Total As and As speciation from worldwide collected red wine samples.

Total As and As speciation were measured in 147 red wines collected worldwide by ICP-MS and HPLC-ICP-MS, respectively. The samples included mid-priced to prestigious wines with vintages covering a period of almost 50 years. Total As concentration ranged from below 0.1 to 56 µg/L (average value: 4.0 ± 5.9 µg/L). None of the samples presented a concentration exceeding the limit set by the Office of Vine and Wine of 200 µg/L. Inorganic As was the most abundant form, representing from about half to all total As, mainly as As(III). Dimethylarsinic-acid (DMA) was detected in slightly less than half of the samples, accounting for a few to several dozens of percent. Monomethylarsonic-acid (MMA) was only detected in a few samples. In average, the DMA concentration seemed to be higher in the Bordeaux wines than in the other ones, irrespective of the total As concentration.

Development of heart-cutting multidimensional gas chromatography coupled to time of flight mass spectrometry for silicon speciation at trace levels in gasoline samples.

To improve the understanding of hydrotreatment (HDT) catalyst poisoning by silicon species, these molecules must be characterized in petroleum products using powerful analytical systems. Heart-cutting gas chromatography coupled to time of flight mass spectrometry (GC-GC/TOFMS) method equipped with a Deans switch (DS) system was developed for the direct characterization of target silicon compounds at trace level (µg kg(-1)) in gasoline samples. This method was performed to identify silicon compounds never characterized before. After the selection of the second dimension column using GC-GC-FID, GC-GC/TOFMS was performed. The calibration curves obtained by the GC-GC/TOFMS method were linear up to 1,000 µg kg(-1). Limits of detection (LOD) were ranging from 5 to 33 µg kg(-1) in spiked gasoline. The method provided sufficient selectivity and sensitivity to characterize known silicon compounds thanks to their specific ions and their retention times. The analysis of a naphtha sample by GC-GC/TOFMS has shown the presence of cyclic siloxanes (D(n)) as major compounds of PDMS thermal degradation with the occurrence of linear siloxanes, especially hexamethyldisiloxane (L(2)), which was never characterized in petroleum products but already known as severe poison for catalyst.

Combining Fourier transform-ion cyclotron resonance/mass spectrometry analysis and Kendrick plots for silicon speciation and molecular characterization in petroleum products at trace levels.

A new method combining FT-ICR/MS analysis and Kendrick plots for the characterization of silicon species at trace levels in light petroleum products is presented. The method provides efficient instrumental detection limits ranging from 80 ng/kg to 5 µg/kg and reliable mass accuracy lower than 0.50 ppm for model silicon molecules in spiked gasoline. More than 3000 peaks could be detected in the m/z 50-500 range depending on the nature of the gasoline sample analyzed. An in-house software program was used to calculate Kendrick plots. Then, an algorithm searched, selected, and represented silicon species classes (O(2)Si, O(3)Si, and O(4)Si classes) in Kendrick plots by incorporating model molecules' information (i.e., exact mass and intensity). This procedure allowed the complete characterization of more than 50 new silicon species with different degrees of unsaturation in petroleum products.

Silicon speciation by gas chromatography coupled to mass spectrometry in gasolines.

A method for the speciation of silicon compounds in petroleum products was developed using gas chromatography coupled to mass spectrometry (GC-MS). Prior to analysis, several precautions about storage and conservation were applied for all samples. In spiked gasoline samples, limits of detection between 24 and 69 µg kg(-1) for cyclic siloxanes (D(4)-D(6)) and between 1 and 7 µg kg(-1) for other species were obtained. In this study, cyclic siloxanes (D(n)) and one ethoxysilane were quantified for the first time in petroleum products by a specific method based on response factor calculation to an internal standard. This method was applied to four samples of naphthas and gasolines obtained from a steam cracking process. Cyclic siloxanes were predominant in four investigated samples with concentrations ranging between 101 and 2204 µg kg(-1). Cyclic siloxane content decreased with an increase in their degree of polymerization. During a steam cracking process, silicon concentrations determined by GC-MS SIM (single ion monitoring) significantly increase. This trend was confirmed by ICP-OES (inductively coupled plasma optical emission spectroscopy) measurements but a difference on the total silicon content was observed, certainly highlighting the presence of unknown silicon species. GC-MS SIM method gives access to the chemical nature of the silicon species, which is crucial for the understanding of hydrotreatment catalyst poisoning in the oil and gas industry.