RESUMEN
Giant barocaloric effects were recently reported for spin-crossover materials. The volume change in these materials suggests that the transition can be influenced by uniaxial stress, and give rise to giant elastocaloric properties. However, no measurements of the elastocaloric properties in these compounds have been reported so far. Here, we demonstrated the existence of elastocaloric effects associated with the spin-crossover transition. We dissolved particles of ([Fe(L)2](BF4)2, [L=2,6di(pyrazol-1-yl)pyridine]) into a polymeric matrix. We showed that the application of tensile uniaxial stress to a composite film resulted in a significant elastocaloric effect. The elastocaloric effect in this compound required lower applied stress than for other prototype elastocaloric materials. Additionally, this phenomenon occurred for low values of strain, leading to coefficient of performance of the material being one order of magnitude larger than that of other elastocaloric materials. We believe that spin-crossover materials are a good alternative to be implemented in eco-friendly refrigerators based on elastocaloric effects.
RESUMEN
In this study, we report the structural, magnetic, and magnetocaloric properties of B substitution on the Mn site in Ni43Mn46-xBxIn11(x= 0.5, 1.0) Heusler alloys. Crystal structure analysis using room-temperature x-ray diffraction data reveals both samples have mixed phases composed of cubic and tetragonal phases. The structural and magnetic phase transition characteristic temperatures are determined using differential scanning calorimetry, isothermal magnetization (MT), and isofield magnetization (MH) measurements. Both alloys exhibit inverse and direct magnetocaloric effects in the vicinity of their magnetostructural transition and Curie temperature (TC), respectively. For Ni43Mn45.0B1.0In11a maximum magnetic entropy change of 25.06 J kg-1K-1is observed at 250 K for a magnetic field change of 5 T.
RESUMEN
A giant barocaloric effect (BCE) in a molecular material Fe3 (bntrz)6 (tcnset)6 (FBT) is reported, where bntrz = 4-(benzyl)-1,2,4-triazole and tcnset = 1,1,3,3-tetracyano-2-thioethylepropenide. The crystal structure of FBT contains a trinuclear transition metal complex that undergoes an abrupt spin-state switching between the state in which all three FeII centers are in the high-spin (S = 2) electronic configuration and the state in which all of them are in the low-spin (S = 0) configuration. Despite the strongly cooperative nature of the spin transition, it proceeds with a negligible hysteresis and a large volumetric change, suggesting that FBT should be a good candidate for producing a large BCE. Powder X-ray diffraction and calorimetry reveal that the material is highly susceptible to applied pressure, as the transition temperature spans the range from 318 at ambient pressure to 383 K at 2.6 kbar. Despite the large shift in the spin-transition temperature, its nonhysteretic character is maintained under applied pressure. Such behavior leads to a remarkably large and reversible BCE, characterized by an isothermal entropy change of 120 J kg-1 K-1 and an adiabatic temperature change of 35 K, which are among the highest reversible values reported for any caloric material thus far.
RESUMEN
Florid osseous dysplasia (FOD) is an uncommon, benign, cemento-osseous lesion of the jaws. The etiology of FOD is still unknown. It is often asymptomatic and may be identified on routine dental radiographs. The classic radiographic appearance of FOD is amorphous, lobulated, mixed radiolucent/radiopaque masses of cotton-wool appearance with a sclerotic border in the jaws. In our case the lesion was found incidentally on routine periapical radiographs taken for restored teeth and edentulous areas. For further and detailed examination, a panoramic radiograph and cone-beam computed tomograph (CBCT) were taken. The panoramic radiograph and CBCT revealed maxillary bilateral and symmetrical, non-expansile, well-defined, round, radiopaque masses in contact with the root of the maxillary right second molar and left first molar teeth. Our aim in presenting this case report was to highlight the importance of imaging in diagnosis of FOD.