Tannic acid adsorption properties of cellulose nanocrystalline/fish swim bladder gelatin composite sponge.

Foods and beverages with excessive tannins acid (TA) content taste astringent and bitter. The overconsumption of TA could result in nutritional and digestive problems. In this study, the cellulose nanocrystals (CNC)/fish swim bladder gelatin (FG) composite sponge was prepared with glutaraldehyde as a crosslinking agent. The TA adsorption performance of the sponge was discussed. The freeze-dried CNC/FG composite sponge had a porous network structure. CNC was combined into the FG matrix as a reinforcing phase. The mechanical strength, thermal stability, and swelling properties of the composite sponge were improved with the addition of an appropriate amount of CNC. Although CNC decreased the porosity of composite sponge, the increase in active adsorption sites resulted in an overall positive effect on its TA adsorption properties. Under the optimal adsorption conditions, the TA removal rate of 1.0 % CNC composites reached 80.4 %. Furthermore, the sponge retained a TA removal rate of 54 % after five cycles of adsorption and desorption using 50 % ethanol. The results demonstrated that CNC/FG composite sponge has application potential in the field of adsorption materials for TA.

3D Printing of Solar Crystallizer with Polylactic Acid/Carbon Composites for Zero Liquid Discharge of High-Salinity Brine.

Zero liquid discharge (ZLD) is a technique for treating high-salinity brine to obtain freshwater and/or salt using a solar interface evaporator. However, salt accumulation on the surface of the evaporator is a big challenge to maintaining stable water evaporation. In this study, a simple and easy-to-manufacture evaporator, also called a crystallizer, was designed and fabricated by 3D printing. The photothermal layer printed with polylactic acid/carbon composites had acceptable light absorption (93%) within the wavelength zone of 250 nm-2500 nm. The micron-sized voids formed during 3D printing provided abundant water transportation channels inside the crystallizer. After surface hydrophilic modification, the crystallizer had an ultra-hydrophilic channel structure and gravity-assisted salt recovery function. The results revealed that the angles between the photothermal layers affected the efficacy of solar evaporation and the yield of solid salt. The crystallizer with the angle of 90° between two photothermal layers could collect more solid salt than the three other designs with angles of 30°, 60°, and 120°, respectively. The crystallizer has high evaporation and salt crystallization efficiency in a high-salinity brine environment, which is expected to have application potentials in the zero liquid discharge of wastewater and valuable salt recovery.