Fe3O4 hollow nanospheres on graphene oxide as an efficient heterogeneous photo-Fenton catalyst for the advanced treatment of biotreated papermaking effluent.

This study focused on the feasibility of using Fe3O4/graphene oxide (FGO) nanocomposites as heterogeneous catalysts for the advanced treatment of real industrial wastewater. FGO nanocomposites with different graphene oxide (GO) ratios were synthesized by coprecipitating iron salts onto GO sheets in basic solution. The characterization of the resulting material structures and functionalities was performed using a range of analytical techniques. A low GO loading afforded a good Fe3O4 nanoparticle dispersibility and resulted in a higher Brunauer-Emmett-Teller surface area and pore volume. The FGO nanocomposites and pure Fe3O4 were used to treat papermaking wastewater in a heterogeneous photo-Fenton process. The results suggested that the nanocomposite designated FGO1 (GO loading of 25 mg) exhibits a higher photocatalytic efficiency than other FGO nanocomposites and pure Fe3O4. A maximum chemical oxygen demand degradation efficiency of 89.6% was achieved in 80 min with 1.5 g L-1 FGO1 at pH 3. The degradation of different pollutants present in wastewater was evaluated with the aid of gas chromatography-mass spectrometry and 3D excitation-emission-matrix analysis. Inductively coupled plasma atomic emission spectroscopy and magnetic measurements confirmed that the FGO1 nanocomposites possess a low iron leachability and a high reusability. Thus, a comprehensive advanced treatment of real industrial wastewater using a magnetic FGO catalyst is demonstrated.

Synthesis of Petal-Like MnO2 Nanosheets on Hollow Fe3O4 Nanospheres for Heterogeneous Photocatalysis of Biotreated Papermaking Effluent.

Owing to the implementation of increasingly stringent water conservation policies and regulations, the pulp and paper mill industry must make increased efforts to meet the limits for pollutant emissions. The primary pretreatment and secondary biochemical treatment methods used currently generally fail to meet the country-specific environmental regulations, and the wastewater must be processed further even after being subjected to secondary biochemical treatments. In this work, we synthesized Fe3O4/MnO2 nanocomposites (FMNs) with a flower-like structure for use in the heterogeneous photocatalytic treatment of biotreated papermaking wastewater. FMNs1.25, which were formed using a KMnO4/Fe3O4 molar ratio of 1.25, could be separated readily using an external magnetic field and exhibited higher photocatalytic activity than those of the other samples as well as MnO2 and Fe3O4. The effects of various experimental parameters on the photocatalytic activity of FMNs1.25, including the initial pH of the wastewater and the catalyst dosage, were determined. The common chemical oxygen demand (CODCr) reduction rate in the case of this sample reached 56.58% within 120 min at a pH of 3, the CODCr of effluent after treatment was 52.10 mg/L. Further, even under neutral conditions, the CODCr of the treated effluent was below the current limit for discharge in China. Moreover, the nanocomposites exhibited good recyclability, and their catalytic activity did not decrease significantly even after five usage cycles. This study should serve as a platform for the fabrication of effective photocatalysts for the advanced treatment of biotreated papermaking effluent and refractory organic wastewater.