RESUMEN
Poly(ethylene oxide) (PEO)-based polymers are common hosts in solid polymer electrolytes (SPEs) for high-power energy devices. Molecular simulations have provided valuable molecular insights into structures and ion transport mechanisms of PEO-based SPEs. The calculation of thermodynamic and kinetic properties rely crucially on the dependability of the molecular force fields describing inter- and intra-molecular interactions with the target system. In this work, we reparametrized atomic partial charges for the widely applied optimized potentials for liquid simulations (OPLS) force field of PEO. The revised OPLS force field, OPLSR, improves the calculations of density, thermal expansion coefficient, and the phase transition of the PEO system. In particular, OPLSR greatly enhances the accuracy of the calculated dielectric constant of PEO, which is critical for simulating polymer electrolytes. The reparameterization method was further applied to SPE system of PEO/LiTFSI with O:Li ratio of 16:1. Based on the reparametrized partial charges, we applied separate charge-scaling factors for PEO and Li salts. The charge-rescaled OPLSR model significantly improves the resulting kinetics of Li+ transport while maintaining the accurate description of coordination structures within PEO-based SPE. The proposed OPLSR force field can benefit the future simulation studies of SPE systems.
RESUMEN
Two types of ion-conducting polyimides with sulfonate or ether functional groups were synthesized as ion-type or coordination-type cathode binders for lithium-ion batteries (LIBs), respectively. Although superior ion transport abilities have been reported for both types of ion-conducting polymers, their electrochemical performances are significantly different and the corresponding transport mechanisms at the electrolyte/electrode interface remain elusive. Here, we combine experimental and computational techniques to investigate the cathode interface in the presence of both functional polymer binders in comparison with the poly(vinylidene fluoride) (PVDF) binder as reference. A broad shoulder in the cyclic voltammogram accompanied by a poor rate performance of battery tests was observed for a LiFePO4 cathode with coordination-type ether-based polyimide (EPI) binder. In contrast, a LiFePO4 cathode with ion-type sulfonated polyimide (SPI) binder exhibits smaller concentration polarization, achieving satisfactory capacity at high current density. Simulations show that the ether-based binder strongly coordinates Li ions and thus slows the diffusion of Li ions. This leads to the reduction of the LIB electrochemical performance at a high C-rate. In contrast, the negative moiety of the SPI binder leads to less localization of Li ions, allowing a slightly higher Li-ion mobility. Conventional PVDF shows no affinity to Li ions, leading to less Li-ion accumulation at the electrode/electrolyte interface. Yet, the cathode surface covered with PVDF shows the lowest Li-ion diffusivity compared to those with the two types of Li-ion-conducting binders. Therefore, cathodes with SPI and PVDF binders show less polarization at the electrode interface and allow higher C-rate performance of LIBs. The combined results provide a comprehensive understanding of the mechanism of ion conduction in ion- and coordination-type Li-ion-conducting polymer binders. This gives valuable insight into the design of next-generation polymer materials for high-power LIBs.
