RESUMEN
The mushroom industry should implement green extraction technologies; however, there is not enough information on the differences between these techniques expressed as the chemical composition of the resulting extract. In this study, selected types of green extraction techniques (GETs) were used on Chaga (Inonotus obliquus) (Fr.) Pilát from Serbia (IS) and Mongolia (IM) to examine the differences that would enable the composition-based technology choices in the mushroom supplement industry. Subcritical water extraction (SWE), microwave-assisted (MW) extraction, and ultrasonic-assisted extraction (VAE) were used to prepare the extracts. SWE was performed at two different temperatures (120 and 200 °C), while 96% ethanol, 50% ethanol, and water were used for MW and VAE. The yield, the content of total phenols, total proteins, and carbohydrates, qualitative and quantitative analysis of phenolic compounds, carbohydrates, including α- and ß- and total glucans, and fatty acids, were determined in the obtained extracts. SWE resulted in a significantly higher yield, total polysaccharide, and glucan content than any other technique. Glucose was the most dominant monosaccharide in the SWE samples, especially those extracted at 200 °C. The MW 50% EtOH extracts showed the highest yield of total phenols. Among the tested phenolic compounds, chlorogenic acid was the most dominant. SWE can be recommended as the most efficient method for extracting commercially important compounds, especially glucans and phenols.
RESUMEN
BACKGROUND: Growing population demands more animal protein products. Pork remains one of the traditional and relatively sustainable types of meats for human consumption. In this paper, life-cycle assessment was performed using data from 12 pig farms. In parallel, a survey on the consumption of pork meat products was conducted analyzing responses from 806 pork meat consumers. The study aims to provide a quantitative calculation of six environmental footprints associated with the consumption of pork meat products in Serbia by analyzing data from pig farms and a pork meat consumption survey. RESULTS: Results revealed that pork meat production is responsible for the emission of 3.50 kg CO2e kg-1 live weight, 16.1 MJe kg-1 , 0.151 mg R11e kg-1 , 31.257 g SO2e kg-1 , 55.030 g PO4e kg-1 and 3.641 kg 1.4 dBe kg-1 . Further calculations reveal that weekly emissions of various environmental potentials associated with an average consumer of pork meat products in Serbia are estimated at values of 4.032 kg CO2e week-1 , 18.504 MJe week-1 , 0.17435 mg R11e week-1 , 35.972 g SO2e week-1 and 63.466 g PO4e week-1 . CONCLUSIONS: Results show that, on the one hand, pork products are responsible for environmental production impacts that mainly occur on farms while, on the other hand, consumption is characterized with high meat inclusion rates. As a leverage strategy it is recommended for producers to concentrate on lowering the production impacts rather than trying to reach consumers for sustainability conciseness. © 2020 Society of Chemical Industry.
