The effect of different functional appliances on the sagittal pharyngeal airway dimension in skeletal class II: a retrospective study.

The aim of this study was to compare the changes in the sagittal pharyngeal airway dimension (SPAD) in adolescents with Class II mandibular retrusion treated with Invisalign Mandibular Advancement (IMA), prefabricated Myobrace (MB), and Twin block (TB). For this retrospective study, the pre-treatment and post-treatment lateral cephalograms of 60 patients who underwent myofunctional treatment, using either one of the tested appliances were gathered from the files of treated patients. Changes in the SPAD were measured in each group, and comparisons were carried out between the three study groups. Additionally, sagittal skeletal measurements were carried out. Comparisons of the study variables at T0 and T1 between the three groups were performed using one-way ANOVA, while comparisons of the difference (T1-T0) were performed using Kruskal Wallis test. A significant SPAD increase has been reported using the three tested appliances (p < 0.05), with the least change documented with MB use (p < 0.05). Significant antero-posterior improvements have been found with IMA, MB, and TB with an increase in the SNB°, and a decrease in ANB° and Wits appraisal (p < 0.05). Non-significant FMA° changes have been observed post-treatment in the three test groups (p > 0.05). The IMA, MB, and TB generated significant SPAD and sagittal changes, with both IMA and TB surpassing MB in the airway area improvement post-treatment. Moreover, the three tested Class II functional appliances did not affect the vertical dimension.

Three-dimensional assessment of low-level laser therapy on orthodontic miniscrew displacement using CBCT: a retrospective study.

BACKGROUND: This study aimed to assess the effect of Low-Level Laser Therapy (LLLT) on sagittal, transverse and vertical Orthodontic miniscrew displacement. MATERIALS AND METHODS: The study included CBCTs from the records of 12 adult patients who underwent upper first premolar extraction and canine retraction with orthodontic miniscrews for maximum anchorage. The miniscrews on one side received LLL, while the other side served as a control. The Low-Level Laser was applied to assess its effect on the displacement of the miniscrews. The used CBCTs have been taken at two-time points: immediately after miniscrew insertion (T0) and four months after the start of canine retraction (T1) with a total of 24 CBCTs. Miniscrew displacement was assessed by measuring head (HMS) and tail (TMS) displacement to the axial, coronal and mid-sagittal planes on the CBCT at the two time points. Miniscrews displacement (T1-T0) was compared between LLL side and control side. Comparisons were performed using paired samples t-test. The significance level was set at p-value < 0.05. The reproducibility of measurements was assessed by intraclass correlation coefficient (ICC). RESULTS: After four months of canine retraction, HMS and TMS from both laser and control sides showed significant three-dimensional displacement at p < 0.05. No significant difference in mean displacement in the vertical, sagittal, nor transverse planes between both sides was elicited. CONCLUSION: LLL application in the used protocol does not affect the amount of miniscrew displacement in any of the three planes of space. Miniscrew displacement was significant in both groups.

Tip, torque and rotation of maxillary molars during distalization using Invisalign: a CBCT study.

BACKGROUND: Desirable molar distalization by bodily movement is challenging and can be difficult to achieve. This study investigated changes in molar angulation (mesiodistal tipping), molar inclination (buccolingual torque) and rotation during distalization using clear aligner therapy (CAT). MATERIALS AND METHODS: This retrospective study included 38 cone beam computed tomographic images (CBCTs) taken for patients treated with molar distalization using CAT. The study evaluated pre- (T0) and post-treatment (T1) CBCTs of 19 adult patients (36.68 ± 13.50 years) who underwent maxillary molar distalization using Invisalign® aligners (Align Technology, Inc., San José, CA, USA) with a minimum of 2 mm distalization. Changes in maxillary molar tip, torque and rotation were measured for 61 molars (183 roots). Paired t-test was used to evaluate the differences between pre- and post-treatment readings. The level of significance was set at p ≤ 0.05. The reproducibility of measurements was assessed by the intraclass correlation coefficient (ICC). RESULTS: Molar angulation did not show significant change after distalization (p = 0.158) however, there was significant increase in buccal molar inclination (p = 0.034) and mesiobuccal molar rotation (p < 0.001). CONCLUSION: Molar distalization of 2 mm did not cause significant molar tipping. Maxillary molars showed significant buccal inclination (increased torque) and mesiobuccal rotation after distalization.

A retrospective study evaluating the influence of Class III correction appliances on the sagittal pharyngeal airway dimension.

The aim of this study was to compare the effects of Class III correction appliances including the Facemask (FM), and the new non-compliance fixed functional appliances such as the Reversed Forsus Fatigue Resistant Device (FRD), as well as the CS-2000 (CS), on the sagittal pharyngeal airway dimension (SPAD). Pre-treatment and post-treatment lateral cephalograms of 45 patients who underwent Class III appliance treatment, using either FM, Reversed FRD, or CS were collected from the files of treated patients. SPAD changes were evaluated in each group, and comparisons were conducted between the three study groups. Additionally, sagittal and vertical skeletal measurements were conducted. The FM, the Reversed FRD, and the CS, were found to generate a significant increase in the SPAD, with the Reversed FRD contributing to the most significant change at the OPAA (116.80 ± 26.36 mm2). All three appliances elicited significant antero-posterior changes in the SNA°, SNB°, and ANB°, also with the greatest intermaxillary change documented with the employment of the Reversed FRD (ANB° = 3.33 ± 0.82°). As for the vertical dimension, the FM, the Reversed FRD, and the CS elicited significant FMA° increases, with the greatest change attributed to the FM (FMA° = 2.32 ± 0.97°). Therefore, the three tested Class III corrective appliances generated significant SPAD, antero-posterior, and vertical changes. However, the Revered FRD showed a superior impact in increasing the SPAD at the OPAA level and in eliciting significant intermaxillary changes.

Cephalometric changes in pharyngeal airway dimensions after functional treatment with twin block versus myobrace appliances in developing skeletal class II patients: a randomized clinical trial.

BACKGROUND: Several appliances have been used for correction of developing skeletal Class II, including different myofunctional appliances as Twin block (TB)as well as the new pre-fabricated Myobrace (MB) appliance. However, the effects of these devices on the pharyngeal airways have not been compared in the literature. Thus, the aim of this study was to compare the effects of two Class II correction appliances; TB and MB on the sagittal pharyngeal airway dimension (SPAD), including the nasopharyngeal airway area (NPAA), the oropharyngeal airway area (OPAA), and the laryngopharyngeal airway area (LPAA). METHODS: This is a two parallel arms randomized comparative clinical trial. Twenty-six children of 9-12 years with Skeletal Class II malocclusion due to mandibular deficiency and normal maxillary growth as confirmed by lateral cephalometric X-ray readings (ANB angle > 4° and SNB angle < 78) and Cervical vertebral maturational index (CVMI) 1 or 2 were randomly assigned into two equal groups. Group I: TB, Group II: MB (prefabricated functional appliance, Myofunctional Research Co., Australia). Lateral cephalograms were taken for all patients in both groups before treatment (T1) and after treatment (6 months later) (T2). The primary aim was to assess pre and post treatment changes in the SPAD in each group, and compare between the two study groups. The secondary aim was to evaluate the sagittal skeletal measurements such as the SNA, SNB, ANB, Wits appraisal, as well as vertical skeletal measurements represented by the Frankfurt-mandibular plane angle (FMA) measured pre- and post-treatment. The independent samples t-test was used to compare the two study groups, and the mean difference and 95% confidence intervals (CI) were computed. The paired samples t-test was used to compare various parameters between T1 and T2 within each group. The cutoff for significance was p-value < 0.05. Data were analyzed using IBM SPSS for Windows (Version 26.0). RESULTS: By Comparing changes in airway measurements within each group, it was found that NPAA, OPAA, and LPAA increased significantly after treatment within each group of MB and TB. TB group showed significantly higher mean difference (T2-T1) in both NPAA and OPAA than MB group with 28.39 (± 56.75) and 40.46 (± 52.16) respectively. The increase in LPAA values was not statistically significant at (T2-T1) between both groups. Regarding skeletal changes, there was a significant increase in the SNB values between T1 and T2 within each group with 2.82 (± 3.32) for MB group and 3.79 (± 3.06) for TB group Moreover, there was a significant decrease in the ANB values between T1 and T2 within each group by 2.42 (± 2.70) for MB group and 3.06 (± 1.14) for TB group. Similarly, there was a significant decrease in the ANB values between T1 and T2 within each group by -2.13 (± 0.62) for MB group and - 2.46 (± 0.72) for TB group. No significant differences were found between both groups in SNA, SNB, ANB and Wits appraisal at p = 0.06, p = 0.45, p = 0.43 and p = 0.22 respectively. FMA did not show significant difference between T1 and T2 within each group, nor showed a significant mean difference between both groups at T2-T1. CONCLUSIONS: TB was more effective than MB in improving the upper (NPAA) and middle (OPAA) airways, while no difference was found regarding the lower airway (LPAA). Both TB and MB reduced the severity of developing skeletal class II due to mandibular retrognathism by forward posturing of the mandible. Thus, patients with airway problems would benefit more from TB than MB.

Does maxillary sinus proximity affect molar root resorption during distalization using Invisalign? a CBCT study.

BACKGROUND: This study aimed to assess the correlation between maxillary sinus proximity to root apices of maxillary molars and root resorption during molar distalization using clear aligner therapy (CAT). MATERIALS AND METHODS: Thirty-eight cone beam computed tomography scans (CBCTs) obtained pre- (T0) and post-treatment (T1) from 19 adult patients (36.68 ± 13.50 years), who underwent maxillary molar distalization using Invisalign® aligners (Align Technology, Inc., San José, CA, USA) with a minimum of 2 mm distalization, were evaluated in this study At least 22 h of aligner wear per day was a main inclusion criterion. Sinus proximity and changes in root lengths were measured for 61 molars (183 roots). Spearman coefficient analysis was used for assessing correlation between sinus proximity and root resorption. The level of significance was set at p ≤ 0.05. The reproducibility of measurements was assessed by intraclass correlation coefficient (ICC). RESULTS: Spearman coefficient revealed no significant correlation between sinus proximity and molar root resorption for mesiobuccal, distobuccal or palatal roots (p = 0.558, p = 0.334, p = 0.931, respectively). CONCLUSION: There was no correlation between maxillary sinus proximity to root apices of maxillary molars and root resorption.