Location specific multi-scale characterization and constitutive modeling of pig aorta.

The mechanical and structural behavior of the aorta depend on physiological functions and vary from proximal to distal. Understanding the relation between regionally varying mechanical and multi-scale structural response of aorta can be helpful to assess the disease outcomes. Therefore, this study investigated the variation in mechanical and multi-scale structural properties among the major segments of aorta such as ascending aorta (AA), descending aorta (DA) and abdominal aorta (ABA), and established a relation between mechanical and multi-structural parameters. The obtained results showed significant increase in anisotropy and nonlinearity from proximal to distal aorta. The change in periphery length and radii between load and stress free configuration was also found increasing far from the heart. Opening angle was significantly large for ABA than AA and DA (AA/DA vs ABA; p = 0.001). Mean circumferential residual stretch (ratio of mean periphery length at load and stress free configurations) was found decreasing between AA and DA, and then increasing between DA to ABA and its value was significantly more for ABA (AA vs DA; p = 0.041, AA vs ABA; p = 0.001, DA vs ABA; p = 0.001). The waviness of collagen fibers, collagen fiber content, collagen fibril diameter and total protein content were found significantly increasing from proximal to distal. Pearson correlation test showed a significant linear correlation between variation in mechanical and multi-scale structural parameters over the aortic length. Residual stretch was found positively correlated with collagen fiber content (r = 0.82) whereas opening angel was found positively correlated with total protein content (TPC) (r = 0.76).

The multiscale characterization and constitutive modeling of healthy and type 2 diabetes mellitus Sprague Dawley rat skin.

In type 2 diabetes mellitus (T2DM), elevated glucose level impairs the biochemistry of the skin which may result in alteration of its mechanical and structural properties. The several aspects of structural and mechanical changes in skin due to T2DM remain poorly understood. To fill these research gaps, we developed a non-obese T2DM rat (Sprague Dawley (SD)) model for investigating the effect of T2DM on the in vivo strain stress state, mechanical and structural properties of skin. In vivo strain and mechanical anisotropy of healthy and T2DM skin were measured using the digital imaging correlation (DIC) technique and DIC coupled bulge experiment, respectively. Fluorescence microscopy and histology were used to assess the collagen and elastin fibers microstructure whereas nanoscale structure was captured through atomic force microscopy (AFM). Based on the microstructural observations, skin was modeled as a multilayer membrane where in and out of plane distribution of collagen fibers and planar distribution of elastin fibers were cast in constitutive model. Further, the state of in vivo stresses of healthy and T2DM were measured using model parameters and in vivo strain in the constitutive model. The results showed that T2DM causes significant loss in in vivo stresses (p < 0.01) and increase in anisotropy (p < 0.001) of skin. These changes were found in good correlation with T2DM associated alteration in skin microstructure. Statistical analysis emphasized that increase in blood glucose concentration (HbA1c) was the main cause of impaired biomechanical properties of skin. The presented data in this study can help to understand the skin pathology and to simulate the skin related clinical procedures. STATEMENT OF SIGNIFICANCE: Our study is significant as it presents findings related to the effect of T2DM on the physiologic stress strain, structural and mechanical response of SD rat skin. In this study, we developed a non-obese T2DM SD rat model which mimics the phenotype of Asian type 2 diabetics (non-obese). Several structural and mechanical characterization techniques were explored for multiscale characterization of healthy and T2DM skin. Further, based on microstructural information, we presented the constitutive models that incorporate the real microstructure of skin. The presented results can be helpful to simulate the realistic mechanical response of skin during various clinical trials.

A hyperelastic model to capture the mechanical behaviour and histological aspects of the soft tissues.

It is well established that the soft connective tissues show a nonlinear elastic response that comes from their microstructural arrangement. Tissues' microstructure alters with various physiological conditions and may affect their mechanical responses. Therefore, the accurate prediction of tissue's mechanical response is crucial for clinical diagnosis and treatments. Thus, a physically motivated and mathematically simplified model is required for the accurate prediction of tissues' mechanical and structural responses. This study explored the 'Exp-Ln' hyperelastic model (Khajehsaeid et al., 2013) to capture soft tissues' mechanical and histological behaviour. In this work, uniaxial tensile test data for the belly and back pig skin were extracted from the experiments performed in our laboratory, whereas uniaxial test data for other soft tissues (human skin, tendon, ligament, and aorta) were extracted from the literature. The 'Exp-Ln; and other hyperelastic models (e.g. Money Rivlin, Ogden, Yeoh, and Gent models) were fitted with these experimental data, and obtained results were compared between the models. These results show that the 'Exp-Ln' model could capture the mechanical behaviour of soft tissues more accurately than other hyperelastic models. This model was also found numerically stable for all modes and ranges of deformation. This study also investigated the link between 'Exp-Ln' material parameters and tissue's histological parameters. The histological parameters such as collagen content, fibre free length, crosslink density, and collagen arrangement were measured using staining and ATR-FTIR techniques. The material parameters were found statistically correlated with the histological parameters. Further, 'Exp-Ln' model was implemented in ABAQUS through the VUMAT subroutine, where the mechanical behaviour of various soft tissues was simulated for different modes of deformation. The finite element analysis results obtained using the 'Exp-Ln' model agreed with the experiments and were more accurate than other hyperelastic models. Overall, these results demonstrate the capability of 'Exp-Ln' model to predict the mechanical and structural responses of the soft tissues.