Lignin Resists High-Intensity Electron Beam Irradiation.

The electron beam irradiation (EBI) of native lignin has received little attention. Thus, its potential use in lignin-based biorefineries is not fully understood. EBI was applied to selected lignin samples and the structural and chemical changes were analyzed, revealing the suitability, limitations, and potential purpose of EBI in wood biorefineries. Isolated milled wood, kraft, and sulfite lignin from beech and eucalyptus were subjected to up to 200 kGy of irradiation. The analysis included gel permeation chromatography for molar masses, heteronuclear single quantum coherence (HSQC)- and 31P NMR and headspace gas chromatography-mass spectrometry for functional groups, and thermogravimetric analysis for thermal stability. Most samples resisted irradiation. Subtle changes occurred in the molecular weight distribution and thermal stability of milled wood lignin. EBI was found to be a suitable pretreatment method for woody biomass if the avoidance of lignin condensation and chemical modification is a high priority.

Partial exchange of ozone by electron beam irradiation shows better viscosity control and less oxidation in cellulose upgrade scenarios.

Electron beam irradiation (EBI) is an alternative treatment for intrinsic viscosity (IV) control in cellulose pulps, but has never been integrated in full bleaching sequences for comparison to conventional methods. Both eucalyptus kraft (EK) paper pulp and beech sulfite (BS) dissolving pulp were subjected to totally chlorine free (TCF) bleaching sequences comprising either EBI, ozone, or both for IV control. Additionally, effects of EBI on hexenuronic acid (HexA) and xylan were investigated. IV was adjusted to 450-500 mL g-1 and properties including carbonyl content, kappa, brightness, alkali-resistance and sugar composition were compared. Pulps produced with EBI had a higher alkali-resistance, uniformity and less cellulose oxidation. However, the degree of bleaching (DoB) was low without the use of ozone. HexA content in a birch pulp was halved by EBI. Isolated xylans were more resistant to irradiation than cellulose with little decrease of molar masses and moderate oxidation.

Heterologous expression of Phanerochaete chrysosporium cellobiose dehydrogenase in Trichoderma reesei.

BACKGROUND: Cellobiose dehydrogenase from Phanerochaete chrysosporium (PcCDH) is a key enzyme in lignocellulose depolymerization, biosensors and biofuel cells. For these applications, it should retain important molecular and catalytic properties when recombinantly expressed. While homologous expression is time-consuming and the prokaryote Escherichia coli is not suitable for expression of the two-domain flavocytochrome, the yeast Pichia pastoris is hyperglycosylating the enzyme. Fungal expression hosts like Aspergillus niger and Trichoderma reesei were successfully used to express CDH from the ascomycete Corynascus thermophilus. This study describes the expression of basidiomycetes PcCDH in T. reesei (PcCDHTr) and the detailed comparison of its molecular, catalytic and electrochemical properties in comparison with PcCDH expressed by P. chrysosporium and P. pastoris (PcCDHPp). RESULTS: PcCDHTr was recombinantly produced with a yield of 600 U L-1 after 4 days, which is fast compared to the secretion of the enzyme by P. chrysosporium. PcCDHTr and PcCDH were purified to homogeneity by two chromatographic steps. Both enzymes were comparatively characterized in terms of molecular and catalytic properties. The pH optima for electron acceptors are identical for PcCDHTr and PcCDH. The determined FAD cofactor occupancy of 70% for PcCDHTr is higher than for other recombinantly produced CDHs and its catalytic constants are in good accordance with those of PcCDH. Mass spectrometry showed high mannose-type N-glycans on PcCDH, but only single N-acetyl-D-glucosamine additions at the six potential N-glycosylation sites of PcCDHTr, which indicates the presence of an endo-N-acetyl-ß-D-glucosaminidase in the supernatant. CONCLUSIONS: Heterologous production of PcCDHTr is faster and the yield higher than secretion by P. chrysosporium. It also does not need a cellulose-based medium that impedes efficient production and purification of CDH by binding to the polysaccharide. The obtained high uniformity of PcCDHTr glycoforms will be very useful to investigate electron transfer characteristics in biosensors and biofuel cells, which are depending on the spatial restrictions inflicted by high-mannose N-glycan trees. The determined catalytic and electrochemical properties of PcCDHTr are very similar to those of PcCDH and the FAD cofactor occupancy is good, which advocates T. reesei as expression host for engineered PcCDH for biosensors and biofuel cells.

Deletion of the small GTPase rac1 in Trichoderma reesei provokes hyperbranching and impacts growth and cellulase production.

BACKGROUND: Trichoderma reesei is widely known for its enormous protein secretion capacity and as an industrially relevant producer of cellulases and hemicellulases. Over the last decades, rational strain engineering was applied to further enhance homologous and heterologous enzyme yields. The introduction of hyperbranching is believed to increase protein secretion, since most exocytosis is located at the hyphal apical tip. There are several genetic modifications which can cause hyperbranching, for example the deletion of the small Rho GTPase rac. Rac plays a crucial role in actin dynamics and is involved in polarisation of the cell during germination and apical extension of the hyphae. RESULTS: We deleted rac1 in a T. reesei strain with an ectopically overexpressed endoglucanase, CEL12A, under Pcdna1 control. This deletion provoked a hyperbranching phenotype and strong apolar growth during germination and in mature hyphae. The strains displayed dichotomous branching and shorter total mycelium length with a larger hyphal diameter. Δrac1 strains exhibited a decreased radial growth on solid media. Biomass formation in liquid cultures was carbon source dependent; similar to the reference strain during growth on lactose, increased on d-glucose and slightly enhanced on cellulose. While extracellular cellulase activities remained at parental strain levels on d-glucose and cellulose, the specific activity on lactose cultures was increased up to three times at 72 h accompanied by an upregulation of transcription of the main cellulases. Although the morphology of the Δrac1 strains was considerably altered, the viscosity of the culture broth in fed-batch cultivations were not significantly different in comparison to the parental strain. CONCLUSIONS: Deletion of the small Rho GTPase rac1 changes the morphology of the hyphae and provokes hyperbranching without affecting viscosity, independent of the carbon source. In contrast, biomass formation and cellulase production are altered in a carbon source dependent manner in the Δrac1 strains.

The Promoter Toolbox for Recombinant Gene Expression in Trichoderma reesei.

The ascomycete Trichoderma reesei is one of the main fungal producers of cellulases and xylanases based on its high production capacity. Its enzymes are applied in food, feed, and textile industry or in lignocellulose hydrolysis in biofuel and biorefinery industry. Over the last years, the demand to expand the molecular toolbox for T. reesei to facilitate genetic engineering and improve the production of heterologous proteins grew. An important instrument to modify the expression of key genes are promoters to initiate and control their transcription. To date, the most commonly used promoter for T. reesei is the strong inducible promoter of the main cellobiohydrolase cel7a. Beside this one, there is a number of alternative inducible promoters derived from other cellulase- and xylanase encoding genes and a few constitutive promoters. With the advances in genomics and transcriptomics the identification of new constitutive and tunable promoters with different expression strength was simplified. In this review, we will discuss new developments in the field of promoters and compare their advantages and disadvantages. Synthetic expression systems constitute a new option to control gene expression and build up complex gene circuits. Therefore, we will address common structural features of promoters and describe options for promoter engineering and synthetic design of promoters. The availability of well-characterized gene expression control tools is essential for the analysis of gene function, detection of bottlenecks in gene networks and yield increase for biotechnology applications.