RESUMEN
Fungi that degrade B20 biodiesel in storage tanks have also been linked to microbiologically influenced corrosion (MIC). A member of the filamentous fungal genus Paecilomyces and a yeast from the genus Wickerhamomyces were isolated from heavily contaminated B20 storage tanks from multiple Air Force bases. Although these taxa were linked to microbiologically influenced corrosion in situ, precise measurement of their corrosion rates and pitting severity on carbon steel was not available. In the experiments described here, we directly link fungal growth on B20 biodiesel to higher corrosion rates and pitting corrosion of carbon steel under controlled conditions. When these fungi were growing solely on B20 biodiesel for carbon and energy, consumption of FAME and n-alkanes was observed. The corrosion rates for both fungi were highest at the interface between the B20 biodiesel and the aqueous medium, where they acidified the medium and produced deeper pits than abiotic controls. Paecilomyces produced the most corrosion of carbon steel and produced the greatest pitting damage. This study characterizes and quantifies the corrosion of carbon steel by fungi that are common in fouled B20 biodiesel through their metabolism of the fuel, providing valuable insight for assessing MIC associated with storing and dispensing B20 biodiesel. IMPORTANCE Biodiesel is widely used across the United States and worldwide, blended with ultra-low-sulfur diesel in various concentrations. In this study, we were able to demonstrate that the filamentous fungus Paecilomyces AF001 and the yeast Wickerhamomyces SE3 were able to degrade fatty acid methyl esters and alkanes in biodiesel, causing increases in acidity. Both fungi also accelerated the corrosion of carbon steel, especially at the interface of the fuel and water, where their biofilms were located. This research provides controlled, quantified measurements and the localization of microbiologically influenced corrosion caused by common fungal contaminants in biodiesel fuels.
Asunto(s)
Biocombustibles , Paecilomyces/metabolismo , Saccharomycetales/metabolismo , Acero , Alcanos , Biocombustibles/microbiología , Carbono , CorrosiónRESUMEN
Renewable fuels hold great promise for the future yet their susceptibility to biodegradation and subsequent corrosion represents a challenge that needs to be directly assessed. Biodiesel is a renewable fuel that is widely used as a substitute or extender for petroleum diesel and is composed of a mixture of fatty acid methyl esters derived from plant or animal fats. Biodiesel can be blended up to 20% v/v with ultra-low sulfur diesel (i.e., B20) and used interchangeably with diesel engines and infrastructure. The addition of biodiesel, however, has been linked to increased susceptibility to biodegradation. Microorganisms proliferating via degradation of biodiesel blends have been linked to microbiologically influenced corrosion in the laboratory, but not measured directly in storage tanks (i.e., in situ). To measure in situ microbial proliferation, fuel degradation and microbially influenced corrosion, we conducted a yearlong study of B20 storage tanks in operation at two locations, identified the microorganisms associated with fuel fouling, and measured in situ corrosion. The bacterial populations were more diverse than the fungal populations, and largely unique to each location. The bacterial populations included members of the Acetobacteraceae, Clostridiaceae, and Proteobacteria. The abundant Eukaryotes at both locations consisted of the same taxa, including a filamentous fungus within the family Trichocomaceae, not yet widely recognized as a contaminant of petroleum fuels, and the Saccharomycetaceae family of yeasts. Increases in the absolute and relative abundances of the Trichocomaceae were correlated with significant, visible fouling and pitting corrosion. This study identified the relationship between fouling of B20 with increased rates of corrosion and the microorganisms responsible, largely at the bottom of the sampled storage tanks. To our knowledge this is the first in situ study of this scale incorporating community and corrosion measurements in an active biodiesel storage environment.
RESUMEN
Hot spring environments can create physical and chemical gradients favorable for unique microbial life. They can also include authigenic mineral precipitates that may preserve signs of biological activity on Earth and possibly other planets. The abiogenic or biogenic origins of such precipitates can be difficult to discern, therefore a better understanding of mineral formation processes is critical for the accurate interpretation of biosignatures from hot springs. Little Hot Creek (LHC) is a hot spring complex located in the Long Valley Caldera, California, that contains mineral precipitates composed of a carbonate base (largely submerged) topped by amorphous silica (largely emergent). The precipitates occur in close association with microbial mats and biofilms. Geological, geochemical, and microbiological data are consistent with mineral formation via degassing and evaporation rather than direct microbial involvement. However, the microfabric of the silica portion is stromatolitic in nature (i.e., wavy and finely laminated), suggesting that abiogenic mineralization has the potential to preserve textural biosignatures. Although geochemical and petrographic evidence suggests the calcite base was precipitated via abiogenic processes, endolithic microbial communities modified the structure of the calcite crystals, producing a textural biosignature. Our results reveal that even when mineral precipitation is largely abiogenic, the potential to preserve biosignatures in hot spring settings is high. The features found in the LHC structures may provide insight into the biogenicity of ancient Earth and extraterrestrial rocks.
RESUMEN
Byssochlamys sp. strain AF001 is a filamentous fungus isolated from fouled B20 biodiesel. Its growth on B20 biodiesel results in the degradation and fouling of the fuel and higher rates of corrosion in affected storage tanks. The genome of Byssochlamys sp. AF001 is 35.9 Mbp and is composed of 10 scaffolds, with a G+C content of 45.89%.
RESUMEN
Beef cattle from a herd in north Alabama were examined because of an outbreak of nonfatal skin disease characterized by discrete circumscribed areas of inflammation that developed on the skin from the neck to the hips. Areas of inflammation, which tended to be superficial, underwent necrosis and scabbed over. The scabs eventually dropped off leaving discrete, round, whitish, hairless lesions that were 1.2 to 2.5 cm diameter. Because clinical signs were consistent with those expected with pseudo-lumpy skin disease (PLSD) caused by bovine herpesvirus type 2 (BHV-2), samples from 16 representative animals were submitted for BHV-2 testing. All 16 animals were seropositive for BHV-2, but the virus could not be isolated from skin biopsy specimens or buffy coat samples. Results of a polymerase chain reaction assay incorporating primers designed to amplify 2 DNA sequences from BHV-2 were positive for 3 of the 10 cattle, suggesting that skin lesions in these cattle were a result of PLSD. Our findings suggest that PLSD may be more common and widespread in the United States than suggested by the frequency with which BHV-2 has been isolated from cattle with PLSD-like skin lesions.