Novel Epoxidized Brazil Nut Oil as a Promising Plasticizing Agent for PLA.

This work evaluates for the first time the potential of an environmentally friendly plasticizer derived from epoxidized Brazil nut oil (EBNO) for biopolymers, such as poly(lactic acid) (PLA). EBNO was used due to its high epoxy content, reaching an oxirane oxygen content of 4.22% after 8 h of epoxidation for a peroxide/oil ratio of 2:1. Melt extrusion was used to plasticize PLA formulations with different EBNO contents in the range of 0-10 phr. The effects of different amounts of EBNO in the PLA matrix were studied by performing mechanical, thermal, thermomechanical, and morphological characterizations. The tensile test demonstrated the feasibility of EBNO as a plasticizer for PLA by increasing the elongation at break by 70.9% for the plasticized PLA with 7.5 phr of EBNO content in comparison to the unplasticized PLA. The field-emission scanning electron microscopy (FESEM) of the fractured surfaces from the impact tests showed an increase in porosity and roughness in the areas with EBNO addition, which was characteristic of ductile failure. In addition, a disintegration test was performed, and no influence on the PLA biodegradation process was observed. The overall results demonstrate the ability of EBNO to compete with other commercial plasticizers in improving the ductile properties of PLA.

Comparative Study of the Properties of Plasticized Polylactic Acid with Maleinized Hemp Seed Oil and a Novel Maleinized Brazil Nut Seed Oil.

In this study, for the first time, Brazil nut seed oil was chemically modified with maleic anhydride to obtain maleinized Brazil nut seed oil (MBNO). The same process was developed to obtain maleinized hemp seed oil (MHO). The use of MBNO and MHO was studied as bio-based plasticizers by incorporating them with different contents ranging from 0 to 10 phr in a polylactic acid (PLA) matrix. By means of mechanical, thermal and thermomechanical characterization techniques, the properties of the different formulations were studied to evaluate the plasticizing effect of the MBNO and MHO. With the addition of both plasticizers, a significant increase in ductile properties was observed, reaching an increase in elongation at break of 643% with 7.5 phr MBNO and 771% with 10 phr MHO compared to neat PLA. In addition, it has been observed that the mechanical resistant properties do not decrease, since the oils enhance the crystallization of PLA by increasing the free volume between its chains and counteracting the effect. Finally, a disintegration test was carried out under thermophilic conditions at 58 °C for 27 days, demonstrating that the incorporation of MHO and MBNO does not significantly affect the biodegradability of neat PLA.