RESUMEN
Epitaxial growth of WTe2 offers significant advantages, including the production of high-quality films, possible long-range in-plane ordering, and precise control over layer thicknesses. However, the mean island size of WTe2 grown by molecular beam epitaxy (MBE) in the literature is only a few tens of nanometers, which is not suitable for the implementation of devices at large lateral scales. Here we report the growth of Td -WTe2 ultrathin films by MBE on monolayer (ML) graphene, reaching a mean flake size of ≃110 nm, which is, on overage, more than three times larger than previous results. WTe2 films thicker than 5 nm have been successfully synthesized and exhibit the expected Td phase atomic structure. We rationalize the epitaxial growth of Td-WTe2 and propose a simple model to estimate the mean flake size as a function of growth parameters that can be applied to other transition metal dichalcogenides (TMDCs). Based on nucleation theory and the Kolmogorov-Johnson-Meh-Avrami (KJMA) equation, our analytical model supports experimental data showing a critical coverage of 0.13 ML above which WTe2 nucleation becomes negligible. The quality of monolayer WTe2 films is demonstrated by electronic band structure analysis using angle-resolved photoemission spectroscopy (ARPES), which is in agreement with first-principles calculations performed on free-standing WTe2 and previous reports. We found electron pockets at the Fermi level, indicating a n-type doping of WTe2 with an electron density of n = 2.0 ± 0.5 × 1012 cm-2 for each electron pocket.
RESUMEN
The growth of bilayers of two-dimensional (2D) materials on conventional 3D semiconductors results in 2D/3D hybrid heterostructures, which can provide additional advantages over more established 3D semiconductors while retaining some specificities of 2D materials. Understanding and exploiting these phenomena hinge on knowing the electronic properties and the hybridization of these structures. Here, we demonstrate that a rhombohedral-stacked bilayer (AB stacking) can be obtained by molecular beam epitaxy growth of tungsten diselenide (WSe2) on a gallium phosphide (GaP) substrate. We confirm the presence of 3R-stacking of the WSe2 bilayer structure using scanning transmission electron microscopy (STEM) and micro-Raman spectroscopy. Also, we report high-resolution angle-resolved photoemission spectroscopy (ARPES) on our rhombohedral-stacked WSe2 bilayer grown on a GaP(111)B substrate. Our ARPES measurements confirm the expected valence band structure of WSe2 with the band maximum located at the Γ point of the Brillouin zone. The epitaxial growth of WSe2/GaP(111)B helps to understand the fundamental properties of these 2D/3D heterostructures, toward their implementation in future devices.
RESUMEN
Rashba interfaces have emerged as promising platforms for spin-charge interconversion through the direct and inverse Edelstein effects. Notably, oxide-based two-dimensional electron gases display a large and gate-tunable conversion efficiency, as determined by transport measurements. However, a direct visualization of the Rashba-split bands in oxide two-dimensional electron gases is lacking, which hampers an advanced understanding of their rich spin-orbit physics. Here, we investigate KTaO3 two-dimensional electron gases and evidence their Rashba-split bands using angle resolved photoemission spectroscopy. Fitting the bands with a tight-binding Hamiltonian, we extract the effective Rashba coefficient and bring insight into the complex multiorbital nature of the band structure. Our calculations reveal unconventional spin and orbital textures, showing compensation effects from quasi-degenerate band pairs which strongly depend on in-plane anisotropy. We compute the band-resolved spin and orbital Edelstein effects, and predict interconversion efficiencies exceeding those of other oxide two-dimensional electron gases. Finally, we suggest design rules for Rashba systems to optimize spin-charge interconversion performance.
RESUMEN
A synergistic effect between strong electron correlation and spin-orbit interaction has been theoretically predicted to realize new topological states of quantum matter on Kondo insulators (KIs), so-called topological Kondo insulators (TKIs). One TKI candidate has been experimentally observed on the KI SmB6(001), and the origin of the surface states (SS) and the topological order of SmB6 has been actively discussed. Here, we show a metallic SS on the clean surface of another TKI candidate YbB12(001) using angle-resolved photoelectron spectroscopy. The SS shows temperature-dependent reconstruction corresponding to the Kondo effect observed for bulk states. Despite the low-temperature insulating bulk, the reconstructed SS with c-f hybridization is metallic, forming a closed Fermi contour surrounding on the surface Brillouin zone and agreeing with the theoretically expected behaviour for SS on TKIs. These results demonstrate the temperature-dependent holistic reconstruction of two-dimensional states localized on KIs surface driven by the Kondo effect.
RESUMEN
Two-dimensional layered transition metal dichalcogenides (TMDCs) show great potential for optoelectronic devices due to their electronic and optical properties. A metal-semiconductor interface, as epitaxial graphene - molybdenum disulfide (MoS2), is of great interest from the standpoint of fundamental science, as it constitutes an outstanding platform to investigate the interlayer interaction in van der Waals heterostructures. Here, we study large area MoS2-graphene-heterostructures formed by direct transfer of chemical-vapor deposited MoS2 layer onto epitaxial graphene/SiC. We show that via a direct transfer, which minimizes interface contamination, we can obtain high quality and homogeneous van der Waals heterostructures. Angle-resolved photoemission spectroscopy (ARPES) measurements combined with Density Functional Theory (DFT) calculations show that the transition from indirect to direct bandgap in monolayer MoS2 is maintained in these heterostructures due to the weak van der Waals interaction with epitaxial graphene. A downshift of the Raman 2D band of the graphene, an up shift of the A1g peak of MoS2 and a significant photoluminescence quenching are observed for both monolayer and bilayer MoS2 as a result of charge transfer from MoS2 to epitaxial graphene under illumination. Our work provides a possible route to modify the thin film TDMCs photoluminescence properties via substrate engineering for future device design.
