Atomic force microscopy in mechanical measurements of single nanowires.

In this paper, we present the results of mechanical measurement of single nanowires (NWs) in a repeatable manner. Substrates with specifically designed mechanical features were used for NW placement and localization for measurements of properties such as Young's modulus or tensile strength of NW with an atomic force microscopy (AFM) system. Dense arrays of zinc oxide (ZnO) nanowires were obtained by one-step anodic oxidation of metallic Zn foil in a sodium bicarbonate electrolyte and thermal post-treatment. ZnO NWs with a hexagonal wurtzite structure were fixed to the substrates using focused electron beam-induced deposition (FEBID) and were annealed at different temperatures in situ. We show a 10-fold change in the properties of annealed materials as well as a difference in the properties of the NW materials from their bulk values with pre-annealed Young modulus at the level of 20 GPa and annealed reaching 200 GPa. We found the newly developed method to be much more versatile, allowing for in situ operations of NWs, including measurements with different methods of scanning probe microscopy.

Four-Point Measurement Setup for Correlative Microscopy of Nanowires.

The measurement method, which utilizes nanomanipulation of the nanowires onto a specially prepared substrate, was presented. It introduced a four-point resistance measurement setup on a chip suited for scanning probe microscopy measurements, integrating connectors and a nanowire specimen. A study on the resistance and resistivity of the thermally post-treated ZnO nanowires at 200 °C and 300 °C in air showed the dependence of these electrical parameters on the annealing temperature. The investigations of the electrical properties of blocks built on the basis of nanowires and their related devices could provide a useful guide not only for designing, fabricating and optimizing electromechanical nanodevices based on nanowires but also for their safe operation in future electronic applications.

Microstructural and optical characterization of TiO2 doped with ytterbium synthesized by sol-gel and Solar physical vapor deposition process.

Pure and ytterbium doped TiO2 nanopowders in anatase phase have been prepared by sol-gel method (SGM) and Solar Physical Vapour Deposition process (SPVD). The physico-chemical parameters of the nanopowders have been described based on the results of micro-structural characterization performed by X-ray diffractometry, scanning electron microscopy, atomic force microscopy, and nitrogen sorption measurements. Thus, final micro-structural properties of SGM and SPVD titania nanopowders have been compared in detail revealing significant changes in the structure and morphology of these two types of materials. Addition of ytterbium had no significant effect on above-mentioned properties, although it modifies significantly the optical properties of the investigated materials. The luminescent properties of developed material were found to be comparable to bulk oxide materials and better than these reported earlier for ytterbium doped titania. In particular it has been shown that the luminescence of SPVD nanopowders is significantly stronger than this of SGM samples.