The conformation of glutenin polymers in wheat grain: some genetic and environmental factors associated with this important characteristic.

In a previous study we used asymmetric-flow field-flow fractionation to determine the polymer mass (Mw), gyration radius (Rw) and the polydispersity index of glutenin polymers (GPs) in wheat (Triticum aestivum). Here, using the same multi-location trials (4 years, 11 locations, and 192 cultivars), we report the factors that are associated with the conformation (Conf) of the polymers, which is the slope of Log(Rw) versus a function of Log(Mw). We found that Conf varied between 0.285 and 0.740, it had low broad-sense heritability (H2=16.8), and it was significantly influenced by the temperature occurring over the last month of grain filling. Higher temperatures were found to increase Rw and the compactness and sphericity of GPs. Alleles for both high- and low-molecular-weight glutenin subunits had a significant influence on the Conf value. Assuming a Gaussian distribution for Mw, the number of polymers present in wheat grains was computed for different kernel weights and protein concentrations, and it was found to exceed 1012 GPs per grain. Using atomic force microscopy and cryo-TEM, images of GPs were obtained for the first time. Under higher average temperature, GPs became larger and more spherical and consequently less prone to rapid hydrolysis. We propose some orientations that could be aimed at potentially reducing the impact of numerous GPs on people suffering from non-celiac gluten sensitivity.

Bread wheat (T. aestivum) variability: Phenotypic and genotypic data from 75 varieties.

Most bread wheat is consumed after processing, which mainly depends on the quantity and quality of protein in the grain. Storage protein content and composition particularly influence the end use quality of milled grain products. Storage proteins are components of the gluten network that confer dough viscoelasticity, an essential property for processing. To explore grain storage protein diversity, 75 bread wheat accessions were grown with two replicates each at two locations. Grains were harvested at maturity and samples were phenotyped for each site and each replicate plant. Grain hardness, thousand-kernel weight and grain nitrogen content were measured. The protein composition of flour from each replicate was characterised by reverse phase-high performance liquid chromatography (RP-HPLC). The molecular distribution of flour polymers was determined by asymmetric flow field-flow fractionation (AF4) and dough technological properties were assessed using a Glutomatic system and a Chopin alveograph. In addition, the 75 accessions were genotyped by the BreedWheat 35k genotyping array (Axiom TaBW35K) containing 34,746 single nucleotide polymorphism markers (SNPs). The dataset produced by this work includes six files with raw data, two files with protocols and figures. Data show the genotypic and phenotypic variabilities of the material used and can be used to explore genetic and environmental effects on traits involved in grain protein quality. This dataset is associated to the research article "Differences in bread protein digestibility traced to wheat cultivar traits" [1].

Genetic and Environmental Factors Associated to Glutenin Polymer Characteristics of Wheat.

The polymers of wheat glutenins are studied here using asymmetric flow field flow fractionation (A4F). Molecular mass (Mw), gyration radius (Rw), and the polydispersity index (PI) of polymers were measured over a four-year, multi-local wheat trial in France. The experiment, involving 11 locations and 192 cultivars, offered the opportunity to approach the genetic and environmental factors associated with the phenotypic values of the polymer characteristics. These characteristics, which were all highly influenced by environmental factors, exhibited low broad-sense heritability coefficients and were not influenced by grain protein content and grain hardness. The 31 alleles encoding the glutenin subunits explained only 17.1, 25.4, and 16.8% of the phenotypic values of Mw, Rw, and PI, respectively. The climatic data revealed that a 3.5 °C increase between locations of the daily average temperature, during the last month of the grain development, caused an increase of more than 189%, 242%, and 434% of the Mw, Rw, and PI, respectively. These findings have to be considered in regard to possible consequences of global warming and health concerns assigned to gluten. It is suggested that the molecular characteristics of glutenins be measured today, especially for research addressing non-celiac gluten sensitivity (NCGS).

SNP markers for early identification of high molecular weight glutenin subunits (HMW-GSs) in bread wheat.

KEY MESSAGE: A set of eight SNP markers was developed to facilitate the early selection of HMW-GS alleles in breeding programmes. In bread wheat (Triticum aestivum), the high molecular weight glutenin subunits (HMW-GSs) are the most important determinants of technological quality. Known to be very diverse, HMW-GSs are encoded by the tightly linked genes Glu-1-1 and Glu-1-2. Alleles that improve the quality of dough have been identified. Up to now, sodium dodecyl sulphate-polyacrylamide gel electrophoresis (SDS-PAGE) of grain proteins is the most widely used for their identification. To facilitate the early selection of HMW-GS alleles in breeding programmes, we developed DNA-based molecular markers. For each accession of a core collection (n = 364 lines) representative of worldwide bread wheat diversity, HMW-GSs were characterized by both genotyping and SDS-PAGE. Based on electrophoresis, we observed at least 8, 22 and 9 different alleles at the Glu-A1, Glu-B1 and Glu-D1 loci, respectively, including new variants. We designed a set of 17 single-nucleotide polymorphism (SNP) markers that were representative of the most frequent SDS-PAGE alleles at each locus. At Glu-A1 and Glu-D1, two and three marker-based haplotypes, respectively, captured the diversity of the SDS-PAGE alleles rather well. Discrepancies were found mainly for the Glu-B1 locus. However, statistical tests revealed that two markers at each Glu-B1 gene and their corresponding haplotypes were more significantly associated with the rheological properties of the dough than were the relevant SDS-PAGE alleles. To conclude, this study demonstrates that the SNP markers developed provide additional information on HMW-GS diversity. Two markers at Glu-A1, four at Glu-B1 and two at Glu-D1 constitute a useful toolbox for breeding wheat to improve end-use value.

Proteogenomic Characterization of Novel x-Type High Molecular Weight Glutenin Subunit 1Ax1.1.

Analysis of Portuguese wheat (Triticum aestivum L.) landrace 'Barbela' revealed the existence of a new x-type high molecular weight-glutenin subunit (HMW-GS) encoded at the Glu-A1 locus, which we named 1Ax1.1. Using one-dimensional and two-dimensional electrophoresis and mass spectrometry, we compared subunit 1Ax1.1 with other subunits encoded at the Glu-A1 locus. Subunit 1Ax1.1 has a theoretical molecular weight of 93,648 Da (or 91,508 Da for the mature protein) and an isoelectric point (pI) of about 5.7, making it the largest and most acidic HMW-GS known to be encoded at Glu-A1. Specific primers were designed to amplify and sequence 2601 bp of the Glu-A1 locus from the 'Barbela 28' wheat genome. A very high level of identity was found between the sequence encoding 1Ax1.1 and those encoding other alleles of the locus. The major difference found was an insertion of 36 amino acids in the central repetitive domain.