Piezoresistive Graphene/P(VDF-TrFE) Heterostructure Based Highly Sensitive and Flexible Pressure Sensor.

We report on a novel graphene/P(VDF-TrFE) heterostructure based highly sensitive, flexible, and biocompatible pressure/strain sensor developed through a facile and low-cost fabrication technique. The high piezoelectric coefficient of P(VDF-TrFE) coupled with outstanding electrical properties of graphene makes the sensor device highly sensitive, with an average sensitivity of 0.76 kPa-1, a gauge factor of 445, and signal-to-noise ratio of 60.8 dB in the range of pressure up to 45 mmHg. A model was proposed to explain the sensor operation, based on carrier density and mobility changes induced by the piezoelectric charge generated in response to strain, which was supported by Hall measurements and Raman spectroscopy. Potential applications in wearable sensing for human activity monitoring were also demonstrated.

Electrochemical properties of yttrium on W and Pb electrodes in LiCl-KCl eutectic melts.

Cyclic voltammetry, square wave voltammetry, linear polarization, chronopotentiometry and chronoamperometry were performed to investigate the electrochemical properties of Y(iii) on W and Pb electrodes in LiCl-KCl eutectic melts. The diffusion coefficient of Y(iii) measured by various techniques was in the order of 10-5. The nucleation of Y on W electrode was found to comply with the instantaneous nucleation mechanism. With increasing temperature, the exchange current densities increased and the charge-transfer resistances decreased, and exchange current densities are distinctly larger on liquid Pb electrode compared with W electrode. In addition, the co-deposition mechanism of Y(iii) and Pb(ii) on W electrode was also studied and four Pb-Y intermetallics could be detected. The feasibility of extraction metallic Y from the melts was explored by co-deposition on W electrode and under-potential deposition on liquid Pb electrode and the extracted products consisted of Pb3Y and Pb phases.

Three-photon imaging using defect-induced photoluminescence in biocompatible ZnO nanoparticles.

BACKGROUND: Although optical spectroscopy promises improved lateral resolution for cancer imaging, its clinical use is seriously impeded by background fluorescence and photon attenuation even in the so-called two-photon absorption (2PA) imaging modality. An efficient strategy to meet the clinical cancer imaging needs, beyond what two-photon absorption (2PA) offers, is to use longer excitation wavelengths through three-photon absorption (3PA). A variety of fluorescent dyes and nanoparticles (NPs) have been used in 3PA imaging. However, their nonlinear 3PA coefficient is often low necessitating high excitation powers, which cause overheating, photodamage, and photo-induced toxicity. Doped wide band gap semiconductors such as Mn:ZnS NPs have previously been used for 3PA but suffer from poor 3PA coefficients. METHODS: Here, we prepared ZnO NPs with intrinsic defects with high 3PA coefficients using a polyol method. We functionalized them with peptides for selective uptake by glioblastoma U87MG cells and used breast cancer MCF-7 cells as control for 3PA studies. Uptake was measured using inductively coupled plasma-mass spectrometry. Biocompatibility studies were performed using reactive oxygen species and cell viability assays. RESULTS: We demonstrate that ZnO NPs, which have a band gap of 3.37 eV with an order of magnitude higher 3PA coefficients, can facilitate the use of longer excitation wavelengths 950-1,100 nm for bioimaging. We used the presence intrinsic defects (such as O interstitials and Zn vacancies) in ZnO NPs to induce electronic states within the band gap that can support strong visible luminescence 550-620 nm without the need for extrinsic doping. The peptide functionalization of ZnO NPs showed selective uptake by U87MG cells unlike MCF-7 cells without the integrin receptors. Furthermore, all ZnO NPs were found to be biocompatible for 3PA imaging. CONCLUSION: We show that defect-induced luminescence 550-620 nm in ZnO NPs (20 nm) due to 3PA at longer excitation (975 nm) can be used for 3PA imaging of U87MG glioblastoma cells with lower background noise.

Saturable Absorption in 2D Ti3 C2 MXene Thin Films for Passive Photonic Diodes.

MXenes comprise a new class of 2D transition metal carbides, nitrides, and carbonitrides that exhibit unique light-matter interactions. Recently, 2D Ti3 CNTx (Tx represents functional groups such as OH and F) was found to exhibit nonlinear saturable absorption (SA) or increased transmittance at higher light fluences, which is useful for mode locking in fiber-based femtosecond lasers. However, the fundamental origin and thickness dependence of SA behavior in MXenes remain to be understood. 2D Ti3 C2 Tx thin films of different thicknesses are fabricated using an interfacial film formation technique to systematically study their nonlinear optical properties. Using the open aperture Z-scan method, it is found that the SA behavior in Ti3 C2 Tx MXene arises from plasmon-induced increase in the ground state absorption at photon energies above the threshold for free carrier oscillations. The saturation fluence and modulation depth of Ti3 C2 Tx MXene is observed to be dependent on the film thickness. Unlike other 2D materials, Ti3 C2 Tx is found to show higher threshold for light-induced damage with up to 50% increase in nonlinear transmittance. Lastly, building on the SA behavior of Ti3 C2 Tx MXenes, a Ti3 C2 Tx MXene-based photonic diode that breaks time-reversal symmetry to achieve nonreciprocal transmission of nanosecond laser pulses is demonstrated.

The kinetics process of a Pb(ii)/Pb(0) couple and selective fabrication of Li-Pb alloys in LiCl-KCl melts.

The electrode reaction of Pb(ii) and co-reduction of Li(i) and Pb(ii) were investigated on a tungsten electrode in LiCl-KCl eutectic melts by a range of electrochemical techniques. From cyclic voltammetry and square wave voltammetry measurements, the reduction of Pb(ii) was found to be a one-step diffusion-controlled reversible process with the exchange of 2 electrons. The diffusion coefficients of Pb(ii) were computed, and they obey the Arrhenius law. Using the linear polarization technique, the kinetic parameters, such as exchange current intensity (j 0), standard rate constant (k 0) and charge transfer resistance (R ct) for the Pb(ii)/Pb(0) couple on a tungsten electrode were studied at different temperatures, and the activation energy is 27.32 kJ mol-1, smaller than the one for diffusion of Pb(ii), which further confirmed that the reduction of Pb(ii) was controlled by diffusion. A depolarisation effect for Li(i) reduction was observed from the results of cyclic voltammetry, square wave voltammetry and chronopotentiometry due to the formation of Li-Pb alloys by co-reduction of Li(i) and Pb(ii). Furthermore, five Li-Pb intermetallic compounds, LiPb, Li8Pb3, Li3Pb, Li10Pb3 and Li17Pb4 characterized by scanning electronic microscopy and X-ray diffraction, were selectively prepared by potentiostatic electrolysis on a tungsten electrode and galvanostatic electrolysis on a liquid Pb electrode, respectively.