nanoscale needle-shaped sample with a precision close to the atomic scale. The photonic atom probe (PAP) is an evolution of APT featuring in situ and operando detection of the photoluminescence signal. The optical signatures of the light-emitting centers can be correlated with the structural and chemical information obtained by the analysis of the evaporated ions. It becomes thus possible to discriminate and interpret the spectral signatures of different light emitters as close as 20 nm, well beyond the resolution limit set by the exciting laser wavelength. This technique opens up new perspectives for the study of the physics of low dimensional systems, defects and optoelectronic devices.
RESUMEN
Correlation between off-axis electron holography and atom probe tomography (APT) provides morphological, chemical and electrical information about Mg doping (p-type) in gallium nitride (GaN) layers that have been grown at different temperatures at a nanometric scale. APT allows access to the three-dimensional distribution of atoms and their chemical nature. In particular, this technique allows visualisation of the Mg-rich clusters observed in p-doped GaN layers grown by metal-organic chemical vapour deposition. As the layer growth temperature increases, the cluster density decreases but their size indicted by the number of atoms increases. Moreover, APT reveals that threading dislocations are decorated with Mg atoms. Off-axis electron holography provides complementary information about the electrical activity of the Mg doping. As only a small fraction of dopant atoms are ionised at room temperature, this fraction is increased by annealing the specimen to 400 °C in situ in a transmission electron microscope (TEM). A strong reduction of the dopant electrical activity is observed for increases in the layer growth temperature. The correlation of APT with TEM-based techniques was shown to be a unique approach in order to investigate how the growth temperature affects both the chemical distribution and electrical activity of Mg dopant atoms.
RESUMEN
The composition of GaAs measured by laser-assisted atom probe tomography may be inaccurate depending on the experimental conditions. In this work, we assess the role of the DC field and the impinging laser energy on such compositional bias. The DC field is found to have a major influence, while the laser energy has a weaker one within the range of parameters explored. The atomic fraction of Ga may vary from 0.55 at low-field conditions to 0.35 at high field. These results have been interpreted in terms of preferential evaporation of Ga at high field. The deficit of As is most likely explained by the formation of neutral As complexes either by direct ejection from the tip surface or upon the dissociation of large clusters. The study of multiple detection events supports this interpretation.