Influence of a variation in the position of the arms on the sagittal connection of the gravity line with the spinal structures.

PURPOSE: To evaluate the influence of the position of the arms on the location of the body's gravity line. PREVIOUS DATA: The sagittal balance of the pelvi-spinal unit is organized so that the gravity line is localized in a way that limits the mechanical loads and the muscle efforts. This position of the gravity line was analyzed in vivo, in standing position, the arms dangling, by the barycentremeter, a gamma rays scanner. Then, several teams had the same purpose but using a force platform combined with radiographies. Their results differed significantly among themselves and with the data of the barycentremetry. However, in these studies, the positions of the arms varied noticeably, either slightly bent forwards on a support, or the fingers on the clavicles or on the cheeks. METHODS: We estimated, for each varied posture of the arms, the sagittal coordinates of the masses of the upper limbs and their influence on the anatomical position of the gravity line of the whole body. RESULTS: Using a simple equation and the data of the barycentremeter, we observed that the variations in the location of the gravity line were proportionally connected to the changes of the sagittal position of the mass of the upper limbs induced by the various positions of the arms. CONCLUSIONS: We conclude in a validation of the data of the barycentremeter, as well as of the data obtained by the force platforms as long as the artifact of the position of the arms is taken into account.

Pelvic incidence: a predictive factor for three-dimensional acetabular orientation-a preliminary study.

Acetabular cup orientation (inclination and anteversion) is a fundamental topic in orthopaedics and depends on pelvis tilt (positional parameter) emphasising the notion of a safe range of pelvis tilt. The hypothesis was that pelvic incidence (morphologic parameter) could yield a more accurate and reliable assessment than pelvis tilt. The aim was to find out a predictive equation of acetabular 3D orientation parameters which were determined by pelvic incidence to include in the model. The second aim was to consider the asymmetry between the right and left acetabulae. Twelve pelvic anatomic specimens were measured with an electromagnetic Fastrak system (Polhemus Society) providing 3D position of anatomical landmarks to allow measurement of acetabular and pelvic parameters. Acetabulum and pelvis data were correlated by a Spearman matrix. A robust linear regression analysis provided prediction of acetabulum axes. The orientation of each acetabulum could be predicted by the incidence. The incidence is correlated with the morphology of acetabula. The asymmetry of the acetabular roof was correlated with pelvic incidence. This study allowed analysis of relationships of acetabular orientation and pelvic incidence. Pelvic incidence (morphologic parameter) could determine the safe range of pelvis tilt (positional parameter) for an individual and not a group.

Relationship between sacral pelvic incidence and acetabular orientation.

The importance of the sacral pelvic incidence (SPI) in relation to individual variations of sagittal spinal curvature has become well-recognised. We attempted to determine the relationship between SPI and acetabular orientation. The three-dimensional coordinates of 47 homologous points were observed on 51 adult anatomical pelvises (26 female and 25 male). The reference vertical plane was Lewinnek's anterior pelvic plane. 10 angular parameters and 11 linear parameters were defined and calculated. These were expressed both in absolute value (in millimetres) and in "acetabular unit" (relative to the mean value of the right and left acetabular rays). Mean values of the parameters were calculated for all pelvises and according to gender. There were two dominant parameters: the "sacral slope" and the "V pubic angle". "Acetabular tilting" was primarily dependent on the "sacral slope" and its intermediary on the "SPI", while "acetabular anteversion" dependent on the "V pubic angle" via the "angle of prow". It is recommended that positioning of the acetabular cup in total hip arthroplasty relates to anatomical parameters, and to the global sagittal balance of the pelvi-spinal unit.

Perineal descent predicted by a pelvic bone factor: the pelvic incidence angle.

PURPOSE: By measuring the pelvic incidence angle, we assessed the relationship between pelvic floor disorders and pelvic morphology, which allowed us to document for the first time the hypothesis that pelvic incidence may be a predictive factor of perineal descent. METHODS: In a retrospective study of 197 women, the perineal descent at rest and during straining was assessed by defecography. The pelvic incidence angle (53 degrees +/- 9 degrees , independent of the subject position) was defined as the angle between the line perpendicular to the sacral plate at its midpoint and the line connecting this point to the middle of the femoral heads axis. The pelvic incidence angle was correlated with the incidence of pelvic floor descent. RESULTS: In those with pelvic floor descent at rest compared with those without, pelvic incidence angle was significantly larger (64 degrees vs. 53 degrees , P < 10E-06). As a predictive factor of perineal descent at rest, a great pelvic incidence (>62 degrees ) had a sensitivity (73 percent), specificity (82 percent), positive predictive value (81 percent), and negative predictive value (75 percent). CONCLUSIONS: A large pelvic incidence (>62 degrees ) may be a predictive factor of perineal descent at rest before the apparition of other acquired factors. With pelvic incidence >62 degrees , a large overhang between the insertions increases the strains on the perineum, which is rather horizontal.

Three-dimensional study of pelvic asymmetry on anatomical specimens and its clinical perspectives.

The aim of this study was to assess pelvic asymmetry (i.e. to determine whether the right iliac bone and the right part of the sacrum are mirror images of the left), both quantitatively and qualitatively, using three-dimensional measurements. Pelvic symmetry was described osteologically using a common reference coordinate system for a large sample of pelvises. Landmarks were established on 12 anatomical specimens with an electromagnetic Fastrak system. Seventy-one paired variables were tested with a paired t-test and a non-parametric test (Wilcoxon). A Pearson correlation matrix between the right and left values of the same variable was applied exclusively to values that were significantly asymmetric in order to calculate a dimensionless asymmetry index, ABGi, for each variable. Fifteen variables were significantly asymmetric and correlated with the right vs. left sides for the following anatomical regions: sacrum, iliac blades, iliac width, acetabulum and the superior lunate surface of the acetabulum. ABGi values above a threshold of +/- 4.8% were considered significantly asymmetric in seven variables of the pelvic area. Total asymmetry involving the right and the left pelvis seems to follow a spiral path in the pelvis; in the upper part, the iliac blades rotate clockwise, and in the lower part, the pubic symphysis rotates anticlockwise. Thus, pelvic asymmetry may be evaluated in clinical examinations by measuring iliac crest orientation.

Sagittal plane alignment of the spine and gravity: a radiological and clinical evaluation.

Analysis of the sagittal balance of the spine includes the study of the spinal curves and of the pelvis in the sagittal plane. It therefore requires full-spine lateral radiographs. The sagittal balance of the spine was studied in forty-nine young adults. Strong correlations were observed between parameters related to the pelvis ("pelvic incidence angle", "sacral slope" and "pelvic tilting"), and the sagittal spinal curves ("lordosis" and "kyphosis"). We therefore propose to begin the evaluation of the sagittal plane alignment of the spine in clinical practice with measurement of the pelvic incidence angle. The relationship between the pelvic incidence angle and the sacral slope, as well as between the sacral slope and lordosis, is then assessed, and these are related to each other. The use of a graphic abacus facilitates assessment of the physiological comparison of the measured values and of the relationship between pelvic and spinal parameters, within their range of physiological variability. This analysis of the sagittal alignment of the spine also considers its dynamic aspect and the importance of gravity load and of muscular contraction on the lumbar structures. These data have been published previously and are recalled here. Three basic patterns of disruption of the relations between parameters may be encountered: a sacral slope angle exceeding the value expected considering the measured pelvic incidence angle (owing to fixed flexion contracture of the hips), excessive lordosis with regard to the observed sacral slope angle (with hyperkyphosis at the thoracic level) and stiff hypolordosis with pelvic retroversion. These three conditions are analysed in the light of the repercussions of the gravity load on the lumbar structures. A convenient method is thus available for functional analysis of the sagittal balance of the spine.