Trifluoroiodomethane as a Precursor to High Global Warming Potential Climate Pollutants: Could the Transformation of Climatically Benign CF3I into Potent Greenhouse Gases Significantly Increase Refrigerant-Related Greenhouse Gas Emissions?

The transition away from the production and consumption of high global warming potential (GWP) hydrofluorocarbons (HFCs) under the 2016 Kigali Amendment to the Montreal Protocol on Substances that Deplete the Ozone Layer (Montreal Protocol) has prompted air conditioning, refrigeration, and heat pump equipment manufacturers to seek alternative refrigerants with lower direct climate impacts. Additional factors affecting alternative refrigerant choice include safety (i.e., flammability and toxicity), environmental, and thermodynamic constraints. At the same time, manufacturers are incentivized to seek refrigerants with higher energy efficiency, which saves on electricity costs and reduces indirect greenhouse gas emissions from electricity generation. The life cycle climate performance (LCCP) metric is commonly used to assess the combined direct and indirect climate impacts of refrigerant-use equipment. Here, we consider an additional impact on climate performance: the degradation of refrigerant in equipment, i.e., the direct climate impacts of high-GWP byproducts that can form as the result of adding trifluoroiodomethane (CF3I) to refrigerant blends to reduce flammability. Such a production of high-GWP gases could change the acceptability of CF3I-containing refrigerants. Further, it highlights the need to understand refrigerant degradation within equipment in calculations of the environmental acceptability of new cooling technology.

Mitigating climate disruption in time: A self-consistent approach for avoiding both near-term and long-term global warming.

The ongoing and projected impacts from human-induced climate change highlight the need for mitigation approaches to limit warming in both the near term (<2050) and the long term (>2050). We clarify the role of non-CO2 greenhouse gases and aerosols in the context of near-term and long-term climate mitigation, as well as the net effect of decarbonization strategies targeting fossil fuel (FF) phaseout by 2050. Relying on Intergovernmental Panel on Climate Change radiative forcing, we show that the net historical (2019 to 1750) radiative forcing effect of CO2 and non-CO2 climate forcers emitted by FF sources plus the CO2 emitted by land-use changes is comparable to the net from non-CO2 climate forcers emitted by non-FF sources. We find that mitigation measures that target only decarbonization are essential for strong long-term cooling but can result in weak near-term warming (due to unmasking the cooling effect of coemitted aerosols) and lead to temperatures exceeding 2 °C before 2050. In contrast, pairing decarbonization with additional mitigation measures targeting short-lived climate pollutants and N2O, slows the rate of warming a decade or two earlier than decarbonization alone and avoids the 2 °C threshold altogether. These non-CO2 targeted measures when combined with decarbonization can provide net cooling by 2030 and reduce the rate of warming from 2030 to 2050 by about 50%, roughly half of which comes from methane, significantly larger than decarbonization alone over this time frame. Our analysis demonstrates the need for a comprehensive CO2 and targeted non-CO2 mitigation approach to address both the near-term and long-term impacts of climate disruption.

Atmospheric methyl tertiary butyl ether (MTBE) at a rural mountain site in California.

Methyl tertiary butyl ether (MTBE) was measured in air samples collected at hourly intervals near Blodgett Forest Research Station on the western slope of the Sierra Nevada, California, in July 1997, October 1998, and June through September 1999. Mixing ratios ranged from below the detection limit (< approximately 0.01 ppbv) to 0.5 ppbv, but were generally less than 0.3 ppbv. At these mixing ratios partitioning of MTBE into surface waters would lead to MTBE concentrations of less than 0.2 microg L(-1). As expected, MTBE mixing ratios were highly correlated with other anthropogenically emitted hydrocarbons. Based on the observed diurnal cycle of MTBE and its ratio to 2-methyl-butane (isopentane), we estimated the average regional daytime oxidant concentration to be (9 to 13) x 10(6) OH radicals per cubic centimeter, consistent with our earlier estimates for this region. Furthermore, MTBE ratios to toluene, another ubiquitous anthropogenic hydrocarbon, were generally consistent with regional transport and dilution, as well as atmospheric oxidation. Exceptions, pertaining to MTBE mixing ratios below or close to the detection limit, were associated with the influence of marine air masses that did not experience anthropogenic hydrocarbon input from California. With all these constraints in place, evidence for an additional atmospheric loss process, such as nonreversible deposition of MTBE, could not be established, and we conclude that any deposition is slow compared with removal from the atmosphere by the OH radical.